RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Maine_Flyer
Showing results 1 to 25 of 500
Search took 0.83 seconds.
Forum: Glow to Electric Conversions
08-23-2010, 11:10 AM
Replies: 0
Views: 1,312
Posted By Maine_Flyer

Himodel's 100A 12s ESC

does anyone have any experience with this ESC? I'm looking for a reasonably price 12s speed control for a large conversion.. going to be running 10s voltage up to 80 amps.. here's the link ...
Forum: Park Flyers & Backyard Flyers
07-26-2010, 06:30 AM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

maiden went well.. the wind was horrible gusty. no glitches at all. didn't do any EM shielding.. she had quite a roll tendency at near full-throttle (roll to the left) couldn't get to full throttle....
Forum: Park Flyers & Backyard Flyers
07-25-2010, 03:30 PM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

just wrapped up the build on white ghost II.. ar7000 rx this time .. 6s2650 ,mega 25/3, graupner 6.5x6.5, UBEC w/2s 620@5v, 68amps static, just under 1600 watts.. she glitches out this time I'm...
Forum: Park Flyers & Backyard Flyers
07-15-2010, 02:47 PM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

I have a DX7 with seven models on it but haven't switched over the smaller stuff yet.. may get a spectrum 4 channel rx for the next build or at least separate components as much as I can. 2.4ghz is...
Forum: Park Flyers & Backyard Flyers
07-15-2010, 02:35 PM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

use to not be an issue, but the last few years 72mhz has been getting worse.. I have a DX7 for my choppers and large scale stuff but haven't switched over my smaller stuff.. hadn't had many problems...
Forum: Park Flyers & Backyard Flyers
07-15-2010, 07:53 AM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

yes in the past I had an esc in it that was only good up to 4s.. it (RIP) now has a 6s esc.. the 25/2 is in my funjet and runs a 5s 2200 pack and a 6x3 apc sport.. it's pretty badass. at 1350 watts
Forum: Park Flyers & Backyard Flyers
07-15-2010, 07:42 AM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

well the story goes like this....
son of a beotch!.. was going to hit a couple circuits and a couple full throttle bursts, land, check stuff out for heat, then go up again and get some video that I...
Forum: Park Flyers & Backyard Flyers
07-14-2010, 03:40 PM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

Just finished refitting the white ghost with a mega 25/3 and heat sink , 80amp esc , 6s 2650 30-50c (2, 3s packs in series) 6.5x6.5 graupner cam prop, separate BEC, with flight control running off a...
Forum: Park Flyers & Backyard Flyers
05-12-2010, 07:51 AM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

Oh ya, the ole white ghost still lives.. not a scratch on it!

Gryphon.. glad to see your still kickin'!!
Forum: Park Flyers & Backyard Flyers
05-12-2010, 07:39 AM
Replies: 1,955
Views: 230,650
Posted By Maine_Flyer

RE: Official F27 Stryker Part 8: Beginners to Custom Darkness

A Blast from the Past

Holy Crap! I thought I was bad going to the dark side , but apparently I was only dipping my toes with the "Ole white Ghost" I see the mega 16/25/2 is still kicking some...
Forum: NitroModels Support
12-20-2007, 09:57 AM
Replies: 10
Views: 1,226
Posted By Maine_Flyer

RE: Larger Nitro Models planned??

gotta mention the 1/3 or 1/4 scale cub again.. that would be nice
Forum: NitroModels Support
12-10-2007, 10:21 AM
Replies: 5
Views: 1,021
Posted By Maine_Flyer

New edge 540T from CMP

beautiful bird and a nice price as well.. if it flys as well as the 80"330L it should be a winner.. CMP Edge 540T this one should fly well on the same motor I have in my Extra330L-- FTL 45cc gasser...
Forum: Park Flyers & Backyard Flyers
11-10-2007, 05:03 PM
Replies: 2,592
Views: 227,557
Posted By Maine_Flyer

RE: F27 STRYKER -Way Past the Limits Part 6 -Go deeper in to the Dark Side...

