RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: raile
Showing results 1 to 25 of 34
Search took 0.50 seconds.
Forum: Gas Engines
03-25-2013, 01:28 PM
Replies: 2
Views: 815
Posted By raile

RE: spe 26cc or mld 28 prop hub?

Thank you for info flyinwalenda, I see they have Stop ring or Front crankcase ring for SPE-26 & MLD-28, MAP: $3.00. would this be a fix so the hub cant go on crank as far and split. Have had nitros...
Forum: Gas Engines
03-25-2013, 12:51 PM
Replies: 2
Views: 815
Posted By raile

spe 26cc or mld 28 prop hub?

Hello, got a giles 202 with spe 26cc that runs perfect but the prop hub is split. I think the mld and spe are the same? Where Can i purchase one of these and a wood ruff key? . Really want to fly...
Forum: Seaplanes
02-14-2012, 06:44 AM
Replies: 5
Views: 1,314
Posted By raile

Box tape on bottom of neptune?

would it be ok to use box tape on the bottom of neptune before covering gets to bad or just recover?if recover, Can you just go over old covering with monokote for an added layer? Thanks
Forum: Seaplanes
02-13-2012, 08:23 AM
Replies: 5
Views: 1,129
Posted By raile

RE: 49 neptune value hobby motor to weight?

thanks again for reply, It burnt the esc up, had watt meter at 390 when rated for 450. These are just junk from what I can tell. Second combo from above supplier and same problem. Went to local LHS...
Forum: Seaplanes
02-11-2012, 12:12 PM
Replies: 5
Views: 1,129
Posted By raile

RE: 49 neptune value hobby motor to weight?

well flew this plane today and it flew very well for the short 3 minute flight I had. Got it all trimed out and flew at about half throttle and it just shut off, glided it in for safe landing but esc...
Forum: Seaplanes
02-10-2012, 10:45 AM
Replies: 5
Views: 1,129
Posted By raile

RE: 49 neptune value hobby motor to weight?

lupy, thank you and I am in Washington but on the other side of the mountains from ya near neport wa and all of my lakes are froze with snow on them so was thinking of a maiden this weekend off a...
Forum: Seaplanes
02-10-2012, 08:12 AM
Replies: 5
Views: 1,129
Posted By raile

49 neptune value hobby motor to weight?

Hello, just got done building my neptune 49 inch from value hobby and am concerned about my power combo. I used this combo from grayson hobby 500 / 600 Brushless Outrunner Motor & ESC (GH2814-6 450W...
Forum: ARF or RTF
01-10-2012, 07:59 AM
Replies: 2
Views: 1,102
Posted By raile

RE: Double TroubleP-51D Mustang 60 - 65.5

thank you firepower, 137 mm leading edge next to fuse lodge.
Forum: ARF or RTF
01-09-2012, 01:47 PM
Replies: 2
Views: 1,102
Posted By raile

Double TroubleP-51D Mustang 60 - 65.5" cg?

Can Some one tell me the cg of this plane? Double Trouble P-51D Mustang 60 - 65.5" Nitro Fuel Powered Radio Remote Controlled RC Warbird Airplane ARF from nitroplanes. and should this plane be upside...
Forum: Speed - Electric
12-06-2011, 02:20 PM
Replies: 3
Views: 469
Posted By raile

RE: stupid question im sure

ok so this does answer my question that i didnt really ask in my post. you can run lipos not being a brushless esc or motor? Worst case is to get a bigger esc? thank you very much
Forum: Speed - Electric
12-06-2011, 01:26 PM
Replies: 3
Views: 469
Posted By raile

stupid question im sure

hello, my son has a Apache Catamaran 2.4 EP RTR by Pro Boat that runs the 7.2 2200 mah batts. Can you you run 11.1 lipos in this and what do you have to do if so? Have alot of them for planes that...
Forum: Speed - RC Nitro Boats
12-04-2011, 12:27 PM
Replies: 7
Views: 1,459
Posted By raile

RE: best bang for buck on rtr

thanks for reply, so would this be better than say shockwave 36 or auacraft superv? i see the price is better. thanks
Forum: Speed - RC Nitro Boats
12-03-2011, 04:20 PM
Replies: 7
Views: 1,459
Posted By raile

best bang for buck on rtr

hello, want to buy a good v hull rtr nitro boat that can go in semi choppy water. whats the best deal out there right now and where? have lots a planes and trucks but dont know where to start on a...
Forum: Speed - Electric
04-21-2011, 10:42 AM
Replies: 4
Views: 925
Posted By raile

