RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: jiannliang
Showing results 1 to 25 of 52
Search took 0.59 seconds.
Forum: ARF or RTF
02-15-2008, 04:20 PM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

For those who concerning about the OS 81 FS-A installation, take a look at my setting. Just use the template of OS FS70 in the manual and you will be fine. I change the exhaust header to the curve...
Forum: ARF or RTF
12-27-2007, 04:59 PM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

I totally agree with you flying 310 is like flying a high wing trainer as only the two engines keep spinning. Our field is hard surface and only 3/4 throttle needed to take off and flew the most of...
Forum: ARF or RTF
12-27-2007, 03:00 PM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

My Cessna 310 weight 21 lb and had the same nose wheel from robart, and it handle the weight just right. Several guys from Cessna 310 thread had reported hard landing would definitely caused some...
Forum: ARF or RTF
12-08-2007, 03:43 AM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

This is exactly what I want to see, a clean installation without cutting too much of the cowl. What are the spinner nuts you are using? It look like true turn spinners. And what size of prop with how...
Forum: ARF or RTF
12-06-2007, 05:12 PM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

How's your YS63 fit in the cowl? Can you post more pictures about this YS63 cowl installation since I am going to using the same engines. I am going to use the straight pipe setting and swing MS...
Forum: ARF or RTF
11-19-2007, 07:52 PM
Replies: 3,275
Views: 523,824
Posted By jiannliang

RE: Top Flite B-25 ARF (Tecnical, tips, suggestions)

Since Tower discontinued OS FS-70 Surpass II, does anyone knows if the new OS FS-70 ultimate w/pump will work? This new FS-70 engine seems carry more hp than the surpass II and with smaller...
Forum: Twin & Multi Engine RC Aircraft
09-25-2007, 01:37 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

The short wing tube finally pay the price. If TF make the wing tube longer and prutude all the way under the nacelle this may not happened. The wood spar just can not hold the weight of the fuselage...
Forum: Twin & Multi Engine RC Aircraft
09-24-2007, 05:27 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I believed it's Armorall original protectant for interior. Someone reported glow plug had white built-up after used but I never had this problem. Just one shoot to a galllon tank and the forming...
Forum: Twin & Multi Engine RC Aircraft
07-06-2007, 07:41 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Congratulation on your successful test flight. What's the flying weight of your 310? With everything on my 310 weight 20.9 lb. Although not the heaviest in this thread (some EP conversion put the...
Forum: Twin & Multi Engine RC Aircraft
07-02-2007, 01:24 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

The review of Cessna 310 by minflyer just posted in RCU magazine. Nice fly with those OS 46 engine. I will expect mine with OS 55 should had better speed than that. But I also notice mike's plane...
Forum: Twin & Multi Engine RC Aircraft
06-22-2007, 02:19 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Just found this on youtube. enjoy
http://www.youtube.com/watch?v=7yVREEgdW-g
Forum: Twin & Multi Engine RC Aircraft
06-19-2007, 11:31 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

420cc and really a tight fit. But I had no problem to install the stopper assembly before jammed it in there. I think the tight fit may help to reduce the unwanted vibration when the engine is...
Forum: Twin & Multi Engine RC Aircraft
06-13-2007, 10:57 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Plug your 2nd engine to channel-8 and turn on the throttle-needle function. Then set up the 5 points curve to sync with 1st engine and it's done. All the trim and throttle cut will apply to 2nd...
Forum: Twin & Multi Engine RC Aircraft
06-13-2007, 01:01 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I got it all figure out after playing with the radio for all night. There's two way to set up throttle cut for twin engines. One with "Throttle needle mix" like you suggest, it's a great feature and...
Forum: Twin & Multi Engine RC Aircraft
06-12-2007, 05:29 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

not quite sure how this work? More detail will definitely help. There's a offset value in program mix screen and was set to 50% now but don't know what does that mean.
Forum: Twin & Multi Engine RC Aircraft
06-12-2007, 01:26 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

How to se up throttle cut for both engines by FUTABA 9C radio? My right throttle use ch-3 and left throttle use ch-8 and program mix to link each other. But even with trim/link both turn on it still...
Forum: Twin & Multi Engine RC Aircraft
06-05-2007, 10:59 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

APC 13x6.
I notch the nacelle and finally it clear the pipe. It really a tight fit and no room for any tilt or tip up/dwon.
Forum: Twin & Multi Engine RC Aircraft
06-05-2007, 12:27 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Both needle valve and valve body already removed. It still won't clear the pipe. Did I do something wrong with the engine setup?
Forum: Twin & Multi Engine RC Aircraft
06-04-2007, 10:21 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I already cut off the bottom nacelle to make heat escape. The problem was nacelle can not clear the exhaust pipes when it was attached on the engine. see pics for detail. I think I may need to make...
Forum: Twin & Multi Engine RC Aircraft
06-04-2007, 01:13 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

My 310 with OS55AX + Bisson muffler had trouble to clear the nacelle installation even with exhaust extension cut to 3/8" length as manual described. What I can think of is makeing two notchs on the...
Forum: Twin & Multi Engine RC Aircraft
04-30-2007, 11:54 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Bench test my OS 55AX again today. Set the mixture control screw to factory setting 2 1/2 turns from close and needle valve 1 3/4 turns and it start right up and ran like a champ. Transition from...
Forum: Twin & Multi Engine RC Aircraft
04-30-2007, 12:17 AM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

Need advise on the OS 55AX needle valve setting. I test ran my OS 55AX today with APC 12x6 prop, 20% cool power fuel. First I check the maixture control setting was 2 1/2 turns from factory and just...
Forum: Twin & Multi Engine RC Aircraft
04-16-2007, 03:39 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I replace it with Robart 1" control horn with clevis.
Forum: Twin & Multi Engine RC Aircraft
03-22-2007, 09:16 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I bought it from MTA hobbies.

http://ecsvr.com/mta/shopexd.asp?id=2309
Forum: Twin & Multi Engine RC Aircraft
03-22-2007, 01:27 PM
Replies: 3,914
Views: 689,942
Posted By jiannliang

RE: Top Flite Cessna 310 posted

I used this. Simple and clean installation.
Showing results 1 to 25 of 52
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.