Clutch Bell
#2
Senior Member
Join Date: Dec 2006
Location: Euless,
TX
Posts: 3,096
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch Bell
The bearings go on the one on the inside and one on the outside. center holes. Put one bearing on the clutch bell pilot chaft adn then slide the clutch bell over it, then put the second bearing inside the only hole big enough for it to fit in.
#3
RE: Clutch Bell
ORIGINAL: danny_one
yea gys i just bought a hpi clutch bell with the bearing but i dont know here they go? [X(]can enybody tell me?
yea gys i just bought a hpi clutch bell with the bearing but i dont know here they go? [X(]can enybody tell me?
i am not too sure what clutch bell your talking about but this is the way it goes on the 1/10 cars:
#4
Member
Thread Starter
Join Date: Aug 2007
Location: Los angeles,
CA
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch Bell
this is the one one that im talking about guys.[link]http://www.clermontmotorsports.com/servlet/the-776/HPI-Racing-Clutch-Bell/Detail[/link]
#6
Junior Member
Join Date: Sep 2007
Location: san diego, CA
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
RE: Clutch Bell
it goes in the same way but i had to add 2 5x10x.5 HPI washers to the outer set because the HPI clutch wiggles a little with the stock set of bearings and washers. Hope that helps.