3.5/Ultralite line owners, clutch bell fitting help, aftermarket bell
friend was nice enough to CNC a nice set of wheels for me. They're a little smaller than the stock wheels that came on my backdraft so now the stock gearing setup is well spent in no time at all so I need a little more top end now. I know the stock bell is an 18t, uses 5*10*4 bearings and is mod1. Well id really appreciate if anyone could tell me if I could run a 20t savage bell? If so, would I just have to swap the bearings from my redcat bell over to the savage bell, slap it back on and remesh? I do have enough room to run the bigger bell I'm pretty sure. 20t will give me exactly what I need. I think all I would need is just the savage bell and everything should fit. I Can't thank you guys enough! Oh, the bell I want to use is HPI #77110. If you guys know another 20t bell that'll work too, post it for me!
|
All times are GMT -8. The time now is 06:10 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.