RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: numancia
Showing results 1 to 13 of 13
Search took 0.62 seconds.
Forum: Gas Engines
03-29-2012, 10:27 PM
Replies: 53
Views: 25,115
Posted By numancia

RE: New liquid cooled gas aero engine !

Having wrestled with designing an efficient air cooling system for my Hawker Hurricane with an inline two stroke gas engine in the cowl, I welcome the MVVS innovation. As previous members have said...
Forum: Gas Engines
07-19-2011, 05:22 AM
Replies: 4
Views: 1,209
Posted By numancia

RE: CH Ignition-Hall effect sensors

thanks you guys and a special greeting to BC, hope you continue to get healthy again. Numancia;)
Forum: Gas Engines
07-18-2011, 07:38 PM
Replies: 4
Views: 1,209
Posted By numancia

CH Ignition-Hall effect sensors

I have gone through several of these sensors on my in line twin made by Clark Industries. The problem seems to be heat, or rather too much of it! Have now resorted to encasing the lead outs in...
Forum: RCV Engines Support
12-07-2009, 01:16 AM
Replies: 68
Views: 16,855
Posted By numancia

RE: improved vibration

Having more thoughts on rebalancing the crankshaft I an inclined to think that the counter weight is much heavier than it needs to be. The "factor" used to calculate the mass of the counterweght is...
Forum: RCV Engines Support
12-03-2009, 07:02 PM
Replies: 68
Views: 16,855
Posted By numancia

RE: improved vibration

Yes it is one of the "older ones" but it does have the eccentric mesh adjust for the gears. I am sooo dissapointed because when I first saw the design and the ability to swing scale like props it...
Forum: RCV Engines Support
12-03-2009, 01:47 AM
Replies: 68
Views: 16,855
Posted By numancia

RE: improved vibration

Hi Gasayers, I too have had a bad experience with an RCV120sp. Mine was mounted on an old hack and promptly destroyed the thing!! I had run several tanks of fuel for breakin but nothing like the...
Forum: RC Warbirds and Warplanes
11-18-2007, 07:04 PM
Replies: 5
Views: 1,291
Posted By numancia

Paint masks

A long construction project is my 1/4 scale Hawker Hurricane to be painted as per AE977, the Sea Hurri that was restored by Hawker Restorations Ltd UK to look like Douglas Bader's 242 Squadron...
Forum: JR Radio & Spektrum Radios
04-19-2007, 01:25 AM
Replies: 1
Views: 757
Posted By numancia

PROGRAMING THE DX7 Spektrum

I would like help in the way of a fully detailed step by step walk through of how to set up this radio to operate ailerons and flaps that employ use of two servos for each function. Such as the great...
Forum: General Racing Discussion
07-20-2006, 10:45 PM
Replies: 2
Views: 554
Posted By numancia

race day organisation

We are just about to run our first pylon race, and want to use software to help with the heat set up and results. Does any one have any knowledge of such software the club could purchase?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-24-2006, 12:33 AM
Replies: 54
Views: 4,028
Posted By numancia

RE: receivers that have been in a wreck; opinions

I just wrecked a new Seawind with a R148Df Rx inside whch had flown day prevoiusly OK. Signal went to full glitch condition after T/O and luckily went into water not people! On reflection same Rx was...
Forum: Giant Scale Aircraft - 3D & Aerobatic
02-16-2004, 09:44 PM
Replies: 0
Views: 644
Posted By numancia

Clarke Hawker Hurricane 1/4 scale

Has any one else assembled one of these? I am reaching the latter stages and would appreciate some input on the engine set up and the ignition system.
Forum: Kit Building
11-16-2002, 07:12 AM
Replies: 51
Views: 5,762
Posted By numancia

Kits, the demise of!

I tried to answer a question"where can I get a good scale kit for an AT6 Texan? After searching the web, Tower, Omni etc. I found only one from Midwest. What happened while I was in my shop for the...
Forum: Giant Scale Aircraft - 3D & Aerobatic
05-10-2002, 03:52 AM
Replies: 4
Views: 4,367
Posted By numancia

Clark Industries 1/4 scale Hawker Hurricane

HI, I am slowly putting together the kit. Have no experience with the engine supplied and would appreciate any suggestions from anyone who has. Engine is the Clarke Merlin, it is basically two Quadra...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.