RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: wal
Showing results 1 to 25 of 107
Search took 0.61 seconds.
Forum: Losi Monster Trucks
06-02-2005, 12:34 AM
Replies: 16
Views: 1,314
Posted By wal

RE: Throttle brake control horn problems. High idle

Hi rm-rf
I had a similar problem, when under throttle; if I simply backed off and went to the neutral position all was good. If I braked then went back to neutral the server savor would tick...
Forum: Losi Monster Trucks
05-12-2005, 08:49 PM
Replies: 12
Views: 766
Posted By wal

RE: lower suspension arm

O NO, What the LST a arms are weak and prone to breaking?
When did this start happening?
Why wasn’t I told?
They can’t do this!
I am gonna sue!
We need to hold a royal commission!
...
Forum: Losi Monster Trucks
05-12-2005, 08:35 PM
Replies: 16
Views: 869
Posted By wal

RE: Beach Truckin

Hi Casper78,

Your truck will love the sand, you will need to clean it after though. Most of the truck is either aluminum or plastic both of which can handle stand ok.

What’s the point of...
Forum: Losi Monster Trucks
05-12-2005, 08:10 PM
Replies: 5
Views: 353
Posted By wal

RE: How do you remove the steering servos?

Trust me, take the whole front end off, it only takes five minutes and if gives you heaps of room to move. Check the size of you new servos, I had to remove the servo blocks and screw them to the...
Forum: Losi Monster Trucks
05-06-2005, 12:02 AM
Replies: 20
Views: 997
Posted By wal

RE: Are you happy with the stock .26? JR Radio?

No problems with roto start, the motor has get up and go to get me into serious trouble. As for the radio, I replaced the standard Jr Xs3 radio with its synthesized version. I did this because I have...
Forum: Losi Monster Trucks
04-01-2005, 01:42 AM
Replies: 21
Views: 920
Posted By wal

RE: I'm a proud owner of

Wow, at that serial number it must have been in stock for a while, welcome to the club.
Forum: Losi Monster Trucks
03-25-2005, 10:04 AM
Replies: 12
Views: 1,096
Posted By wal

RE: Fuel costs -

i am glad i am not running my car on the stuff.
Forum: Losi Monster Trucks
03-24-2005, 11:08 PM
Replies: 6
Views: 556
Posted By wal

RE: need help, how come it wont fit

That tiny little plug gives me the willies, I am going to replace it with the standard JR cable and re wire my batteries, I run tow batteries and I will only take me about five minutes to solder the...
Forum: Losi Monster Trucks
03-24-2005, 07:36 AM
Replies: 21
Views: 1,720
Posted By wal

RE: Everything messed up on LST

You could always buy a new LST, only kidding.

I have trouble tuning mine as well, had to replace the LSN o ring, it was still intact but the needle kept moving. I have also purchased a new glow...
Forum: Losi Monster Trucks
03-24-2005, 07:30 AM
Replies: 9
Views: 1,018
Posted By wal

RE: Throttle Servo

Yep I have killed my throttle servo as well, it just sits there twitching forward and back. I replaced it with a blue bird 9Kg-cm metal gear servo.

I also killed the servo saver, going from...
Forum: Losi Monster Trucks
03-24-2005, 07:24 AM
Replies: 6
Views: 598
Posted By wal

RE: Digital Servos Question

i run blue bird servos on stearing (16Kg - cm by choice) and throtle (9 Kg - cm not by choice) and servo savers went straight on.
Forum: Losi Monster Trucks
03-21-2005, 06:15 AM
Replies: 24
Views: 1,440
Posted By wal

RE: Jumping

So your saying I shouldn't shut my eyes as the truck hits the bottom of the ramp and just wait for the noise of touch down?:D
Forum: Losi Monster Trucks
03-20-2005, 07:40 AM
Replies: 10
Views: 824
Posted By wal

RE: Silver clutch springs updated right?

