RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Mountain_Flyer
Showing results 1 to 25 of 89
Search took 0.58 seconds.
Forum: Electric General Discussion
02-26-2007, 08:25 PM
Replies: 4
Views: 637
Posted By Mountain_Flyer

RE: Receiver / Servo Question ??

Don, I run a Electrifly SS25 with 4 HS-55's in my Mini Pulse XT with no problems. your setup should be A-OK..
Forum: Electric General Discussion
02-22-2007, 07:00 PM
Replies: 6
Views: 741
Posted By Mountain_Flyer

RE: J-3 Cub 25 ARF - Frustrated!!!

Solid Hit,
I ran into the loose fitting wheel collars for the elevator rods as well .. i just used longer set screws to fix mine though .. but the third wire is a very good idea

Hobiecatlob,...
Forum: Electric General Discussion
01-19-2007, 10:32 PM
Replies: 6
Views: 741
Posted By Mountain_Flyer

RE: J-3 Cub 25 ARF - Frustrated!!!

Yup, its a factory fubar and everyone I know thats built one has had the same problem .. you will need to bore out the holes in the X plate pretty simple if you have a drill-press, even a hand...
Forum: Electric Aerobatic & Sport Planes
01-12-2007, 08:38 PM
Replies: 1,963
Views: 319,468
Posted By Mountain_Flyer

RE: E-Flite Mini Pulse XT Owner's Club

Yes the range on the 05S is one mile..... and if you can still see your MPXT at one mile you have WAY better eyes than I do :)
Forum: Electric General Discussion
01-03-2007, 09:12 PM
Replies: 5
Views: 1,042
Posted By Mountain_Flyer

RE: problem with Electrifly SS-12 speed controller

I run quite a few of the Electrifly SS ESC's and I've had the samething happen .. and its usually caused by the BEC being overloaded and resetting which causes the RX to loose power for a fraction of...
Forum: Electric General Discussion
12-31-2006, 07:04 PM
Replies: 6
Views: 745
Posted By Mountain_Flyer

RE: Problem w/ motor cutting off....

ok well is this a Brushed ESC? I'm assuming it is since you say it has a 550 motor.. If so its a good chance the BEC is only rated for 1 amp. and thats no where near enough for the servos your...
Forum: Electric General Discussion
12-30-2006, 10:22 PM
Replies: 6
Views: 745
Posted By Mountain_Flyer

RE: Problem w/ motor cutting off....

What ESC is it? .. the BEC may not beable to handle the load your servos are putting on it. Check to see what the BEC is rated for .. 1amp .. 2 amps .. or more .. if its only 1 amp then there is...
Forum: Park Flyers & Backyard Flyers
12-29-2006, 03:18 PM
Replies: 54
Views: 4,084
Posted By Mountain_Flyer

RE: Show off your hangar

Here's My Hanger ... Ain't she a beaut :D
Forum: Electric General Discussion
12-25-2006, 11:53 AM
Replies: 2
Views: 580
Posted By Mountain_Flyer

RE: EFlite 540 Edge

here is what you need http://www.horizonhobby.com/Products/Default.aspx?ProdID=EFLM1915
Forum: Electric General Discussion
12-20-2006, 01:57 PM
Replies: 4
Views: 618
Posted By Mountain_Flyer

RE: Super Cub - Breaking in Motor?

The purpose for breaking in a Brushed motor is to seat the brushes to the commutator . The best way to do this is to suspend the motor in a glass of water and hook it directly to a single D cell...
Forum: Electric Aerobatic & Sport Planes
12-12-2006, 12:43 PM
Replies: 1,963
Views: 319,468
Posted By Mountain_Flyer

RE: E-Flite Mini Pulse XT Owner's Club

the APC 12x6E won't give you much ground clearance on the MPXT ( about a half an inch ). No real need for that much prop on the MPXT anyway .. its not a 3D plane. I run the APC 10x7E on mine .. but...
Forum: Electric Aerobatic & Sport Planes
10-12-2006, 10:09 PM
Replies: 395
Views: 77,092
Posted By Mountain_Flyer

RE: E-flite J-3 Cub 25 ARF

FlyingGuy,
Which E-Flite ESC were you running? the 40amp or a smaller one?
I run the GP Silver Series 45amp ESC on mine .. ive never had a heat issue and I like you run a single 2100mAh Lipo...
Forum: Brushed/Brushless motors, speed controls, gear drives
10-08-2006, 02:40 AM
Replies: 7
Views: 1,622
Posted By Mountain_Flyer

RE: Inexpensive ESC's?

