tonardo bb trans
#1
Senior Member
Thread Starter
Join Date: Apr 2008
Location: lancaster, PA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
tonardo bb trans
Had to fix my tornado tras wouldn't shift now i swaped out the adjuster now also when i had it apart there were no bearings in the caseing and it caused my gears to wear.Now i had 39,42 the gears that were in it were 42,47 will the 39,42 make a difference
#3
Senior Member
Thread Starter
Join Date: Apr 2008
Location: lancaster, PA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
RE: tonardo bb trans
I'll have to get her running and see what happens but what is the best way to adjust the gap between the gears one the trans and motor
#4
Senior Member
Join Date: Nov 2007
Location: Bridgewater,
NJ
Posts: 3,961
Likes: 0
Received 0 Likes
on
0 Posts
RE: tonardo bb trans
Going to a smaller spur gear will decrease the amount of low end power and give you an increase in the amount of top end (if the engine can provide the necessary rpm's).
#8
Senior Member
Thread Starter
Join Date: Apr 2008
Location: lancaster, PA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
need help guys been a few years now i got back into it my car was running fine now seems to only move if i give it full throttle but then it creaps spin trans with fingers wheels don't move.Trans isn't engaugeing like it should moves freely when pushing it but when running give it throttle doesn't work then you hear like a ching ching when you rev it high thr gears move when you rev it but don't seems to be truning wheels
Last edited by harley75; 07-25-2015 at 11:02 AM. Reason: forgot
#9
Senior Member
Thread Starter
Join Date: Apr 2008
Location: lancaster, PA
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
turns out the one way bearing spun inside the gear lucky i have two for spares.Running the vp powermaster fuel that was all i could get my hands on but this fuel is good stuff.But i don't like it is only 9% oil but i'm running a little rich