RCU Forums

RCU Forums (http://www.rcuniverse.com/forum/)
-   Redcat Racing Support (http://www.rcuniverse.com/forum/redcat-racing-support-427/)
-   -   default needle settings on nitro motor shockwave rc (http://www.rcuniverse.com/forum/redcat-racing-support-427/10877034-default-needle-settings-nitro-motor-shockwave-rc.html)

deon99 12-26-2011 02:45 PM

default needle settings on nitro motor shockwave rc
 
Hi does any one know the high speed and low speeddefault needle settings. on the nitro motor in a shockwave rc

nitrosportsandrunner 12-26-2011 05:15 PM

RE: default needle settings on nitro motor shockwave rc
 
try 4 turns out on the high-speed.
3 out on the low.
2mm opening on the idle gap.
That should be good enough to get it started.
also, pre heat the motor with a hair dryer to make it easier to start if its a new motor.

codokas 12-26-2011 06:11 PM

RE: default needle settings on nitro motor shockwave rc
 
2 1/2 out on high and screw flush with collar on the low

DOUG
Quote:

ORIGINAL: deon99

Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc

nitrosportsandrunner 12-26-2011 06:24 PM

RE: default needle settings on nitro motor shockwave rc
 

Quote:

ORIGINAL: codokas

2 1/2 out on high and screw flush with collar on the low

DOUG
Quote:

ORIGINAL: deon99

Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc

that sounds like the settings once the motor is broken in. out of the box it needs to be very rich for breaking in the motor.

codokas 12-27-2011 06:38 AM

RE: default needle settings on nitro motor shockwave rc
 
Correct you are.For breaking in ya gotta run it rich
DOUG

quote]ORIGINAL: nitrosportsandrunner


Quote:

ORIGINAL: codokas

2 1/2 out on high and screw flush with collar on the low

DOUG
Quote:

ORIGINAL: deon99

Hi does any one know the high speed and low speed default needle settings. on the nitro motor in a shockwave rc

that sounds like the settings once the motor is broken in. out of the box it needs to be very rich for breaking in the motor.
[/quote]


All times are GMT -8. The time now is 10:32 PM.