RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: 429CV23
Showing results 1 to 25 of 37
Search took 0.03 seconds.
Forum: Speed - RC Gas Boats
04-30-2018, 07:59 AM
Replies: 11
Views: 1,755
Posted By 429CV23

Easier to choke it by partially covering the horn...

Easier to choke it by partially covering the horn with a finger. If it dies while in the water it should be warm enough to restart without choking it.
Forum: Speed - RC Gas Boats
01-18-2018, 09:14 AM
Replies: 8
Views: 2,712
Posted By 429CV23

Got 2 of the bunks installed. Nice to have it...

Got 2 of the bunks installed. Nice to have it coming together and the boat sitting on it now. Will get 2 more bunks made, as well as the bow stop/winch stand.
2251485
2251486
Forum: Speed - RC Gas Boats
01-11-2018, 01:00 PM
Replies: 8
Views: 2,712
Posted By 429CV23

I received the new wheels/tires which are...

I received the new wheels/tires which are significantly larger than the first set I purchased. The first wheels/tires I got were about 2" diameter, and looked way too small. I sourced some Traxxas...
Forum: RC Rock Crawlers
12-29-2017, 06:41 AM
Replies: 12
Views: 3,354
Posted By 429CV23

It all depends on where you'll be using it, and...

It all depends on where you'll be using it, and what level of performance you want. I have an original Nitro Hawk, and a 1st gen T-Maxx, but just picked up a Redcat Gen7 Pro to pull my 48" gas boat....
Forum: RC Classic Cars & Trucks
12-29-2017, 06:32 AM
Replies: 13
Views: 15,641
Posted By 429CV23

lifeandhowtoliveit...

lifeandhowtoliveit (http://www.rcuniverse.com/forum/members/lifeandhowtoliveit.html) : Nice looking Hawk!

I have an original (white plastic) Nitro Hawk that I purchased new in the early '90s. I...
Forum: RC Classic Cars & Trucks
12-29-2017, 06:13 AM
Replies: 13
Views: 15,641
Posted By 429CV23

Long crank TRX .15 Still available sometimes on...

Long crank TRX .15
Still available sometimes on ebay.
Forum: Speed - RC Gas Boats
12-23-2017, 05:08 PM
Replies: 8
Views: 2,712
Posted By 429CV23

I installed them as they would be on a vehicle. ...

I installed them as they would be on a vehicle. Shackles front/back, frame mounts in the middle. Not really too concerned about their operation. If I had mounted the shackles in the rear on both,...
Forum: Speed - RC Gas Boats
12-17-2017, 03:16 PM
Replies: 8
Views: 2,712
Posted By 429CV23

Got one side of the suspension in today. Will...

Got one side of the suspension in today. Will have to build the axle tubes before I can install the other side.

Simply using plates with holes drilled in them to mount the axles would have been so...
Forum: Speed - RC Gas Boats
12-15-2017, 10:42 AM
Replies: 8
Views: 2,712
Posted By 429CV23

Got the leaf springs set up. The long leaf...

Got the leaf springs set up. The long leaf included in the kit was too long; the tires would have been a few inches apart. Not acceptable. So I used the mid-sized leaf; heated and rolled the end...
Forum: Speed - RC Gas Boats
12-06-2017, 10:13 AM
Replies: 8
Views: 2,712
Posted By 429CV23

Got the leaf spring kit yesterday. Looks like...

Got the leaf spring kit yesterday. Looks like it'll work really well with the 3/8" aluminum C-channel I'm using for the trailer. It'll require some trimming down of the C-channel for the shackle...
Forum: Speed - RC Gas Boats
11-29-2017, 05:53 AM
Replies: 8
Views: 2,712
Posted By 429CV23

Trailer Leaf Springs

I'm starting to build a trailer for the Hypersport to be pulled by either my nitro T-Maxx or an electric 4x4 to be purchased later. Has anyone used the GMade leaf spring kit, GMA30041?
It's a...
Forum: Speed - RC Gas Boats
10-15-2017, 04:34 PM
Replies: 11
Views: 1,755
Posted By 429CV23

Not much help from Arrow Shark tech support. I've...

Not much help from Arrow Shark tech support. I've repeatedly explained I power on the transmitter, cycle channel 3 several times to ensure it is 'Off' before powering on the R-One. I even linked a...
Forum: Speed - RC Gas Boats
10-14-2017, 06:56 AM
Replies: 11
Views: 1,755
Posted By 429CV23

I tested the starter system again yesterday. ...

