Volcano EPX motors
Me and My son Burned up our volcano EPX stock brushed motor. Any recomendations on a good replacement. Brushed or brushless. Im all ears.
|
RE: Volcano EPX motors
leopard 60amp brushless ESC with either a 3300kv to 3500kv motor.
The system (motor and esc) run $60 on hobbypartz.com. that system is very close in performance to what the brushless version volcano comes with. If you wanna stay brushed, then a axial 27, HPI saturn 27t or basically and 27t motor will do the job. |
RE: Volcano EPX motors
Thanks Nitro. I will look into those. I will probably go the brushless route.
|
RE: Volcano EPX motors
ORIGINAL: mikejd Thanks Nitro. I will look into those. I will probably go the brushless route. a brushed motor will run you $20. You can get a better brushed motor, that will run you $30-$40 if you also upgrade the ESC. But a better esc is another $30 (used) So a $60-$80 brushless system is a better spend. Just make sure the motor in the system is no lower than 3300kv...or you will have to re-gear the truck. A 3500-3900kv motor would be better. |
RE: Volcano EPX motors
Nitro any other suggestions other than the leopard. Hobbypartz is out of stock on all the leopards.
I found them on ebay but rather not send my money to Hong Kong. |
I just got the same truck for my son and it came with the 550 brushed motor instead of the 540 one but i want it to be as quick as possibe for him but dont want to replace anything gears exc.. what brushed motor can i get that would allow me to do this?
|
All times are GMT -8. The time now is 11:10 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.