RE: Aquacraft rio offshore to brushless?

thank you but i had been through there and terms such as lipo 2 or 3 or 4 and 9000 kv or 2600 kv with 60 or 20 amp esc? Terms i just don't know, was just hoping for a good run of the mill set up?...
Forum: Speed - Electric
04-21-2011, 08:11 AM
Replies: 4
Views: 925
Posted By raile

Aquacraft rio offshore to brushless?

Hello, can somebody tell me the least expensive yet reliable way to convert the aquacraft rio to brushless and exactly what I need? Am into nitro not electric but my son wants this faster. Have basic...
Forum: RC Scale Aircraft
02-18-2007, 10:44 PM
Replies: 2
Views: 485
Posted By raile

p-51d Nitroplanes 60 Prop?

Hello,Purchased 60 arf p-51d from nitroplanes.com. Have .61 gms engine,can someone please advise on what size prop to run. Have 11/6 on it now but have not flown and do not know if it is sufficiant....
Forum: Seaplanes
02-12-2007, 05:55 PM
Replies: 26
Views: 4,267
Posted By raile

RE: new floats

hello, total rookie here but I built a couple sets of floats for my .40 trainer and great planes super sportster with advise from jimcasey in other thread. Tried covering in monkote and it worked ok,...
Forum: Seaplanes
12-15-2006, 12:24 PM
Replies: 3
Views: 1,127
Posted By raile

Float template?

hello, want to try building floats out of pink styrophoam. Does any body have a template that I could print in a couple of pages to trace? Am not very good @ drawing. Am building them for a 40 class...
Forum: Seaplanes
12-13-2006, 06:31 PM
Replies: 10
Views: 1,280
Posted By raile

RE: Hobico 40 trainer&Floats- Dives left?

Thanks for all info first off and yes the floats being to far forward did cause this. I moved them back so step is behind cg 1 inch and plane flew fine, allot different than with wheels but no more...
Forum: Seaplanes
12-12-2006, 03:37 PM
Replies: 10
Views: 1,280
Posted By raile

RE: Hobico 40 trainer&Floats- Dives left?

sorry about spelling, yes ailerons. Am Flying on snow so no water in floats and it floats well in my hot tub with no leaks. I have checked everything you have suggested plus weighed floats separately...
Forum: Seaplanes
12-12-2006, 01:15 PM
Replies: 10
Views: 1,280
Posted By raile

RE: Hobico 40 trainer&Floats- Dives left?

thanks for info, My instructions said to install step 1/4 inch in front of cg, If you are saying an inch behind cg that would make a big difference right? jrf- I could not even keep plane in air...
Forum: Seaplanes
12-11-2006, 07:07 PM
Replies: 10
Views: 1,280
Posted By raile

Hobico 40 trainer&Floats- Dives left?

New to the Float world but have flown trainers alot and some low wing models. Put a set of us aircore floats on this hobico 40 trainer and am useing it on snow. Followed all recomondations from this...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
08-15-2006, 12:33 PM
Replies: 29
Views: 4,314
Posted By raile

RE: Upgrade motor on a "bonzer" 1/10 truck

hello, upgraded my bonzer with a reedy 19 turn motor and Duratrax intellispeed controll. Was told this speed controll was fine for that motor but truck just rips for about three minutes and...
Forum: RC 1/8th Scale Buggies
08-10-2006, 08:58 AM
Replies: 0
Views: 358
Posted By raile

Himoto Syclone Gears

Just Bought One of these single speed Himoto Syclone Buggy (HI801) and after reading here does not sound that great. What gears should I order just for back up, and what should I do befor running it?...
Forum: RC Car General Discussions
08-09-2006, 07:48 PM
Replies: 0
Views: 298
Posted By raile

10% nitro in himoto buggy?

Maybe dumb question, But have 5 gallons of 10% nitro for my planes and am new to cars. Says to use 20% nitro in the himoto buggies, will the 10% hurt anything. Thanks in advance
Showing results 1 to 25 of 34
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.