Bill Falck's Special "Rivets" large scale
#51
Thread Starter
Join Date: Sep 2003
Location: Chittaway Point NSW, AUSTRALIA
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Looking good. Though I hope you had a typo with your prop size 😬
on that engine I imagine an APC T6 (20x15) would have been more suited. I run a cut down T6 (19x15) on my DA60
on that engine I imagine an APC T6 (20x15) would have been more suited. I run a cut down T6 (19x15) on my DA60
#52
My Feedback: (23)
Join Date: Feb 2002
Location: NORTH HOLLYWOOD,
CA
Posts: 276
Likes: 0
Received 0 Likes
on
0 Posts
hi nitro , I have ran the engine with the apc prop 24x8 . I got 7200 rpm top end.but I am afraid it will fly too slow. I am not intend to race with it yet .... but I want good speed. I have zinger ( good for steer paint ...lol ) 20x14 . I may try.
not sure about an APC T6 20X15. I may order one .I will start with 24 x 10 as the motor spec call for . I want to keep the rpm around 7200 - 7400 .dont forget it is Brison 4.8 , 78cc . it is not a raceing engin .
will keep inform on the outcome and maiden .
not sure about an APC T6 20X15. I may order one .I will start with 24 x 10 as the motor spec call for . I want to keep the rpm around 7200 - 7400 .dont forget it is Brison 4.8 , 78cc . it is not a raceing engin .
will keep inform on the outcome and maiden .