RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: mscj-RCU
Showing results 1 to 25 of 36
Search took 0.68 seconds.
Forum: RC Flight Simulator Software
11-13-2003, 09:59 PM
Replies: 1
Views: 434
Posted By mscj-RCU

RE: can't control heli in fms

nevermind....figured out to set the bottom 4 channels in the config scren-works now.
Forum: RC Flight Simulator Software
11-13-2003, 09:26 PM
Replies: 1
Views: 434
Posted By mscj-RCU

can't control heli in fms

I can't control the helicopters in fms....my cable isn't working right now, so I'm using a joystick-throttle doesn't seem to work, can't get off the ground. Any ideas?
Forum: Foamies! - RC Electric Foam Aircraft
08-05-2003, 06:39 PM
Replies: 93
Views: 13,052
Posted By mscj-RCU

280BB in 300C gearbox

Greg--does that 280BB bolt right in the 300C gearbox without mods?
Forum: Batteries & Chargers
07-25-2003, 03:21 PM
Replies: 6
Views: 742
Posted By mscj-RCU

should I trust this pack?

I had used these cells in a digital camers for a while-maybe 10 charges on them. The last time I charged them, I think they hit 105 degrees-it was 90-95 ambient temp at the time. I'll try the 6...
Forum: Batteries & Chargers
07-25-2003, 02:48 PM
Replies: 6
Views: 742
Posted By mscj-RCU

should I trust this pack?

A few days ago, I soldered 4 1600 nimh Panasonic cells into a receiver pack for my glow plane, charged at 140 ma for about 14 hrs, then cycled them on my Triton. The pack wouldn't peak, even after...
Forum: Electric General Discussion
05-28-2003, 01:23 PM
Replies: 3
Views: 723
Posted By mscj-RCU

mega 16/15 gearbox?

will the 16/15 series fit in any 480 sized gearbox?
Forum: Batteries & Chargers
12-17-2002, 10:08 PM
Replies: 18
Views: 1,565
Posted By mscj-RCU

triton charger anywhere?

Thanks Raydee! Ordered it from Marc this morning--$124 plus shipping, hopefully have it by the weekend! BTW, HobbyTown wanted $149 and wouldn't ship to boot.
Forum: Batteries & Chargers
12-17-2002, 01:33 AM
Replies: 18
Views: 1,565
Posted By mscj-RCU

triton charger anywhere?

anyone know where a triton charger is in stock???
Forum: Glow Engines
09-19-2002, 01:09 AM
Replies: 5
Views: 769
Posted By mscj-RCU

Prop for MDS .58

what kind of rpm's do you get with the 13x4? Mine pulls 12900 on an apc 11.5x4 and 11900 on a 12.25x3.75...always in the quest for more thrust.
Forum: 3D Flying!
09-09-2002, 08:25 PM
Replies: 4
Views: 659
Posted By mscj-RCU

aerobatic and 3d help

I'm looking to learn some aerobatics and try some 3d maneuvers--I've found some basic descriptions of the moves, but are there any sites that spell it out for you---radio stick movements, etc that...
Forum: ARF or RTF
08-02-2002, 12:57 AM
Replies: 15
Views: 1,574
Posted By mscj-RCU

ultra stick wing dowels burning???

I took some advice from a couple of your posts-reinforced bulkhead with lite ply-epoxied in, filled in grooves in dowels and used heat shrink over them. Maybe try it this weekend-thanks for the...
Forum: ARF or RTF
07-31-2002, 01:46 AM
Replies: 15
Views: 1,574
Posted By mscj-RCU

ultra stick wing dowels burning???

wrung out my ultra stick 40 last nite-got pretty wild with it (plane only has maybe 10 flights on it, tame ones until the 2 tonite)-after removing wing, I noticed the dowels looked burned on top with...
Forum: The Clubhouse
07-26-2002, 11:09 PM
Replies: 1
Views: 471
Posted By mscj-RCU

control line wingmaster???

Anyone ever heard of a control line kit called a Wingmaster? Probably from the early to mid eighties-just curious as to what it looks like, specs, etc-a person I work with says he has a new in box...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-10-2002, 11:43 AM
Replies: 2
Views: 379
Posted By mscj-RCU

charging transmitter battery

Sorry-radio is a Hitec Eclipse 7.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-10-2002, 01:12 AM
Replies: 2
Views: 379
Posted By mscj-RCU

charging transmitter battery

can a peak charger be used to charge the transmitter battery while it's in the radio? I know heat is an issue, but will the diode interfere with the charger? Thanks, Mike.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-03-2002, 02:19 PM
Replies: 3
Views: 658
Posted By mscj-RCU

Eclipse 7 spoilerons and flaperons

you can mix in spoilerons with the channel 7 switch-use a p-mix (4 or 5 if I remember right) with master ch 7 and slave ch 1 (assuming you have your wing servos on 1 and 6) and adjust the spoileron...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-03-2002, 02:14 PM
Replies: 3
Views: 602
Posted By mscj-RCU

Hitec glitches/full travel?

I have an ultra stick 40 with hitec servos in the wing-problem is that one of the aileron servos goes full travel in the air-can't tell which one, plane starts a rapid aileron roll on its own, does 3...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-27-2002, 09:13 PM
Replies: 4
Views: 620
Posted By mscj-RCU

eclipse and negative shift

Tried it with a fairly new Futaba receiver last nite-worked fine. I think I'm done with the feather-it was the only neg shift receiver I had.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-26-2002, 09:50 PM
Replies: 4
Views: 620
Posted By mscj-RCU

eclipse and negative shift

anyone had any trouble with their eclipse and negative shift receivers? I have only used positive shift until recently-now I've tried 2 brand new feather receivers, and they both glitch badly, along...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
06-23-2002, 11:17 PM
Replies: 1
Views: 683
Posted By mscj-RCU

eclipse-feather glitching

I have an Eclipse with spectra and a feather receiver-my problem is the feather's servos glitch when the radio is on-not when it is turned off-so that eliminates a noisy environment. Also, the glitch...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
06-20-2002, 01:03 AM
Replies: 2
Views: 745
Posted By mscj-RCU

Crow feature

Found this on googlegroups--

quote:
I put the ailerons on channels 1 and 6. The flaps are on channel 5 (the gear channel). You must have flaperons enabled and you also need both channel 1 and 6...
Forum: ARF or RTF
06-08-2002, 12:26 PM
Replies: 3
Views: 641
Posted By mscj-RCU

ultra stick antenna routing?

How have you done yours? I just finished installing engine and radio, now I can't decide on how to run the antenna wire. Suggestions please! Thanks, Mike.
Forum: Glow Engines
06-01-2002, 10:39 PM
Replies: 3
Views: 491
Posted By mscj-RCU

stripped threads

stripped 2 of the head bolt threads on my engine today-any way to fix them?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-19-2002, 01:15 AM
Replies: 1
Views: 395
Posted By mscj-RCU

Hitec screws & stuff

www.servocity.com has them-about a buck fifty for mounting hardware kit-comes with screws and servo arms. you may have to call them-they may not be listed on the site.
Forum: ARF or RTF
05-02-2002, 01:43 AM
Replies: 7
Views: 1,012
Posted By mscj-RCU

servos don't fit in wing

Width of servos is greater than the width of the opening in the wood frame of the wing. Length appears 1 or 2/1000 small, but I'm not too worried about that since there is only sheeting at the front...
Showing results 1 to 25 of 36
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.