Looking For F4U Corsair For A .60 Engine
#2
Senior Member
Join Date: Aug 2006
Location: Harrisonburg,
VA
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
RE: Looking For F4U Corsair For A .60 Engine
There is one here [link=http://plans.rcmodell.hu/planscal.html]Corsair.dxf[/link]. It's about half way down the page. I have downloaded it and it looks good. However there are no wing ribs shown. I am a good scratch builder but not capable of enough scratching to figure out the airfoil and rib sizes. If there is anyone who has done it could you send it to me? I'd like to take a shot at this one.
Sean
Sean