RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: 4C8DAN
Showing results 1 to 25 of 51
Search took 0.59 seconds.
Forum: RC Giant Scale Cars
02-04-2013, 09:50 AM
Replies: 0
Views: 1,083
Posted By 4C8DAN

Multiplex Rhino Digi 4 servo problem - reduced travel

Hi, wondered if anyone has experienced this problem and with any luck has the solution.

I have 3 x multiplex digi 4 rhino servos - the distance of travel (throw) on the throttle/brake servo...
Forum: RC Giant Scale Cars
02-03-2013, 11:10 PM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Pulse port checked and clear. I have since stripped out the fuel lines and tank - here may lye the problem. The pickup is not good with the felt tails broken and the joining pipe creased/kinked.
...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
02-01-2013, 08:09 AM
Replies: 3,595
Views: 270,188
Posted By 4C8DAN

RE: OFFICIAL RC18MT/B/T THREAD

In the UK they are on eBay - may be worth a look at US ebay ?
Forum: RC Giant Scale Cars
01-27-2013, 12:12 AM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Hi thanks for to continued help. No I did not remove the coil but I will check the gap - it is not hard to pull (I meant hard to start eg won't start without half throttle)

I even tried another...
Forum: RC Giant Scale Cars
01-26-2013, 10:52 AM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Thanks. No I wasn't aware of needing to set coil gap - how do you set it ? Needles reset but did not help. Losing the will to fix it again which happened last time. I am considering a new engine...
Forum: RC Giant Scale Cars
01-26-2013, 04:58 AM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Ok so fuel cap was breathing fine. Base gasket was wet and I could see it leaking while the engine was running.

Base gasket changed and now it is very hard to start - was starting easier before...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-24-2013, 11:02 PM
Replies: 6
Views: 2,326
Posted By 4C8DAN

RE: RC18T2/B2 team kit - Mamba MMB25-CM2068

Lipo battery sorted I found the best size battery, perfect fit - I think it's the biggest you could get it without modifying the car. Literally just slots between the posts and is not too wide. The...
Forum: RC Giant Scale Cars
01-24-2013, 09:13 AM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Thanks all, appreciated

I will take your advice....
Forum: RC Giant Scale Cars
01-23-2013, 10:52 PM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Thanks - I was thinking (hoping!) it was something simple, all the basic principles are there, starts quite easily, initially runs with good power, then it all goes to nothing.

You're right I...
Forum: RC Giant Scale Cars
01-23-2013, 03:16 PM
Replies: 16
Views: 1,271
Posted By 4C8DAN

RE: Unused MCD Racerunner - please help - engine trouble / running problem

Thanks - for the sake of a few quid I think changing the gaskets is definitely what I should do first - if that doesn't solve it then I'll try something like you suggest. As you say, thing expand...
Forum: RC Giant Scale Cars
01-22-2013, 11:53 PM
Replies: 16
Views: 1,271
Posted By 4C8DAN

Unused MCD Racerunner - please help - engine trouble / running problem

Hi all,

I have an MCD RR (older version I guess) which I bought 5 - 6 years ago.

Initially ran well and used a fair few times then I started experiencing engine problems - I searched the...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-21-2013, 10:21 AM
Replies: 6
Views: 2,326
Posted By 4C8DAN

RE: RC18T2/B2 team kit - Mamba MMB25-CM2068

Not sure if anyone cares ?!

Kit built and motor is correct size and installed without issue (plenty of grunt it seems)... Yet to run properly there is snow everywhere!

Cheap nasty servo...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-13-2013, 02:46 PM
Replies: 6
Views: 2,326
Posted By 4C8DAN

RE: RC18T2/B2 team kit - Mamba MMB25-CM2068

Thanks, I have ordered the team kit so will for sure know within a few days !

Still need lipo help please... I know nothing!
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-13-2013, 11:00 AM
Replies: 6
Views: 2,326
Posted By 4C8DAN

RE: RC18T2/B2 team kit - Mamba MMB25-CM2068

Can anyone out there help?

Can you advise what 2 cell lipo to use? I am not familiar with the ratings, types, types and jargon.....?


Thanks
Dan
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-10-2013, 10:16 PM
Replies: 3,595
Views: 270,188
Posted By 4C8DAN

RE: OFFICIAL RC18MT/B/T THREAD

Hi,


I am planning to buy an RC18-B2 but have almost made the decision to go kit form (RC18-T2/B2). Depending on advice I may sway to the RTR.


~ Can anyone advise whether I can use...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
01-10-2013, 11:32 AM
Replies: 6
Views: 2,326
Posted By 4C8DAN

RC18T2/B2 team kit - Mamba MMB25-CM2068

Hi,


I am planning to buy an RC18-B2 but have almost made the decision to go kit form (RC18-T2/B2). Depending on advice I may sway to the RTR.


~ Can anyone advise whether I can use my...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
08-04-2005, 05:36 AM
Replies: 22
Views: 1,394
Posted By 4C8DAN

RE: Needed: A decent micro car to run around the garage.

You will be recommended loads of great kit but IMO nearly all too quick for indoors.

Kyosho mini Z monster definately fast enough for indoors but still controllable. Great fun, powerslides,...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
08-04-2005, 05:04 AM
Replies: 13
Views: 1,174
Posted By 4C8DAN

RE: servo for rc18t

Will the GPM kit's servo horn fit the 81mg? The spacing is all wrong with the normal servo horn.

cheers.
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
08-04-2005, 04:44 AM
Replies: 16
Views: 8,706
Posted By 4C8DAN

RE: RC18t servo

RC18T Steering problems: Sloppy steering, won't stay straight!!!!

TO "itspuddingtime00," Have you any pictures of the HS81MG mounted. I have this servo and have ordered this alloy linkage...
Forum: 1/16th, 1/18th, Mini & Micro RC Cars
07-29-2005, 07:53 AM
Replies: 602
Views: 50,681
Posted By 4C8DAN

RE: Associated RC18T

http://one18th.com/NewsCat3,8,11,12,13.htm

Alloy chassis!!!
Forum: HPI Monster Truck Forum
02-26-2005, 07:08 PM
Replies: 1
Views: 361
Posted By 4C8DAN

Reverse Module is 21 like 25??

Does anyone know if there is a diffference between the 21 and the 25 reverse modules on the savage's?

I have a savage 25 and a new module for a 21, will it be ok?

cheers.
Forum: HPI Monster Truck Forum
02-25-2005, 05:36 AM
Replies: 2
Views: 434
Posted By 4C8DAN

200 english pounds.... Truckzilla???? or what else????

I would like bigger engine/truck...

I have just been refunded £200 for the truckzilla conversion as they were out of stock. But it was ordered spare of the moment and I am now thinking £200...
Forum: HPI Monster Truck Forum
02-25-2005, 05:29 AM
Replies: 11
Views: 869
Posted By 4C8DAN

RE: all wheel drive steering

I think the mod will be cool but IMO it will be important to allow the rear wheels to move only a fraction in comparison to the front (use a very short servo arm) then i rekon it would be...
Forum: HPI Monster Truck Forum
02-22-2005, 10:37 AM
Replies: 4
Views: 570
Posted By 4C8DAN

RE: Front wheel drive Savage!!!

ed,

I would have done the alloy and nearly did but £20 each just seems too much!

I have 4 spare plastic ones from ebay!

Dan.
Showing results 1 to 25 of 51
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.