Why is my dogbone too! short.
#1
Member
Thread Starter
Join Date: Jul 2008
Location: Pontypool, ON, CANADA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Why is my dogbone too! short.
I was running my volcano last nite and did not know till today that My left front dogbone was missing. I searched today and found the dogbone but when i went to put it back in it is too short. My manual says it should be 88mm but is really 77mm. Is there another part that's missing? I've been running it for 10 days since i've got it. So it's not like the first time out it fell out.
#3
Member
Thread Starter
Join Date: Jul 2008
Location: Pontypool, ON, CANADA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
RE: Why is my dogbone too! short.
They seem ok and in tact. When i match it up to the right side it is still too short compared the dogbone that has not fallen out.
#4
Member
Thread Starter
Join Date: Jul 2008
Location: Pontypool, ON, CANADA
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
RE: Why is my dogbone too! short.
OK i figured out what has happened the dogbone i foun was the one from the tranny to the front diff. but i seem to be missing the drive cup off the diff. Can i just buy that ?
#5
Senior Member
Join Date: Dec 2007
Location: Starkville,
MS
Posts: 472
Likes: 0
Received 0 Likes
on
0 Posts
RE: Why is my dogbone too! short.
yea just get u couple extras bones b\c they going to fall out i have had my volcano since christmas and only lost one but i also adjusted my spindle closer in so i don't get as much turn but beats losing a dog bone.. and i usally bash my volcano so turning not used that much