RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: hockey101
Showing results 1 to 21 of 21
Search took 0.50 seconds.
Forum: RC Nitro Stadium Trucks
04-18-2006, 04:57 PM
Replies: 4
Views: 372
Posted By hockey101

advice please!

Nitro evader w. os 18cvr, engine running but wheels not turning. checked slipper. whats going on. I have taken apart the tranny not too long ago. everything looked good.


Thanks
Forum: RC Nitro Stadium Trucks
04-05-2006, 02:36 PM
Replies: 2
Views: 421
Posted By hockey101

RE: Aluminum EZ start cover for Jato/2.5R??

i dont think they make that, what i did was ca glue a piece of aluminum foil there, it takes some patience to get all the wrinkles out but seems to work. shiny side out reflects heat better.

...
Forum: RC Nitro Stadium Trucks
04-05-2006, 07:27 AM
Replies: 4
Views: 429
Posted By hockey101

2.5 sleeve and piston

2 questions,

First will a 2.5r engine rebuild kit fit in a 2.5?

Second, will the be a difference in perfomance?

Thanks Guys
Forum: RC Nitro Stadium Trucks
04-04-2006, 08:55 AM
Replies: 6
Views: 384
Posted By hockey101

RE: compression

thanks for your help,
i can turn the flywheel with my pinky but can definately feel where TDC is and is sort of tough to turn i dont understand what step 3 is
Forum: RC Nitro Stadium Trucks
04-03-2006, 02:57 PM
Replies: 6
Views: 384
Posted By hockey101

compression

How do you know if you need to replace your engine. I have a Traxxas 2.5 and have about 3 or 4 gallons through it.
Forum: RC Nitro Stadium Trucks
03-18-2006, 12:14 PM
Replies: 8
Views: 5,287
Posted By hockey101

RE: clogged carb?

I have a Jato and I had the same problem. I changed all the fuel lines, cleaned the high speed and the low speed needle, changed the fuel tank, and tightened the back plate..from what you described...
Forum: RC Nitro Stadium Trucks
03-06-2006, 12:51 PM
Replies: 5
Views: 574
Posted By hockey101

RE: Engine only working when primed ??

I agree change the fuel and dont let it sit in the tank. Also change the glow plug.One trick I use is on my intial start I warm the head with a hair dryer it seems to start right away after that

...
Forum: RC Nitro Stadium Trucks
03-03-2006, 08:22 AM
Replies: 7
Views: 602
Posted By hockey101

RE: nitro evader st

i also have the os 18cvr and noticed increased performance somewhere high 40's low 50 mph range
Forum: RC Nitro Stadium Trucks
02-26-2006, 09:30 AM
Replies: 0
Views: 271
Posted By hockey101

link for new jato tires

http://www.imexrc.com/sneakpeek.htm
Forum: RC Nitro Stadium Trucks
02-26-2006, 09:27 AM
Replies: 16
Views: 625
Posted By hockey101

RE: traxxas 2.8 rubber

These are awesome. no dat as to when they come out though
Forum: RC Nitro Stadium Trucks
02-26-2006, 09:26 AM
Replies: 16
Views: 625
Posted By hockey101

RE: traxxas 2.8 rubber

http://www.imexrc.com/sneakpeek.htm

Here they are
Forum: RC Nitro Stadium Trucks
01-31-2006, 09:49 AM
Replies: 1
Views: 303
Posted By hockey101

RE: new engine

Is the Jato new? Why do you want a new engine. the 2.5 that is stock is very powerful and fast.
Forum: RC Nitro Stadium Trucks
01-27-2006, 10:32 AM
Replies: 4
Views: 279
Posted By hockey101

RE: gas not getting to carb

Its an air leak... try replacing all the fuel lines, tighten the carb and check the lid on the gas tank.... you can check for leaks by either using bubbles (for kids) or liquid dish soap and some...
Forum: RC Nitro Stadium Trucks
01-27-2006, 10:25 AM
Replies: 2
Views: 380
Posted By hockey101

RE: Jato questions

I run on the road quite a bit. the best tires i found are proline road hawgs in the front. and proline road rage in the back...it seems to hook up the best with the least amoutn of wear


good...
Forum: RC Nitro Stadium Trucks
01-20-2006, 08:21 AM
Replies: 5
Views: 659
Posted By hockey101

RE: roto start or e-z start?

to answer your question, they both have good/bad points

roto start you need to buy a glow plug driver and sometimes its hard to find the slot where the dogbone lines up (this is true of the...
Forum: RC Nitro Stadium Trucks
01-20-2006, 07:58 AM
Replies: 6
Views: 586
Posted By hockey101

RE: tuneing nitro engines

I would get a temp gun (duratrax flashpoints are cheap and easy to use point and shoot).. But from what it sounds like, you are running way too hot. Dont go by the glow plug color.. you wont know if...
Forum: Traxxas Monster Truck forum
12-31-2005, 09:54 AM
Replies: 17
Views: 873
Posted By hockey101

RE: After Run oil....EVERYTIME???

I have an OSmax 18cv-r engine and booklet says DO NOT put after run in the carb as it will cause the o rings inside the carb to dry out
Forum: RC Nitro Stadium Trucks
12-31-2005, 09:48 AM
Replies: 8
Views: 516
Posted By hockey101

RE: Jato... I need help finding a air leak

I will try that..
Another question, will a low battery in the starter cause that problem?
Forum: RC Nitro Stadium Trucks
12-31-2005, 09:20 AM
Replies: 8
Views: 516
Posted By hockey101

Jato... I need help finding a air leak

I need help finding an air leak. I think it is a leak because the engine wont prime. I have replaced the fuel tank and lines
Forum: RC Nitro Stadium Trucks
12-31-2005, 09:17 AM
Replies: 2
Views: 334
Posted By hockey101

Jato... I need help finding a air leak

I need help finding an air leak.
Symptoms engine will not prime. I have replaced the fuel tank and lines

Help
Forum: Glow Engines
12-31-2005, 09:13 AM
Replies: 2
Views: 534
Posted By hockey101

Jato??? I need help finding a air leak

I think I have an air leak somewhere. the reason is, the engine will not prime, I have replaced the fule tank and the lines. How do I find the leak.
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.