I just put Hobao shoes and springs in mine and I have run five tanks so fare and all is good. I did two tanks on road and three tanks bashing.
Forum: Losi Monster Trucks
03-20-2005, 07:31 AM
Replies: 37
Views: 2,885
Posted By wal

RE: OK whos got serious cash??????????

WOW, that half the price of the truck, that’s twenty packets of plastic ones. Man; not even I drive that bad.

Even Titanium has a weakness; does anyone know what it is? If you push them two...
Forum: Losi Monster Trucks
03-20-2005, 07:23 AM
Replies: 10
Views: 1,057
Posted By wal

RE: LST Brakes

I put in the LOSB3606 High Performance Brake Pad Set when I had the gearbox out, the have more grip then the standard ones, I can flip the entire truck tail over nose if I brake to hard.
Forum: Losi Monster Trucks
03-20-2005, 07:14 AM
Replies: 5
Views: 696
Posted By wal

RE: Servos

I changed to blue-bird BMS630MG, 13Kg-cm / 181oz-in. They have steel cogs, they look water proof but not really prepared to test ;) and the servo savers slide straight on no worries at all. The only...
Forum: Losi Monster Trucks
03-19-2005, 06:04 AM
Replies: 1
Views: 456
Posted By wal

Clutch shoes by Houdini!

To cut a long story short, I recently cracked my transmission case. Being to scared to pull it apart myself I had my LHS do it for me, during this operation my TiNi gears came in to I told them to...
Forum: Losi Monster Trucks
03-19-2005, 05:48 AM
Replies: 2
Views: 413
Posted By wal

RE: Steel TiNi pinions only?

If you have viable stock spur gears give it a go, the worst that can happen is you strip the spur gears and you have to put the TiNi ones, I have a complete set and have run about three tanks through...
Forum: Losi Monster Trucks
03-19-2005, 05:41 AM
Replies: 6
Views: 621
Posted By wal

RE: help with new lst

If you are going to use water near the servos make sure you dry them as soon as possible, I have a dead throttle server and I think I may be the degreasing I gave the truck with a can of degreaser...
Forum: Losi Monster Trucks
03-18-2005, 05:58 PM
Replies: 14
Views: 1,018
Posted By wal

RE: Steel TiNi Gears

I think Losi need to make these a standard item on the LST
Forum: Losi Monster Trucks
03-18-2005, 05:44 PM
Replies: 14
Views: 1,240
Posted By wal

RE: Replacement bodies for my LST?

Guns don't kill people, postal workers do :D
Nice, custome M16?
Forum: Losi Monster Trucks
03-18-2005, 06:27 AM
Replies: 14
Views: 1,240
Posted By wal

RE: Replacement bodies for my LST?

Nice paint job on the top photo, and a pretty pennies worth of carbon fiber on the table. [8D]

Dinning room? I don’t understand. My house as three bedrooms, one kitchen, one bathroom and one...
Forum: Losi Monster Trucks
03-18-2005, 06:11 AM
Replies: 13
Views: 981
Posted By wal

RE: OK 4 those who blamed my last video, heres a new one!

Was that the nice ping of TiNi gears I could hear?

I think if you have access to an air compressor and some degreaser taking on the sand would be ok. A little to close to the water for my liking...
Forum: Losi Monster Trucks
03-18-2005, 01:17 AM
Replies: 1
Views: 402
Posted By wal

TiNi second gear,

Hi LSTers

I have just fitted my TiNi and my second gear seems a little off, I am either not engaging second gear or it engages straight away. The speed seems ok so I am thinking it’s the...
Forum: Losi Monster Trucks
03-18-2005, 01:07 AM
Replies: 7
Views: 492
Posted By wal

RE: LST Diff cover questions

I went with the plan LST ones, no problems. Just watch your shimming, I had to put the shim on the other side and all is ok. I found it easy to do the entire job with the truck upside down, the LST...
Showing results 1 to 25 of 107
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.