The GP Silver Series ESC would fit the bill. I use the SS25 in my Mini Funtana with an E-Flite Park480 and the SS45 in my E-Flite J-3 Cub 25 running the E-Flite Power 25. Both work flawlessly and are...
Forum: Electric Training
05-01-2006, 11:33 PM
Replies: 6
Views: 1,096
Posted By Mountain_Flyer

RE: Aerobird extreme electrics pinned down

I use to own an Aerobird Extreme put allot of flight time in on it. I finally sold it to a friend earlier this year. I never did have any problems with its electronics but i'm fully aware that mine...
Forum: RC Gliders, Sailplanes and Slope Soaring
04-26-2006, 10:34 PM
Replies: 19
Views: 8,390
Posted By Mountain_Flyer

RE: Great Planes Spectra Select RTF - Goods and Bads.

I have a Spectra but the ARF version. I use 2S Lipos ( 1900 to 2100 mAh ) and it makes adequate power .. It will normally climb to 500 feet in one to one and a half minutes depending on the...
Forum: Park Flyers & Backyard Flyers
03-25-2006, 10:55 PM
Replies: 33
Views: 7,072
Posted By Mountain_Flyer

RE: E-Flite mini Edge 540

well that bites!! [:@].. they send you a plane to test and review and they don't send you there best motor to put in it!?! :D heh heh all kidding aside actually the Eflite Park 400 4200Kv is quite...
Forum: Park Flyers & Backyard Flyers
03-23-2006, 07:06 PM
Replies: 5
Views: 945
Posted By Mountain_Flyer

RE: gws corsair

vicman,
Totally agree, I use an SK400XT Brushless outrunner in mine .. great power, low cost motor. I spent more on the ESC than the motor :)
I never installed the rudder .. did go with the...
Forum: Park Flyers & Backyard Flyers
03-23-2006, 06:50 PM
Replies: 33
Views: 7,072
Posted By Mountain_Flyer

RE: E-Flite mini Edge 540

Greg,
So... when are you going to test it with an E-Flite Park 480 outrunner? :D
Forum: Electric General Discussion
02-26-2006, 04:22 AM
Replies: 1
Views: 438
Posted By Mountain_Flyer

RE: BECs - Elimination

yes, it is explained in detail in the instructions that came with the ESC
( this is from the instruction sheet that comes with the GreatPlanes ElectriFly Silver Series 25Amp ESC )
"Remove the...
Forum: Electric Training
02-21-2006, 05:44 PM
Replies: 10
Views: 1,019
Posted By Mountain_Flyer

RE: First Radio suggestions

the Optic 6 with the Spectra module supports BOTH positive AND negative shift RX's, hence all hitec and futaba's and all of the JR's and Airtronics that are positive shift. it also supports PCM RX's...
Forum: Electric General Discussion
02-16-2006, 01:19 AM
Replies: 3
Views: 998
Posted By Mountain_Flyer

RE: GWS Warbird Outrunner Mount

this is how:
http://www.horizonhobby.com/Products/Default.aspx?ProdId=EFLM1915
Works great for the SK400XT .. unfortunately there out of stock at the moment ..

as for a good match for the...
Forum: Brushed/Brushless motors, speed controls, gear drives
02-14-2006, 08:34 PM
Replies: 8
Views: 1,774
Posted By Mountain_Flyer

RE: Best Watt/amp Meter for the money?

i own an E-flite Power Meter also .. great little tool tells you the Watts, Amps, Volts, and mAh used, all with one button. can't get any more simple to use than that :) and at $45 its a hard price...
Forum: Park Flyers & Backyard Flyers
02-10-2006, 02:32 PM
Replies: 33
Views: 3,488
Posted By Mountain_Flyer

RE: So....I bought a Slow Stick today

Diggs,
you might also consider the GWS Estarter or the GWS Beaver. Both are nice flying 3 channel planes.
also the Mountain Models Magpie is a good three channel that can be easily changed into...
Forum: Electric General Discussion
01-31-2006, 03:38 PM
Replies: 9
Views: 1,465
Posted By Mountain_Flyer

RE: Advice from a NEWBIE for NEWBIES!!!

Leo L,
You forgot to mention power poles, light poles, flag poles, score boards, billboards, and also large bushes ( there related to trees though :D )
So.. basicly anything sticking more than...
Showing results 1 to 25 of 89
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.