Ray and All,
been running the DX7 for a few months now, on nitro helis, glow planes, electric stuff, and now gas models... one thing I learned quick is to use a very good and reliable battery...
Forum: Park Flyers & Backyard Flyers
11-09-2007, 08:00 PM
Replies: 2,592
Views: 227,557
Posted By Maine_Flyer

RE: F27 STRYKER -Way Past the Limits Part 6 -Go deeper in to the Dark Side...

XH20, make sure the right side elevon is in the aileron TX channel (which ever that is on a berg) left side in the elevator channel.. make sure the servos are opposing each other with both servo...
Forum: Park Flyers & Backyard Flyers
11-09-2007, 07:50 PM
Replies: 2,592
Views: 227,557
Posted By Maine_Flyer

RE: F27 STRYKER -Way Past the Limits Part 6 -Go deeper in to the Dark Side...

Hey GG .. Just strolling thru myself and caught your post.. interesting.. I just had to change out an aileron servo in my 27% extra and the set is pretty new.. using DX7 and did bind when I was...
Forum: NitroModels Support
10-20-2007, 06:56 PM
Replies: 16
Views: 2,024
Posted By Maine_Flyer

RE: nitro models extra 330 80"

just a note to those gettng ready to build this one.. be advised to flood some epoxy on the inside of the fuse where the landing gear mounts.. just look in there and you'll see where to flood it.....
Forum: NitroModels Support
10-17-2007, 08:59 PM
Replies: 16
Views: 2,024
Posted By Maine_Flyer

RE: nitro models extra 330 80"

kit quality is excellent as is fit and finish... hardware is very good.. I particularly like the hinges with the control horn fixed to the hinge.. it puts the clevis connection right at the hinge...
Forum: NitroModels Support
10-16-2007, 11:45 PM
Replies: 16
Views: 2,024
Posted By Maine_Flyer

RE: nitro models extra 330 80"

finished mine a few days ago and broke in the engine.. have it ready for maiden tomorrow.. put in the 45cc FTL engine from hobbycity.. comes with a very good ignition box with electronic advance, an...
Forum: NitroModels Support
09-27-2007, 08:30 AM
Replies: 16
Views: 2,024
Posted By Maine_Flyer

RE: nitro models extra 330 80"

I have mine coming next week.. my plan is to get it in the air as cost effective as possible.. it's gonna sport a 45cc gas 2 stroke (china made) looks like the venum engine. digital metal geared...
Forum: Walkera Helis - Dragonfly, etc..
04-03-2007, 08:15 PM
Replies: 13,939
Views: 872,571
Posted By Maine_Flyer

RE: Walkera 22E Lets Talk

thanks again, does the esc get power from the existing motor wires in the 4in1?
Forum: Walkera Helis - Dragonfly, etc..
04-03-2007, 08:11 PM
Replies: 13,939
Views: 872,571
Posted By Maine_Flyer

RE: Walkera 22E Lets Talk

thanks E_Heli, I have the parts coming..
Forum: Walkera Helis - Dragonfly, etc..
04-03-2007, 09:06 AM
Replies: 13,939
Views: 872,571
Posted By Maine_Flyer

RE: Walkera 22E Lets Talk

got my 22e last week after months of sim flying.. got it all setup.. well best i could with the slop in the head and servos.. she hovers pretty stable with little vibration.. I'm running the 3s...
Forum: Park Flyers & Backyard Flyers
04-03-2007, 05:54 AM
Replies: 2,513
Views: 153,899
Posted By Maine_Flyer

RE: F27 STRYKER - Way Past the Limits - Part 5 - Step in to the Dark Side...

critter, I'm running that motor in my scratch-built sailplane at 32oz auw with a 10x5 apc folder w/ 4s 3100 12c... pulls 19 amps WOT and likes it.. I'm guessin that on 3s you could run an APC...
Forum: Park Flyers & Backyard Flyers
03-31-2007, 07:53 AM
Replies: 15
Views: 686
Posted By Maine_Flyer

RE: Hs81's stripped in my stryker...already

M-C, you 'should' swap them all so the set is 'matched'. However, I wouldn't throw out any that still look good--save them for single replacements in a pinch.;)
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.