RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: Littl3TuffGuy13
Showing results 1 to 25 of 394
Search took 0.56 seconds.
Replies: 1
Views: 373
Posted By Littl3TuffGuy13

RC10T4 and 2s lipos

I was curious if anyone knows if these 2s 5200mah 30c will fit in the RC10T4 tray because I have some 3s that are too wide. These are about 4MM smaller.
Replies: 4
Views: 2,473
Posted By Littl3TuffGuy13

RE: Traxxas slash 2x4, how big of a batt??

Get some 2S lipos from hobbycity/hobbyking you can buy one for around 30 bucks or less. The ones I'm looking at are 23$ 5200mah hardcase. They will run atleast 30 minutes or more depending on...
Replies: 4
Views: 677
Posted By Littl3TuffGuy13

RE: Zippy Lipos Swelling

Yea, they get charged at 4 amps. And the way I have it in my T4 it bounces out of place so there is probably my problem. I might be getting some 2s hardcase anyways to fit the T4 cause then i can...
Replies: 4
Views: 677
Posted By Littl3TuffGuy13

Zippy Lipos Swelling

I have 3s 5000mah 30c lipos in my T4 and They don't fit so they are sitting up right with a rubber band holding them down. Well one of my batteries started swelling the other day. Is this because...
Replies: 12
Views: 1,144
Posted By Littl3TuffGuy13

RE: Castle Creations Systems

Go with the 4600kv with whichever you chose because you will run into less heat problems, It is easy to gear up.
Replies: 15
Views: 7,113
Posted By Littl3TuffGuy13

RE: Slash 2wd LiPo question

I was in the same situation, looking to upgrade to Lipo. I went with 3s (Run sidewinder VXL combo) And I grin every time when i slap in the 3s, but it is pretty rediculous. My friend uses 2s and...
Replies: 11
Views: 927
Posted By Littl3TuffGuy13

RE: Motor/ESC Temps.

Okay tried 14t pinion and after idk 15-20 minutes of hard driving with sand pandles esc was 164F and VXL at 180 i think. I think its because I may have burned out the VXL a while ago, but It still...
Replies: 11
Views: 927
Posted By Littl3TuffGuy13

RE: Motor/ESC Temps.

I geared it with a 23t pinion and it got up to 180F pretty quick so I went to 18 and it still ran around 170 so I went down to 14t and it was around 140F running pretty hard, but I am going to run it...
Replies: 11
Views: 927
Posted By Littl3TuffGuy13

Motor/ESC Temps.

I was running my RC10T4 today geared with a 16t pinion and stock spur (Don't know what the spur is) My motor got up to 172F, and ESC up to 180F. I was running Sidewinder/Velineon combo and a 3s...
Replies: 20,623
Views: 1,300,935
Posted By Littl3TuffGuy13

RE: The Evader Coalition ~ T.E.C.

So ever since i got the lightened hard anodized slipper plates i have been burning through the slipper pads. At tower it says the blue ones are for the hard anodized so i get the blue ones, but I'm...
Replies: 19
Views: 3,502
Posted By Littl3TuffGuy13

RE: Burnt up VXL motor

Well now im just running at home which is what 99% of my driving is. I ran today at 23/90 and ESC AND Motor both got to 180F and i stopped to let it cool. So now im going to go back down and see...
Replies: 19
Views: 3,502
Posted By Littl3TuffGuy13

RE: Burnt up VXL motor

I tried 23/90 again and it seemed like it heated up faster than 16/90. At 16/90 it hit 170 maybe 10-15 minutes into the run running pretty hard. I ran 23/90 and i was running really lightly cause...
Replies: 19
Views: 3,502
Posted By Littl3TuffGuy13

RE: Burnt up VXL motor

So i was actually fine running 23/90 more than 18/90? Cause i dropped it even lower recently and been running 16/90 (reason i have a 90 spur gear is cause i used to have a castle 5700 that i burnt...
Replies: 19
Views: 3,502
Posted By Littl3TuffGuy13

Burnt up VXL motor

So I went to a track for my first time today. It was indoor and I left my Slash set at 23/90 and around 10 minutes into the run i remembered, so i pulled it off the track and checked the temp and it...
Replies: 3,214
Views: 431,770
Posted By Littl3TuffGuy13

RE: The Official Traxxas Slash short-course race truck

Took the slash out to play today with my 3s lipo. I set up a ramp to jump into the snow/grass. First jump was around half throttle pretty casual. My second jump I gained some confidence and got...
Replies: 5
Views: 548
Posted By Littl3TuffGuy13

RE: Sidewinder Problems

It's booting up more now, but still starts hittin the throttle on its own. I think i remember this before, just had to wait it out, there must be some moisture causing some problems that drys up...
Replies: 5
Views: 548
Posted By Littl3TuffGuy13

Sidewinder Problems

So I'm at my grandma's house and there are some power lines around, I seemed to be having frequency problems. I went out for my 3rd run playing in the snow and It started tweaking out more and...
Replies: 14
Views: 38,455
Posted By Littl3TuffGuy13

RE: Spur/pinion gear question .

If you increase both it wont really change much you can't gain both at the same time.
Replies: 11
Views: 4,306
Posted By Littl3TuffGuy13

RE: Stampede Axle Stub breakage

I just put MIP's CVD's today, quick and easy. They seem to run real smooth too.
Replies: 6
Views: 656
Posted By Littl3TuffGuy13

RE: VXL or SIDE WINDER????

I run Sidewinder/VXL motor and I love it. I already burned up a 5700 with 7-cells but it was hot outside and i think i was geared a bit high (didn't have a temp gauge then), plus it was in my slash.
Replies: 14
Views: 6,935
Posted By Littl3TuffGuy13

RE: A beginners impression of the Traxxas Rustler XL5

Well now you have a really awesome XL-5, but I would have suggested the Mamba Max Pro 5700 or normal max cause you can use 3s or sidewinder with 4600.
Replies: 16
Views: 6,060
Posted By Littl3TuffGuy13

RE: castle creations sidewinder 5700kv?

I run Sidewinder/VXL motor and its awesome, only reason im using the vxl motor is because I run a slash and I had heat problems with the 5700kv, but that was probably my fault. I didn't have a...
Replies: 16
Views: 6,060
Posted By Littl3TuffGuy13

RE: castle creations sidewinder 5700kv?

Get the Sidewidner/4600kv combo.
Replies: 3,214
Views: 431,770
Posted By Littl3TuffGuy13

RE: The Official Traxxas Slash short-course race truck

Can anyone link me Non progressive springs for the front and back of my slash? I found these
Back?
Front
The back ones don't have any details about which model they fit, but the front ones...
Replies: 21
Views: 1,378
Posted By Littl3TuffGuy13

RE: Thinking about getting some Lipo's

Turnigy and Flightmax are very trust able battery packs.
Showing results 1 to 25 of 394
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.