RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: boataddict
Showing results 1 to 25 of 95
Search took 0.59 seconds.
Forum: RC Giant Scale Cars
08-31-2010, 05:09 PM
Replies: 5,821
Views: 788,521
Posted By boataddict

RE: King Motors Baja Review with pictures

Has anyone had a good experience with the HPI SFL-30MG Servo in the KM23? What modifications did you have to make to install this servo?
Forum: RC Giant Scale Cars
04-16-2009, 02:46 AM
Replies: 5,821
Views: 788,521
Posted By boataddict

RE: King Motors Baja Review with pictures

For the tires, I used duct tape. There is a post on hpibajaforum that describes the process. Basically you remove the tire, wheel and foam insert, turn the tire inside out and wrap the tire and the...
Forum: RC Giant Scale Cars
04-08-2009, 11:44 PM
Replies: 5,821
Views: 788,521
Posted By boataddict

RE: King Motors Baja Review with pictures

I have the KSRC-001 23cc. Great value and fun, I don’t think I will go back to owning a nitro car. I want to rebuild the motor at some point in the future.

Does anyone have a list of the...
Forum: RC Giant Scale Cars
06-29-2008, 04:00 PM
Replies: 64
Views: 5,937
Posted By boataddict

RE: CY23cc not starting....

This may not be your issue but recently I had a similar problem, the car ran fine all day. I powered it off, refueled then tried to start and got nothing. What I did notice was that the pull-starter...
Forum: Speed - RC Nitro Boats
04-01-2007, 04:15 PM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

Here is my warranty experience with the Dynamite and Horizon. I had a positive resolution.

http://www.rcuniverse.com/forum/fb.asp?m=2937529
Forum: Speed - RC Nitro Boats
06-04-2006, 08:05 PM
Replies: 2,876
Views: 315,893
Posted By boataddict

RE: Thunder Cat 31

If you took all these precautions and still broke 3 shafts and other boaters arn't breaking any then you may have an alignment problem. Call Horizon and see if you can send the hull back for...
Forum: Speed - RC Nitro Boats
05-26-2006, 12:45 AM
Replies: 2,389
Views: 288,532
Posted By boataddict

RE: THE OFFICIAL SHOCKWAVE 36 THREAD

Has anyone experimented with larger and fully adjustable trim tabs on this boat ?

Similar to this : http://www.bonzisports.com/detail.aspx?ID=92
Forum: Speed - RC Nitro Boats
05-18-2006, 11:59 PM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

I know it has been a while since anyone posted to this but since the summer is here I am curious to find out if anyone has attempted a motor upgrade on the Miss.Bud? The only video I could find was...
Forum: Speed - RC Nitro Boats
04-10-2006, 09:35 PM
Replies: 18
Views: 3,823
Posted By boataddict

RE: Mean Machine 18 RTR

Are you sure it was a Mean Machine that you saw? Aeromarine states that the boat comes installed with a metal prop..
Forum: Speed - RC Nitro Boats
04-07-2006, 09:17 PM
Replies: 18
Views: 3,823
Posted By boataddict

RE: Mean Machine 18 RTR

My wife ordered one last year as surprise Birthday gift for my "Birthday last year" but they never shipped. She told me she got a call today (almost a year later) from Aeromarine asking if she was...
Forum: Speed - RC Nitro Boats
01-28-2006, 11:55 PM
Replies: 7
Views: 876
Posted By boataddict

RE: Miss Budweiser Plug Problems

The diameter of the standard (T) wrench head is too wide to get to the glow plug in the top of the Dynamite motor.

