RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: rossb
Showing results 1 to 16 of 16
Search took 0.52 seconds.
Forum: RC On Road Nitro Cars
07-10-2005, 01:26 AM
Replies: 1
Views: 447
Posted By rossb

R40 build questions - wiring, etc..

What is part 73480 - 4 on this page of the manual:

http://www.hpiracing.com/graphics/instr/r40/R40-P29o.jpg

This plastic part behind the radio switch sticks out the side of the car and it...
Forum: RC On Road Nitro Cars
07-08-2005, 01:41 PM
Replies: 4
Views: 462
Posted By rossb

RE: R40, no instructions on how to adjust the suspension

Thanks. I just registered over there and I do not see an R40 forum. I do see a thread called "R40 forum" and it is about 250 posts long. Is that what you are talking about?
Forum: RC On Road Nitro Cars
07-08-2005, 07:30 AM
Replies: 4
Views: 462
Posted By rossb

RE: R40, no instructions on how to adjust the suspension

These sheets are answering some of my questions:

http://www.hpiracing.com/graphics/setup/haranatsr40_setup.jpg
http://www.hpiracing.com/graphics/setup/r40blank.pdf
...
Forum: RC On Road Nitro Cars
07-08-2005, 12:50 AM
Replies: 4
Views: 462
Posted By rossb

R40, no instructions on how to adjust the suspension

I just got an R40 kit. I am reading the book that came with the car and it does not mention anything about how to adjust the suspension. According to HPI the car has
Adjustable front/rear...
Forum: RC On Road Nitro Cars
07-07-2005, 09:30 PM
Replies: 6
Views: 731
Posted By rossb

RE: What engine are you running on your R40?

I am going to run this motor (http://www.ofna.com/eng-picco-roar.html) with an SG shaft. I have been very happy with the Picco .26 in my Savage (http://www.rbartick.com/hpi/buildidx.htm) so I...
Forum: RC On Road Nitro Cars
06-30-2005, 09:31 PM
Replies: 2
Views: 415
Posted By rossb

RD Logics pipes, Normal vs Turbo

Has anyone used an RD Logics pipe? Are these good pipes? I was considering using one with a Picco .12 ROAR motor.

What is the difference between a Normal and Turbo pipe? Both are ROAR legal....
Forum: RC On Road Nitro Cars
06-05-2005, 10:50 AM
Replies: 35
Views: 8,890
Posted By rossb

RE: Is the HPI Nitro RS4 3 18SS Kit a good first kit?

http://www.roarracing.com/toplevel/about.htm
Forum: RC On Road Nitro Cars
06-02-2005, 11:40 PM
Replies: 12
Views: 1,058
Posted By rossb

RE: Having trouble starting a brand new 18SS motor

I hate to state the obvious, but you are doing something wrong. The wheels spinning would not cause it to stall. Check your glow plug, set the needles back to factory specs, pre-heat the motor with...
Forum: RC On Road Nitro Cars
06-01-2005, 09:10 PM
Replies: 35
Views: 8,890
Posted By rossb

RE: Is the HPI Nitro RS4 3 18SS Kit a good first kit?

I race my 18ss in an Outlaw class. If we do not have enough cars for an Outlaw class they let me run with the ROAR legal cars. I am a ROAR member and I usually run here:

...
Forum: RC On Road Nitro Cars
06-01-2005, 09:08 PM
Replies: 12
Views: 1,058
Posted By rossb

RE: Having trouble starting a brand new 18SS motor

When I got my 18SS Kit I sealed the backplate and the carb neck with RTV before starting it. I also installed the HPI/Motorsaver performance air filter. I set the carb needles to the factory...
Forum: RC On Road Nitro Cars
05-30-2005, 10:05 PM
Replies: 28
Views: 1,680
Posted By rossb

RE: O.S. .12 in a RS4 3SS

I have the HPI 18ss in my RS4 and it is not blowing up parts. My kit did come with Heavy Duty parts.
Forum: RC On Road Nitro Cars
05-30-2005, 10:02 PM
Replies: 12
Views: 1,102
Posted By rossb

RE: Need Help With RS4 RTR 3

Check the fuel line when it shuts off. If it is getting fuel I would replace the glow plug. If it is not getting fuel you will have to look fot an air leak.
Forum: RC On Road Nitro Cars
05-29-2005, 10:58 PM
Replies: 35
Views: 8,890
Posted By rossb

RE: Is the HPI Nitro RS4 3 18SS Kit a good first kit?

The diffs will loosen up after you drive it.
Forum: RC On Road Nitro Cars
05-29-2005, 10:39 PM
Replies: 3
Views: 615
Posted By rossb

Will RS4 3 bodies fit an R40?

I painted 4 HPI 200mm bodies for my RS4 3 18ss. They are all cut out, trimmed, and reamed to fit my RS4. Will they fit on an R40? I know the tank, exhaust, and glow plug holes are different but I do...
Forum: RC On Road Nitro Cars
05-29-2005, 10:38 PM
Replies: 35
Views: 8,890
Posted By rossb

RE: Is the HPI Nitro RS4 3 18SS Kit a good first kit?

See this:

http://www.rbartick.com/hpi/rs4_buildidx.htm
Forum: RC On Road Nitro Cars
05-27-2005, 12:24 AM
Replies: 2
Views: 842
Posted By rossb

RS4 3 Sway Bar Install Question

I just got the HPI sway bars for my 18ss. I snapped the bar ends into the suspension arms and the bar ends move around a bit in the arms. This allows the bar to move a bit while it is installed on...
Showing results 1 to 16 of 16


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.