RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: CHEVPARTPRO
Showing results 1 to 25 of 52
Search took 0.58 seconds.
Forum: Giant Scale Aircraft - 3D & Aerobatic
07-21-2012, 06:47 AM
Replies: 25
Views: 8,533
Posted By CHEVPARTPRO

RE: EG Aircraft

I have the 30cc mx2. Very nice arf, good engineering, good quality, great flyer. My only issue was the stock tank had a split on the seam out of the box.
Forum: RC Rock Crawlers
04-06-2009, 06:52 PM
Replies: 15
Views: 1,273
Posted By CHEVPARTPRO

RE: which ESC to get?

How do your run the mamba or sidewinder on brushed? I didn't see anything on the website. I have a Phoenix on my Trex and am very happy with it.

Thanks
Todd
Forum: Traxxas Monster Truck forum
03-25-2009, 05:31 PM
Replies: 5
Views: 388
Posted By CHEVPARTPRO

RE: Revo Replacement Clutch ???

Running an 18tz on a stock clutch. No problem, just flip it around so the pins are on the trailing end of the shoe. Over a gallon on the current clutch.
Forum: Car Nitro & Gas Engines
03-20-2009, 07:59 AM
Replies: 12
Views: 1,774
Posted By CHEVPARTPRO

RE: OS .18tz PLUG

p7 plug and curtis youngblood wildcat 20%. switching over to cool power 20% heli when the cy is done. i don't think there is any rust inhibitors in the cy
running the engine in a revo.
Forum: Traxxas Monster Truck forum
02-25-2009, 07:59 PM
Replies: 2,573
Views: 343,097
Posted By CHEVPARTPRO

RE: REVO PICS(POST YOUR REVO PICS HERE)

Let the comments begin.
Forum: Traxxas Monster Truck forum
11-22-2008, 11:11 AM
Replies: 7
Views: 555
Posted By CHEVPARTPRO

RE: rear shocks on revo?

check the pillow balls on the hubs. If they are too tight they will bind.
Forum: Traxxas Monster Truck forum
11-10-2008, 09:06 PM
Replies: 11
Views: 677
Posted By CHEVPARTPRO

RE: Os .18 in revo being strange...

if it sounds like a rattling can of marbles it may be one of the bearings going.
Forum: Car Nitro & Gas Engines
11-06-2008, 06:42 PM
Replies: 29
Views: 2,223
Posted By CHEVPARTPRO

RE: top speed

I'm running the 18TZ and blowing past the big block losi eight's.

Running 36t spur 17t clutch bell and wide gears in the tranny.
Forum: Traxxas Monster Truck forum
10-26-2008, 01:31 PM
Replies: 9
Views: 2,025
Posted By CHEVPARTPRO

RE: Revo Platinum Vs 3.3 length

the platinum has a wing. That's about two inches??
Forum: Traxxas Monster Truck forum
10-04-2008, 02:18 PM
Replies: 5
Views: 534
Posted By CHEVPARTPRO

RE: stock filter to motor saver

more air needs more fuel
Forum: Car Nitro & Gas Engines
09-30-2008, 02:12 PM
Replies: 10
Views: 1,666
Posted By CHEVPARTPRO

RE: Cooling head screws, locktite?

Put some fuel on your screws before you install them. The oil will burn and lock the screws in place till you need to remove them again.
Forum: Traxxas Monster Truck forum
09-29-2008, 06:49 PM
Replies: 8
Views: 471
Posted By CHEVPARTPRO

RE: Say it aint so.. Bad Front bearing???

I got an OS18tz with a leaking front bearing. Noticed just after break in. Swapped it out and haven't looked back. A little seepage is normal, but when it won't hold a tune or idle properly it's...
Forum: Traxxas Monster Truck forum
09-29-2008, 08:18 AM
Replies: 3
Views: 347
Posted By CHEVPARTPRO

RE: ent over

+1 on the wing. The Illuzion tango body is heavier and provides good engine protection as well.
Forum: Traxxas Monster Truck forum
09-08-2008, 09:45 AM
Replies: 7
Views: 600
Posted By CHEVPARTPRO

RE: Which Smallblock for revo 3.3?