The Dynamite glow plug wrench (DYN2510) will work fine-...
Forum: ARF or RTF
01-26-2006, 09:05 PM
Replies: 7,471
Views: 711,040
Posted By boataddict

RE: New Hanger 9 p-51 mustang **Trainer?!?**

Nice Video G-Pete..
Forum: Speed - RC Nitro Boats
01-20-2006, 12:04 AM
Replies: 13
Views: 921
Posted By boataddict

RE: more power for my bud

Here is the post(with included video) by Dirt Dummy a while back running the HPI .15 SS.

http://www.rcuniverse.com/forum/fb.asp?m=1733633



There was another post awhile back by...
Forum: Speed - RC Nitro Boats
01-19-2006, 01:38 PM
Replies: 9
Views: 6,700
Posted By boataddict

RE: Dynamite .15 engine, good or not?

My Dyno .15 failed after 2 gallons because the piston clip came loose and wedged itself between the piston and the cylinder. HorizonHobby/Dynamite repaired the motor under warranty and I had the...
Forum: Speed - RC Nitro Boats
01-19-2006, 01:14 PM
Replies: 34
Views: 3,294
Posted By boataddict

RE: horizon hobby's new boat

I guess the Mean Machine .18 is dead in the water so to speak... Now that Horizon has announced the release of a catamaran which has a bigger engine, electric starter and cost less than the MM.18 ....
Forum: Speed - RC Nitro Boats
12-08-2005, 01:25 PM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

Both hull types; Flex Shaft and Straight Shaft are still available from Horizonhobby.com. The hulls cost $134.99. They also have the supporting hardware available on their site as well.
Forum: Speed - RC Nitro Boats
12-04-2005, 10:11 PM
Replies: 45
Views: 3,981
Posted By boataddict

RE: Mean Machine 18

It has been 5 month since anyone has heard about the Mean Machine.

Has anyone had any luck contacting Aeromarine RC about the Mean Machine?

Since the Holidays are upon us once again I...
Forum: Speed - RC Nitro Boats
11-08-2005, 01:07 AM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

I personally have not made the change to the steering servo. I find that the steering is adequate but agree it could be a bit more responsive.

Hopefully someone on this forum can make a...
Forum: Speed - RC Nitro Boats
11-04-2005, 11:45 PM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

Talon,

To answer the question on the servo.

here is an article (this also in the first post) that I found a while back where they replaced the servo with a JR Z4750 Ultra race.

...
Forum: Speed - RC Nitro Boats
11-03-2005, 11:31 PM
Replies: 374
Views: 149,212
Posted By boataddict

RE: Proboat Miss Budweiser 1/12 – Awesome!

Talon25,

Most of the info is provided in previous posts but like you said you haven't read it all as yet. I will try to answer your questions but it would be wise if you read the entire post....
Forum: Speed - RC Nitro Boats
10-20-2005, 04:15 PM
Replies: 7
Views: 1,179
Posted By boataddict

RE: Miss Bud - Help - Stripped Countersunk Drive Dog Screw

Nope, be certain to use tools with a good handle.
Forum: Speed - RC Nitro Boats
10-20-2005, 04:09 PM
Replies: 7
Views: 1,179
Posted By boataddict

RE: Miss Bud - Help - Stripped Countersunk Drive Dog Screw

LSU Tiger.

These steps should make it clearer.


1.) Remove Silicone exhaust coupler.
2.) Remove Prop and Prop Drive Dog
3.) Disconnect all fuel and water lines from motor.
4.)...
Forum: Speed - RC Nitro Boats
10-17-2005, 05:40 PM
Replies: 7
Views: 1,179
Posted By boataddict

RE: Miss Bud - Help - Stripped Countersunk Drive Dog Screw

All the information is listed in that link I provided.

http://www.rcuniverse.com/forum/fb.asp?m=2847700
Forum: Speed - RC Nitro Boats
10-17-2005, 02:06 PM
Replies: 7
Views: 1,179
Posted By boataddict

RE: Miss Bud - Help - Stripped Countersunk Drive Dog Screw

Sorry to hear this happened to you. I wrote about this in my Miss.Bud post a few months ago.

http://www.rcuniverse.com/forum/fb.asp?m=2847700

Hope this helps.
Showing results 1 to 25 of 95
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.