I tested the starter system again yesterday. Seems to be working fine as long as I cycle channel 3 prior to powering on the R-One starter controller. It still energizes the starter right away after...
Forum: Speed - RC Gas Boats
10-13-2017, 08:50 AM
Replies: 11
Views: 1,755
Posted By 429CV23

I have not replaced the plug. I did a test a...

I have not replaced the plug. I did a test a couple days ago and will again tonight. If I power on the transmitter and cycle the 3rd channel several times before powering the R-One unit it seems to...
Forum: Speed - RC Gas Boats
10-08-2017, 07:15 AM
Replies: 11
Views: 1,755
Posted By 429CV23

So a quality issue has quickly surfaced. Once...

So a quality issue has quickly surfaced. Once the engine is started, there is no rudder or throttle control. I tried multiple changes to wiring routes, removing the flex shaft, etc to see what...
Forum: Speed - RC Gas Boats
10-03-2017, 04:47 PM
Replies: 11
Views: 1,755
Posted By 429CV23

I considered a belt starter, and saw some nice...

I considered a belt starter, and saw some nice units with a LiPo incorporated, but they were pricey too, around $160 if I remember correctly. But the extra convenience of being able to start remotely...
Forum: Speed - RC Gas Boats
10-03-2017, 04:44 PM
Replies: 11
Views: 1,755
Posted By 429CV23

I don't know if I can really comment much on the...

I don't know if I can really comment much on the quality now. It seems like they've made significant changes in the system since it was released last year. The belt drive used to have 2...
Forum: Speed - RC Gas Boats
10-03-2017, 10:16 AM
Replies: 11
Views: 1,755
Posted By 429CV23

Hypersport 48 Upgrades

I got the water pump and Arrow Shark TS760-Marine starter installed. Way too cool. Starter has worked very well for the first few quick start tests. Fires in less than a second. :D The fuel tank...
Forum: Speed - RC Gas Boats
09-28-2017, 05:14 AM
Replies: 11
Views: 3,854
Posted By 429CV23

If there is enough water in the hull to fill the...

If there is enough water in the hull to fill the starter gearbox, it'll be at the bottom of the lake. It may be a gimmick ... until it dies in the middle of the lake and I don't have to throw on a...
Forum: Speed - RC Gas Boats
09-27-2017, 05:38 AM
Replies: 11
Views: 3,854
Posted By 429CV23

I'll post info about the starter, and install...

I'll post info about the starter, and install pics if there is a good 3rd party host; looks like photobucket no longer has working links. I haven't found much info or reviews about the starter. They...
Forum: Speed - RC Gas Boats
09-25-2017, 05:40 PM
Replies: 11
Views: 3,854
Posted By 429CV23

Thanks for the info guys! The R-One unit...

Thanks for the info guys! The R-One unit included with the starter provides ~6v to the receiver from the LiPo pack, eliminating the need for an additional battery. I downloaded the user manual, and...
Forum: Speed - RC Gas Boats
09-25-2017, 05:29 PM
Replies: 11
Views: 3,854
Posted By 429CV23

Why is that? Is the operational current draw from...

Why is that? Is the operational current draw from servos included with a RTR boat intrinsic knowledge?

And ... there are no clubs close to me, and neither of the local Hobbytown stores have...
Forum: Speed - RC Gas Boats
09-24-2017, 06:52 PM
Replies: 11
Views: 3,854
Posted By 429CV23

LiPo Capacity for Receiver/Servos

Is 1300mah sufficient to run the receiver/servos on a gas boat? I'm wondering if I should have gone with larger capacity, maybe 2200+? Trying to balance run time and size/weight.
I'm really tired of...
Forum: Speed - RC Gas Boats
09-21-2017, 05:27 PM
Replies: 11
Views: 1,574
Posted By 429CV23

Thanks for the great info guys! I plan on adding...

Thanks for the great info guys! I plan on adding a clutch over the winter, and if a water pump isn't a truly needed component I won't bother installing it unless I start having over heat issues.
Forum: Speed - RC Gas Boats
09-21-2017, 01:15 PM
Replies: 11
Views: 1,574
Posted By 429CV23

I picked up a water pump, which didn't include...

I picked up a water pump, which didn't include the mounting bracket as advertised. I'm thinking of mounting it directly to the stringer between the engine mount and radio box. Any issue drilling...
Showing results 1 to 25 of 37
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.