Cessna Bobcat
#26
Senior Member
Thread Starter
Join Date: Jun 2009
Location: Douglassville,
PA
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
RE: Cessna Bobcat
It's been a while since I finished the repairs so I thought I'd post some pictures. I painted the cockpit with light grey paint since these photos were taken and did a final sanding, but have put this on hold for now. I might want to make some changes so for now it's hanging in the cave.
#27
Join Date: Jun 2014
Location: Hudson Valley. New York. USA
Posts: 283
Likes: 0
Received 2 Likes
on
2 Posts
Breaker, breaker - anyone on?
I decided today to build a rendition of the Bob Morse RCM Bobcat and came across this thread. Not sure whether to start a new one or see if any of you gents are still around to talk about your building and flying experience. First question - what is your experience with Lazercuts in Tx for the short kit?
Thanks and hope to revive the lively conversation . There is a strong thread on the Don Smith version here on RCU that is 100 inches but that is beyond my workshop ability - way too big.
I am printing up the Bob Morse plans off the outerzone site - any and all comments are welcome.
Best!
Peter
I decided today to build a rendition of the Bob Morse RCM Bobcat and came across this thread. Not sure whether to start a new one or see if any of you gents are still around to talk about your building and flying experience. First question - what is your experience with Lazercuts in Tx for the short kit?
Thanks and hope to revive the lively conversation . There is a strong thread on the Don Smith version here on RCU that is 100 inches but that is beyond my workshop ability - way too big.
I am printing up the Bob Morse plans off the outerzone site - any and all comments are welcome.
Best!
Peter
#28
My Feedback: (22)
Join Date: Jan 2002
Location: East Brunswick, NJ
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
Hi Peter. Welcome to Bobcat territory. There are a few of us around working on the RCM UC78 plans build. Mine is about 40% complete.
Check out this thread http://www.rcuniverse.com/forum/twin...-50-build.html
This was the most active build until recently when it went quite. Check it out.
Check out this thread http://www.rcuniverse.com/forum/twin...-50-build.html
This was the most active build until recently when it went quite. Check it out.