RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Pellicle
Showing results 1 to 13 of 13
Search took 0.53 seconds.
07-25-2010, 02:00 PM
Replies: 7
Views: 2,220
Posted By Pellicle

RE: 3G AND FLYMENTOR

I believe the two are incompatible.

Both generate a mixed signal and require a unmixed input. So either way you put them in series they would not function properly.

A unit like the Skookum...
Forum: T-Rex heli
12-31-2009, 10:13 AM
Replies: 4
Views: 815
Posted By Pellicle

RE: Where can I find this replacement part?

I have never seen these sold separately. If you buy a set of landing gear you will likely need them as they are a high replacement item compared to other parts. Then you will have spares. The silds...
Replies: 4,979
Views: 915,205
Posted By Pellicle

RE: New Hitec Aurora 9-Channel 2.4Ghz Radio System

I just picked up one with a 7 channel receiver . Already opened my Christmas present!!
Now to get some better weather for flying[:o]

I like the positioning of the switches and controls. ...
12-17-2009, 11:26 AM
Replies: 10
Views: 5,801
Posted By Pellicle

RE: Is Vbar worth the added expense?

I think any of the systems will make you happy. Go with a 3 axis MEMS based systems which most of the good one are.
12-15-2009, 11:18 PM
Replies: 10
Views: 5,801
Posted By Pellicle

RE: Is Vbar worth the added expense?

The Spatan requires you also buy additional gyros for each axis. This also allows for use of a infrared stabilization unit. These sense the temp differential between sky and the ground.
So for...
12-12-2009, 01:05 PM
Replies: 10
Views: 5,801
Posted By Pellicle

RE: Is Vbar worth the added expense?

Don,
The stabilization systems make the heli much more resistant to wind. In general you can set it up to be very stable in a hover but you still need to know how to hover. On some systems you...
12-11-2009, 11:28 AM
Replies: 10
Views: 5,801
Posted By Pellicle

RE: Is Vbar worth the added expense?

It all depends on what you want. The pros go beyond looks and flight time. Head speed is arguable but you do get slightly more available power or time due to the decreased resistance. You can use...
12-11-2009, 10:02 AM
Replies: 7
Views: 1,992
Posted By Pellicle

RE: my TT raptor30 tail rattles or shakes left to right

Check to make sure the tail linkage has no slop or binding. Damage can cause this and can make it difficult for the gyro to control the tail properly. Also check you tail rotor shaft. A bent shaft...
11-23-2009, 08:43 AM
Replies: 7
Views: 4,283
Posted By Pellicle

RE: Flybarless Supplier

The Gaui 365 is a 3 axis flybarless system. It uses older technology sensors but is I think it is the lowest priced flybarless stabilizer system. It does have drift and vibration issues compared to...
11-02-2009, 10:33 PM
Replies: 3
Views: 1,072
Posted By Pellicle

RE: LCD Glasses Heli Tach

Bill,

Could you PM me on this subject?

Thanks
11-01-2009, 04:35 PM
Replies: 3
Views: 1,072
Posted By Pellicle

RE: LCD Glasses Heli Tach

Does anyone know where one of these units can be found? I really like the design. For smaller copters the ability to measure a higher RPM would be great.
09-04-2005, 09:04 AM
Replies: 1,266
Views: 187,651
Posted By Pellicle

RE: ParkZone Slo-V Review

So you replaced the receiver and put in a brushless ESC? Which Rimfire Outrunner did you choose?
09-03-2005, 12:01 PM
Replies: 1,266
Views: 187,651
Posted By Pellicle

RE: ParkZone Slo-V Review

The pinion gear on the motor cracked during my first flight . Thought I had lost power but on inspection the gear was turning on the shaft and had a crack between two teethe. I want to upgrade to a...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.