Got an 18tz in my revo. It uses the stock mount. My truck is bump start so the backplate wasn't an issue. You may have to lightly mod the crank depending on which tz you use. I run the stock revo...
Forum: Traxxas Monster Truck forum
09-06-2008, 04:00 PM
Replies: 15
Views: 1,880
Posted By CHEVPARTPRO

RE: aluminum rims for revo

Aluminum rims are usually heavier than plastic and will not flex. If you bash at all, stick with the plastic ones. You will break the aluminum ones.
Forum: Car Nitro & Gas Engines
08-27-2008, 02:56 PM
Replies: 6
Views: 811
Posted By CHEVPARTPRO

RE: Too Lean?

I recently switched over from a trx3.3 to an os18tz. I found that the temps dropped when I switched to 20% fuel over 30%. The os manual says use 5-20% fuel. The power difference was not noticeable...
Forum: Car Nitro & Gas Engines
08-27-2008, 02:47 PM
Replies: 6
Views: 727
Posted By CHEVPARTPRO

RE: Other causes of overheating than running too lean ?

Improper gearing can also cause heat issues. If the engine doesn't have enough load it can rev too high and cause overheating while running with a proper tune.
Had that problem when I switched...
Forum: Century - Predator, Hawk IV, Falcon, Raven
08-22-2008, 03:21 PM
Replies: 7
Views: 2,530
Posted By CHEVPARTPRO

RE: Hawk Pro Gyro Location???

I have mine on top of the fan shroud under the linkages. No residue, no interference
Forum: Traxxas Monster Truck forum
08-20-2008, 02:20 PM
Replies: 334
Views: 42,674
Posted By CHEVPARTPRO

RE: REVO RACIN' THREAD

http://image2-3.rcuniverse.com/e1/forum/upfiles/192006/Ge66493.jpg
Forum: Traxxas Monster Truck forum
08-19-2008, 02:29 PM
Replies: 334
Views: 42,674
Posted By CHEVPARTPRO

RE: REVO RACIN' THREAD

Let's see

Revo 3.3 chassis
dx3r radio
OS 18TZ(p)
40 mm flywheel
imex pipe
imex air cleaner
center diff
platinum throttle servo mount
Forum: Traxxas Monster Truck forum
08-12-2008, 07:56 AM
Replies: 10
Views: 1,049
Posted By CHEVPARTPRO

RE: Good Revo clutch?

Just flip the stock one so the pins push the shoes. It will last much longer and grab quicker.
Forum: Traxxas Monster Truck forum
08-11-2008, 10:32 AM
Replies: 20
Views: 15,155
Posted By CHEVPARTPRO

RE: rc airplane engine in rc truck

It won't get enough cooling. It's designed to have a prop blowing air over it constantly.
Forum: Traxxas Monster Truck forum
08-08-2008, 08:27 PM
Replies: 2,573
Views: 343,097
Posted By CHEVPARTPRO

RE: REVO PICS(POST YOUR REVO PICS HERE)

My Big block killer. OS18tz with wide ratio gears 16t/36t cb and spur, Imex air cleaner and muffler. Weighs in at 8.75lbs.
Wish I had a radar gun! I got the losi eight & ofna hyper's beat at our...
Forum: Traxxas Monster Truck forum
08-05-2008, 07:21 PM
Replies: 15
Views: 1,031
Posted By CHEVPARTPRO

RE: Want top power and speed!!!

os 18 tz! It's a monster that'll keep up with the big blocks. Fits the original motor mount but some modding is required. And it's not as thirsty as the big blocks.
Forum: Traxxas Monster Truck forum
07-24-2008, 05:43 PM
Replies: 15
Views: 2,075
Posted By CHEVPARTPRO

RE: Single Speed Conversion

Hey Oopmwa,

I'm interested in your conversion kit. Sent ya a pm.

Todd
Showing results 1 to 25 of 52
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.