Australian kit cutter
#2
Senior Member
My Feedback: (1)
RE: Australian kit cutter
Oh, yes.
There was a fellow who joined into a conversation at a forum about 4-5 months ago, (or possibly longer) who was from Downunder. He was setting up a shop to do cutting and wanted some information. Most of the respondants were from N.A., and did not read his address, or were just airheads. I can't remember exact location but he was informative.
I think initially he wanted information on how to construct a laser cutter, but then also wanted something on CNC set ups.
Wm.
There was a fellow who joined into a conversation at a forum about 4-5 months ago, (or possibly longer) who was from Downunder. He was setting up a shop to do cutting and wanted some information. Most of the respondants were from N.A., and did not read his address, or were just airheads. I can't remember exact location but he was informative.
I think initially he wanted information on how to construct a laser cutter, but then also wanted something on CNC set ups.
Wm.
#4
Senior Member
Join Date: Mar 2006
Location: Geraldton, AUSTRALIA
Posts: 1,549
Likes: 0
Received 0 Likes
on
0 Posts
RE: Australian kit cutter
Just in case your still looking dale:
[link=http://www.rcuniverse.com/forum/m_7359951/anchors_7920002/mpage_1/key_/anchor/tm.htm#7920002]Kit cutter for an Australian model[/link]
[link=http://www.rcuniverse.com/forum/m_7359951/anchors_7920002/mpage_1/key_/anchor/tm.htm#7920002]Kit cutter for an Australian model[/link]