RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: jman12
Showing results 1 to 25 of 86
Search took 0.59 seconds.
07-20-2020, 08:52 AM
Replies: 32
Views: 9,339
Posted By jman12

Spirit of St Louis

I talked with Nick Ziroli Sr. about a proper engine for the Spirit of St Louis and he told me not to go below 70cc. You can fly it with a G62 with limited flight performance. I hope this helps.
12-20-2017, 05:28 AM
Replies: 1,010
Views: 312,068
Posted By jman12

Gents, After a few years sitting in my...

Gents,

After a few years sitting in my closet, I'm finally going to break out my Balsa USA Sopwith Pup kit and start the building process. Looking at a G62 or BT80 for power.
09-19-2012, 05:25 AM
Replies: 22
Views: 9,542
Posted By jman12

RE: Freewing ME-262

Totally different plane quality and color scheme.
06-20-2012, 09:48 AM
Replies: 5
Views: 1,445
Posted By jman12

RE: Amazing Aerial Videos

You tube is restricting access to your video. Says it's private.
Forum: RC Jets
03-01-2012, 11:24 AM
Replies: 151
Views: 20,527
Posted By jman12

RE: HobbyKing - Good or Bad

I order from them many times and never had a bad experience. Just remember, it takes a couple of weeks to get your order from Hong Kong.
Forum: Kit Building
09-08-2011, 03:35 PM
Replies: 25
Views: 4,328
Posted By jman12

RE: Global Skylane 45-60 build

Did you happen to save your fuselage plans? For some reason , my fuse plans disappeared from my shop. I would really appreciate a copy of the plans. Thanks. R/John Mynster
06-06-2011, 02:41 PM
Replies: 2
Views: 583
Posted By jman12

Floating Aileron Servo's

Sir,

I have been using the same 6EX TX and R617FS RX radio system for the past two years without any problems. Just recently I have been having problems with my ailerons not centering in the...
05-25-2011, 01:30 PM
Replies: 6
Views: 2,631
Posted By jman12

Futaba 7C Vector Thrust Setup

Ok guys, here is my question. My radio is setup for my SU-34 as follows:

Ch1 - Ailerons
Ch2 - Elevator
Ch3 - Throttle (ESC)
Ch4 - Rudder (Nose Wheel)
Ch5 - Retractable Landing Gear
Ch6...
05-03-2010, 12:54 PM
Replies: 56
Views: 15,716
Posted By jman12

RE: E-flite BAe Hawk 15 DF ARF

What is the best way to change out the fan unit? Where do you hold to tighten the collet?
05-01-2010, 06:04 PM
Replies: 9
Views: 1,266
Posted By jman12

RE: Beginner with questions

How many amps do I set to charge a 4s 2200 lipo?
07-12-2009, 06:33 PM
Replies: 1
Views: 974
Posted By jman12

7C 2.4 GHz TWO AILERON SERVO SETUP

I know this probably has been asked before, but can somebody give the a clue how to set up a two aileron servo setup. I have one servo on each aileron, one servo plugged into CH 1 and the other in...
Forum: Kit Building
03-12-2009, 07:11 AM
Replies: 17
Views: 2,526
Posted By jman12

RE: Dyna Flight Decathlon

I just bought a Dynaflight Decathlon for my 15 year old son this week. In fact, it should be on it's way from Tower Hobbies. I plan on putting in a Moki 2.10 with a Sonic-Tronic Super Smoke system....
01-30-2009, 08:14 AM
Replies: 11
Views: 2,075
Posted By jman12

RE: RC Report: Latest Victim of the Economy (R.I.P.)

I'm sad to hear and see RC Report's final edition. RC Report was the best overall magazine on the street today. I enjoyed reading the unbias reports on all sorts of model aviation. Gordon Banks is a...
01-26-2009, 03:39 PM
Replies: 0
Views: 503
Posted By jman12

Great Planes P6E Hawk Aileron - Rudder Mixing

Can somebody give me a quick rundown on aileron and rudder mixing for a Great Planes P6E Hawk? Thanks
01-22-2009, 08:57 PM
Replies: 10
Views: 1,539
Posted By jman12

RE: 7C PMix for dual elevator servos

I purchased a "Y" connector with a choke, connected each servo and plugged it into a FASST 6 channel receiver (channel 2). Everything works fine.
01-21-2009, 09:45 AM
Replies: 10
Views: 1,539
Posted By jman12

RE: 7C PMix for dual elevator servos

erec11,

Did you use a 7C radio to achieve success? I'm trying to work out the same problem with a "Y" connector, heavy duty servo extensions and a filter. I had the dual elevator servo's setup...
Replies: 4
Views: 719
Posted By jman12

RE: Servo Jitters

Thanks for the advice. At this point, I wouldn't take it out to the field.
Replies: 4
Views: 719
Posted By jman12

Servo Jitters

I have a problem with a dual elevator setup controlled by dual servo's located bottom to bottom in the tail section of the aircraft. If I unplug one servo the problem stops. If I relocate the servo...
01-12-2009, 09:54 AM
Replies: 2
Views: 767
Posted By jman12

RE: Great Planes P6E Biplane

Here are some pictures of the plane and my son Kurt.
01-12-2009, 09:47 AM
Replies: 2
Views: 767
Posted By jman12

Great Planes P6E Biplane

Hello everyone! I purchased the Great Planes P6E for my 50th birthday persent and did I get a damn good plane. Since this is an ARF I cant stick my chest out and claim too much for the success of the...
Forum: Kit Building
11-16-2008, 08:29 PM
Replies: 1,145
Views: 161,198
Posted By jman12

RE: 07 TopFlite Stinson build

The Top Flite Stinson has a Quadra 42 gas engine, Futaba FASST radio and servos for guidance, 21ST Century Fabric covering, and Pro Mark Model Grapics (Gullwing Airlines). The graphics were fairly...
Forum: Kit Building
11-16-2008, 08:06 PM
Replies: 1,145
Views: 161,198
Posted By jman12

RE: 07 TopFlite Stinson build

Hello everyone! Well, the day has come and my SR-9 is fianally completed. Here is a picture of my pride and joy. Yes the plane and my son!
01-15-2008, 09:04 AM
Replies: 32
Views: 9,339
Posted By jman12

RE: Ziroli Sprit of St Louis

Denny,

Check out our website for upcoming events. I know we're having a spring helicopter event. R/John
Forum: Gas Engines
01-14-2008, 03:39 PM
Replies: 0
Views: 484
Posted By jman12

MOVED: MOKI 2.10 Operators Manual

Glow Engines: http://www.rcuniverse.com/forum/fb.asp?m=6905822
Forum: Glow Engines
01-14-2008, 01:19 PM
Replies: 2
Views: 1,198
Posted By jman12

MOKI 2.10 Operators Manual

Can someone provide me a scanned copy of the Moki 2.10 operators manual? I would really appreciate the help. R/John
Showing results 1 to 25 of 86
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.