RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: Vendetta
Showing results 1 to 25 of 168
Search took 0.53 seconds.
Forum: Gas Engines
11-20-2008, 08:17 PM
Replies: 9
Views: 1,732
Posted By Vendetta

RE: CRC 26 Troubles...

Yeah I hear a arc in the box as the magnet passes over the sensor so the Hal seems to be working. The manual says 4.8-6v so I dont think its was the pack. I have spoken to Alex at AK Models and he...
Forum: Gas Engines
11-18-2008, 09:18 AM
Replies: 9
Views: 1,732
Posted By Vendetta

RE: CRC 26 Troubles...

Well, I've gotten it started in the last few days and ran about a total of 70 minutes in 10 minute cycles and the last run it was running horrible, wouldnt run up properly properly and now all of a...
Forum: Gas Engines
11-13-2008, 12:08 PM
Replies: 9
Views: 1,732
Posted By Vendetta

RE: CRC 26 Troubles...

Thanks for the replies folks, I will try and keep you posted...
Forum: Gas Engines
11-13-2008, 11:44 AM
Replies: 9
Views: 1,732
Posted By Vendetta

CRRC 26 Troubles...

Before I get flamed, I klnow there is a very extensive post on this engine, I've read most of the 600+ replies on that thread but I have a few questions and that thread was started so long ago that...
Forum: RC Warbirds and Warplanes
11-06-2008, 07:58 PM
Replies: 0
Views: 560
Posted By Vendetta

Servo Options for CMP Hellcat 90

I'm about to start a CMP Hellcat 90 with a crrc 26. I have FUT S3004's but something tells me that 44 oz/in at 4.8v wont be enough. What do you folks figure is the minimum for oz/in ??? Thanks.
Forum: RC Warbirds and Warplanes
10-17-2008, 07:51 PM
Replies: 27
Views: 3,009
Posted By Vendetta

RE: H9 Hellcat Crash Video

You guys are a funny bunch
Forum: RC Warbirds and Warplanes
10-17-2008, 07:51 AM
Replies: 27
Views: 3,009
Posted By Vendetta

RE: H9 Hellcat Crash Video

Wow a lot of hatters around here...
Forum: RC Warbirds and Warplanes
10-16-2008, 03:51 PM
Replies: 4
Views: 813
Posted By Vendetta

RE: Cmpro and Nitro planes

$81 + 40 for the 90 Size hellcat? from who?
Forum: RC Warbirds and Warplanes
10-16-2008, 09:29 AM
Replies: 4
Views: 813
Posted By Vendetta

Cmpro and Nitro planes

I'm a bit confused, can you folks help. Whats the difference between the Nitro Planes Hellcat, the CMPro and the Giant Scal Planes hellcat? All look to be the same but saw a comment where someone...
Forum: RC Warbirds and Warplanes
10-13-2008, 09:39 PM
Replies: 27
Views: 3,009
Posted By Vendetta

RE: H9 Hellcat Crash Video

add either more plywood guides along the inside of the fuse or rear mount the servos... I learned the hard way !
Forum: RC Warbirds and Warplanes
10-13-2008, 07:46 AM
Replies: 27
Views: 3,009
Posted By Vendetta

RE: H9 Hellcat Crash Video

Like I said, speed was definately a factor.
Forum: RC Warbirds and Warplanes
10-12-2008, 09:10 PM
Replies: 27
Views: 3,009
Posted By Vendetta

H9 Hellcat Crash Video

Well, I completely destroyed my hellcat today. I believe the crash was caused by a faliure of the elevator due to the pushrod guide breaking off from the Plywood guide and causing the guide and rod...
Forum: Batteries & Chargers
10-05-2008, 06:58 PM
Replies: 4
Views: 646
Posted By Vendetta

RE: Ni-Mh Temp

Not sure. The cycle was set to 1.0a discharge and 4.0a charge. Pack seems healthy though. Was hot as heck though...
Forum: Batteries & Chargers
10-05-2008, 10:56 AM
Replies: 4
Views: 646
Posted By Vendetta

Ni-Mh Temp

I just recioeved a 4.8v 4000mAh Ni-Mh pack. I cycled the pack and it came back at about 4490Ma. I never heard the charger end but when I re4alized that the pack had ended the charge I decided to...
Forum: Batteries & Chargers
09-29-2008, 04:08 PM
Replies: 13
Views: 1,069
Posted By Vendetta

RE: Large capacity RX Packs?

found this place, http://www.cheapbatterypacks.com. They have Elite 4000 Sub C cells. These cells any good?
Forum: Batteries & Chargers
09-29-2008, 03:42 PM
Replies: 13
Views: 1,069
Posted By Vendetta

Large capacity RX Packs?

I'm looking for a large Capacity Ni-Mh pack. I would like a 4.8v Sanyo Cell pack with about a 4000mAh Capacity. I know I can find the indivisual cells for about $7.00 (Sanyo HR-4/3AU 4000 NIMH) but...
Forum: Glow Engines
09-26-2008, 04:47 PM
Replies: 3
Views: 732
Posted By Vendetta

RE: Fuel Dot placement

Great, Thanks for the response !
Forum: Glow Engines
09-26-2008, 11:09 AM
Replies: 3
Views: 732
Posted By Vendetta

Fuel Dot placement

I know the center line of the fuel tank should be even with the carburetor on the engine or a tad bit lower. My question is what if the fuel dot is lower? Other words, the fuel line itself is...
Forum: Glow Engines
09-20-2008, 05:29 PM
Replies: 0
Views: 475
Posted By Vendetta

OS .76 Pitts Muffler Question

I Have a OS .76AX and a slimline pitts compact muffler. Problem is they gave the the wrong muffler. Its the Slimline 3217 (for the .61, specs below), I should have gotten the 3213 which says for...
Forum: RC Warbirds and Warplanes
09-14-2008, 09:13 PM
Replies: 5
Views: 955
Posted By Vendetta

RE: JR 791 Retarct Servo

Thanks for the info folks...
Forum: RC Warbirds and Warplanes
09-14-2008, 03:06 PM
Replies: 5
Views: 955
Posted By Vendetta

RE: JR 791 Retarct Servo

I actually found on another forum that it will work on 6v BUT that some RX's were picky about it... Anyone using it with a spectrum RX at 6v?
Forum: RC Warbirds and Warplanes
09-14-2008, 02:58 PM
Replies: 5
Views: 955
Posted By Vendetta

JR 791 Retarct Servo

Can this servo be used with a 6v system? I noticed JR only has specs for 4.8v. Going to be used in a H9 hellcat. Thanks.

791 Hi-Torque Lo-Profile MG Retract Servo
Specs
Size...
Forum: 3D Flying!
08-31-2008, 09:55 AM
Replies: 2
Views: 640
Posted By Vendetta

3D plan differences...

I had posted this in another section of the forum and didnt get much in the form of an answer and was hoping I would get a better response here...

I've been flying for a few years now and do...
Forum: Beginners
08-30-2008, 10:10 PM
Replies: 3
Views: 504
Posted By Vendetta

3D Plane differences

I've been flying for a few years now and do mild 3D. I would like to build a 50cc 3D. I was wondering if someone can explain the basic differences between a few different models. What are some of...
Forum: ARF or RTF
07-31-2008, 06:01 PM
Replies: 5
Views: 787
Posted By Vendetta

RE: H9 Pulse w/ OS .46 AX Props

Thanks guys !! I'll keep you posted ! :eek:
Showing results 1 to 25 of 168
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.