RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: kostaktinos_mt
Showing results 1 to 25 of 500
Search took 1.35 seconds.
Replies: 10
Views: 713
Posted By kostaktinos_mt

RE: feigao over heating

i am not a novak fan [i owned some;didn`t like them], and incidentally i haven`t owned a neu [seen a couple in action from 1st person experience though]...
but i have heard all sorts of good stuff...
Replies: 10
Views: 713
Posted By kostaktinos_mt

RE: feigao over heating

all sensorless bl motors will overheat when run without load and minimal voltage feed... with high voltage feed and without load, chances are that the rotor will crack because of the centrifugal...
Replies: 1
Views: 307
Posted By kostaktinos_mt

RE: I need to widen my Tsunami

redcat sells alloy extended a-arms for your truck...
also found on one of the versions of the truck...
Replies: 7
Views: 920
Posted By kostaktinos_mt

RE: Battery/Setup for maximum run time

brushless adds efficiency on its own [when compared with brushed], but brushless to brushless is different... as a general principle, high-voltage / low amp setups [which usually imply many cells in...
Replies: 7
Views: 920
Posted By kostaktinos_mt

RE: Battery/Setup for maximum run time

get a tekin r1pro... has a 'true' real-time adjustable current limiter, which allows you to tame down the huge current bursts under heavy acceleration, and thus increase system efficiency &...
Replies: 4
Views: 692
Posted By kostaktinos_mt

RE: What is the best brushless system for the emaxx?

lehner 1950/6 or 1940/7 or plettenberg bigmaxx pro, with either quark125b or tekin r1pro...
you asked for the best...
Replies: 8
Views: 1,174
Posted By kostaktinos_mt

RE: Conversion Motor mounts for 1/8 applications

offshoreelectrics sells a motor mount that does a suprisingly nice job on most conversions...
Replies: 31
Views: 2,341
Posted By kostaktinos_mt

RE: E-Savage Simple Brushless System By KLO

no way it works smooth... 32p and mod1 will work together, but VERY INEFFICIENTLY, which means lots of noise, heat, wear and tear, and limited performance ratio...
Replies: 78
Views: 6,737
Posted By kostaktinos_mt

RE: e-savage brushless project ( with pics!)

ammo`s don`t have pressed-in endbells like feigaos, so there are no endbell popping-off problems whatsoever...

as far as the ammo motors...well... everyone that is either a visitor or a member...
Replies: 15
Views: 760
Posted By kostaktinos_mt

RE: Motor Mount for E-Warhead

offshoreelectrics has some nice motor mounts...
Replies: 61
Views: 3,074
Posted By kostaktinos_mt

RE: Forgive me, E-Maxx VS E-Savage

my opinion has been expressed many times, so i won`t do that once more... not in detail i mean...
but on what you said here, i have to disagree...
i had an emaxx for 2.5years, modded completely...
Replies: 13
Views: 791
Posted By kostaktinos_mt

RE: e savage

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXPRL3&P=ML

i repeat, that the stock charger is also a decent unit...charges anything between 1-8cells, voltage boosting, full peak detection for...
Replies: 13
Views: 791
Posted By kostaktinos_mt

RE: e savage

i had one...and never said i had problems... i said i prefer the stock gt charger over the duratrax one... therefore i wouldn`t buy the twinpeak if i was buying a new esavage...and even if i got the...
09-27-2007, 05:30 AM
Replies: 10
Views: 1,322
Posted By kostaktinos_mt

RE: e savage vs e maxx

second that... had an emaxx for 2.5years, and currently own an ezilla/esavage for the past 2years... the esavage gets my vote with no second thoughts...
Replies: 41
Views: 1,429
Posted By kostaktinos_mt

RE: e-savage quality

side by side packs don`t fit the stock holders without mods...
3racing straps, or twinforce trays work great and are relatively cheap... 6 or 7cells, side by side...
Replies: 13
Views: 791
Posted By kostaktinos_mt

RE: e savage

the intellipeak dual is worse than the esavage stock charger...
the stock batteries aren`t top notch by any means though...
Replies: 25
Views: 1,640
Posted By kostaktinos_mt

RE: How to do wheelies w/ E-Savage?

it works fine at 14cells...
09-06-2007, 12:51 PM
Replies: 1
Views: 582
Posted By kostaktinos_mt

RE: Best choice for charger

hobbico dual peak... around 45$, peak detection, pulse charging, 5amp dual output...
Replies: 10
Views: 771
Posted By kostaktinos_mt

RE: E-Savage, E-Zilla whats the difference? Please help

nope... no leading authority or so...
i just happen to know what i am talking about...
you may ask around if my posts don`t fit your questions...
and good afternoon...
Replies: 6
Views: 685
Posted By kostaktinos_mt

RE: Rustler XL-5 in the bush

140F max, although i recommend staying at 120F for extended battery life...
Replies: 6
Views: 685
Posted By kostaktinos_mt

RE: Discharger???

3600s were the max capacity batteries by the time the particular discharger was designed and promoted...
and yes, you can easily fit deans...
Replies: 3
Views: 424
Posted By kostaktinos_mt

RE: e-savage lost power

perhaps your slipper clutch has become a bit loose...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.