RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: corporateoutcast
Showing results 1 to 17 of 17
Search took 0.64 seconds.
Forum: Sport Flying
06-26-2007, 02:06 PM
Replies: 6
Views: 776
Posted By corporateoutcast

RE: Propeller pushing in reverse?!?!

ahh ok, that's actually the first time I've had it happen, but I now see how it can occur.
Forum: Sport Flying
06-25-2007, 09:06 PM
Replies: 6
Views: 776
Posted By corporateoutcast

Propeller pushing in reverse?!?!

Hey all!

Tonight during warm-up of my OS .46 AX engine, I noticed the most bizarre behavior yet. When I flip started my plane, the prop starting pushing the plane in reverse! I stopped the...
Forum: Glow Engines
05-30-2007, 06:33 AM
Replies: 7
Views: 3,291
Posted By corporateoutcast

RE: Royal .46 Engine help

I just took out the plane yesterday and tweaked the high speed needle right up to the end of then the throttle increases when you pinch the fuel line.

The engine isn't running too bad and seems...
Forum: Glow Engines
05-28-2007, 12:59 PM
Replies: 7
Views: 3,291
Posted By corporateoutcast

Royal .46 Engine help

Greetings all!

I just recently repaired an old trainer that's been sitting on the shelf for a couple years and I'm having an issue with it's old Royal .46 engine. I flip start it with a starting...
Forum: RC Car Radio Equipment
06-24-2006, 01:29 PM
Replies: 95
Views: 15,192
Posted By corporateoutcast

RE: spectrum pros and cons.

Everything with this radio is "Pro"! I have the DX3 and purchased the Telemetry unit for both my T-Maxx and Nitro 4-Tec and I absolutely love the flexibility. I've read guys having problems with drop...
Forum: Park Flyers & Backyard Flyers
06-16-2006, 10:38 AM
Replies: 2,602
Views: 195,595
Posted By corporateoutcast

RE: F27 STRYKER, WAY PAST THE LIMITS! PART 4...

is that paint covered with tape or blue tape?

looks sharp!
Forum: Aerial Photography and Video
06-14-2006, 09:12 AM
Replies: 1
Views: 715
Posted By corporateoutcast

Stryker video - onboard and off

Playing around with some video of my newly built brushless Stryker.

Maiden Flight

Onboard - Down the nose

Onboard - Down the tail - Part 1

Onboard - Down the tail - Part 2
Forum: Park Flyers & Backyard Flyers
06-12-2006, 07:03 AM
Replies: 2,602
Views: 195,595
Posted By corporateoutcast

RE: F27 STRYKER, WAY PAST THE LIMITS! PART 4...

Hey all!

So, as probably most of the people here got the email from Hobby Zone last night or this morning, Did you see the Stryker C? Looks like they did away with the proprietary design of...
Forum: Park Flyers & Backyard Flyers
06-08-2006, 02:51 PM
Replies: 2,602
Views: 195,595
Posted By corporateoutcast

RE: F27 STRYKER, WAY PAST THE LIMITS! PART 4...

I had that happen once, it was my Deans connectors for my power. Cold solder joint and the wire was moving around in the heat shrink. Do you know how much your current draw is at full power?

jeff
Forum: Park Flyers & Backyard Flyers
06-07-2006, 03:12 PM
Replies: 2,602
Views: 195,595
Posted By corporateoutcast

RE: F27 STRYKER, WAY PAST THE LIMITS! PART 4...

Maxamus,

The paint is just a typical "Rustoleum" type spray paint. It peels off easily when you apply a sticker, so I had to be somewhat strategic when I reinforced the motor mount with duct...
Forum: Park Flyers & Backyard Flyers
06-07-2006, 09:35 AM
Replies: 2,602
Views: 195,595
Posted By corporateoutcast

RE: F27 STRYKER, WAY PAST THE LIMITS! PART 4...

I took my 3rd Stryker brushless out for it's maiden flight lastnight. Click HERE to check out the video!

http://corporateoutcast.com/images/bluebird.jpg

Specs:
Mega 16/15/4 brushless
...
Forum: Electric RC Helis
05-11-2006, 10:20 AM
Replies: 314
Views: 82,087
Posted By corporateoutcast

RE: HeliMax MX400 CCPM heli "build" thread

OK, I crashed but I learned a TON! In my previous message a referred to the vibration, this was caused by 2 things, blade balance and lack of Pitch curve.

In my configuration I mistakenly setup...
Forum: Electric RC Helis
05-09-2006, 09:30 PM
Replies: 314
Views: 82,087
Posted By corporateoutcast

RE: HeliMax MX400 CCPM heli "build" thread

hey guys got a few questions for you.

I just recently got my MX400 Pro back up and running and I've never successfully flown this thing and still in the setup stage. I slowly starting to tweak...
Forum: RC Car Radio Equipment
03-10-2006, 09:12 PM
Replies: 1
Views: 458
Posted By corporateoutcast

RE: Spektrum hook up?????

Yeah hook the power up to the aux box on any unused connector. Then connect the jumper from the reciever's BATT/TEL port to the AUX box's T port. I have a T-Maxx using a DX3 with the RPM and...
Forum: RC Car Radio Equipment
01-30-2006, 02:21 PM
Replies: 1
Views: 752
Posted By corporateoutcast

Spektrum DX3 & Telemetry questions

Greetings All!

I have 2 questions regarding the Spektrum DX3.

Has anyone come up with a way of mounting the Telemetry hand-held unit to a DX3 transmitter? Curious to see before I start...
Forum: Beginners
11-14-2005, 05:23 PM
Replies: 18
Views: 1,318
Posted By corporateoutcast

RE: New engine question, OS 46AX

got the starter yesterday! :)

thanks for the reply.

jeff
Forum: Beginners
11-14-2005, 04:11 PM
Replies: 18
Views: 1,318
Posted By corporateoutcast

New engine question, OS 46AX

I'm a complete newbie to RC airplanes and installed a new OS 46AX engine this weekend and had a question about starting it. It seems like there is quite a level of resistance when cranking the...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.