RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: dave0955
Showing results 1 to 25 of 25
Search took 0.44 seconds.
Forum: RC Scale Aircraft
04-27-2013, 09:18 PM
Replies: 7
Views: 1,895
Posted By dave0955

RE: OS 65 LA or Ax?

If you go for the AX line, which IMHO is the better line, go with the 75AX. I put my 75AX in H9 P-51 PTS, was a blast until I cranked the ailerons up (cheap H9 servos) and stripped one on a high...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
09-14-2011, 07:54 PM
Replies: 6
Views: 13,486
Posted By dave0955

RE: DX6i switch replacement

Hahaha, I just lost the Tumb Wheel on my DX6i. Cant access the menu.
So I call Horizon Hobby to purchase a new button\wheel. No way they say, have to send the radio in for service.
Uh, no,...
Forum: Gas Engines
12-14-2010, 01:56 PM
Replies: 19
Views: 3,190
Posted By dave0955

RE: 160fx gas Equivalent

Go with the Syssa for tight cowl spacing and power.
I could not find anything outside the world of nitro or electric to cleanly cowl my KMP PC-9 until I found the Syssa. Tried the DLE-30, couldn't...
Forum: Gas Engines
10-19-2010, 11:30 AM
Replies: 16
Views: 4,303
Posted By dave0955

RE: INFO RE A AEROVATE 20 CC ENGINE

captinjohn said: well my thought is look this data up yourself before SRARTING a new thread. Not just you....everyone should do a serach before starting a new thread.

Take it easy there capt'n....
Forum: Giant Scale Aircraft - 3D & Aerobatic
09-12-2010, 07:30 PM
Replies: 7
Views: 2,949
Posted By dave0955

RE: Pilot 30cc SBACH with DLE 30 question

I purchased the 30cc Sbach 342 from RedwingRC and I am using the DLE 30.

http://www.redwingrc.com/planes/sbach.html

I have version 1 of the DLE 30 but I bought the rear carb conversion kit...
Forum: ARF or RTF
11-27-2009, 05:11 PM
Replies: 35
Views: 10,689
Posted By dave0955

RE: NEW Seagull Dewoitine ARF ?

Hope its large enough
Forum: ARF or RTF
11-27-2009, 01:37 AM
Replies: 35
Views: 10,689
Posted By dave0955

RE: NEW Seagull Dewoitine ARF ?

Yeah, how do I upload the photo???
Forum: ARF or RTF
11-25-2009, 02:38 PM
Replies: 35
Views: 10,689
Posted By dave0955

RE: NEW Seagull Dewoitine ARF ?

I have the Seagull 40 sized PC-9. I put an OS 55AX in it and 12 x 6 APC prop. It really performs with this combination.
Fantastic little plane and always gets lots of attention and compliments at...
Forum: ARF or RTF
11-24-2009, 02:37 PM
Replies: 35
Views: 10,689
Posted By dave0955

RE: NEW Seagull Dewoitine ARF ?

I've been after the PC-9 120 with the Dewoitine a close 2nd thought.
Both planes are available in the UK however shipping is very expensive, to the point where its almost prohibitive unless you...
Forum: RCV Engines Support
08-20-2008, 10:33 PM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

No, RCV had nothing to say after the repair.
They suspected the timing when the problems started, and had BJ's get in touch.
BJ's did a great job updating the engine. Not like an old leaky...
Forum: RCV Engines Support
08-05-2008, 03:22 PM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

Well, got the 60SP back almost month and a half ago [:-]. Completely upgraded to the latest 60SP specifications. Sure looks good :D.
Anyway, the railway has been taking up all my time [:@] so I...
Forum: RCV Engines Support
05-29-2008, 12:09 PM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

Hi guys, thanks for all the input.
Fuel is good, not to old, glow is good and I am using a remote glow starter, no problem with the circuit.
Hahaha, as far as starting it backwards, nope, I have...
Forum: RCV Engines Support
05-28-2008, 08:25 AM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

Yes lots of compression, the problem is not compression and as I said, there are no blockages, 125psi of compressed air took take care of any chances of that. Fully inspected prior to blowing it out...
Forum: RCV Engines Support
05-28-2008, 02:13 AM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

Steph, I'll check the timing on the engine, pretty much the only thing I havent done yet. I'll let you know the results.
Out of curiosity, on a new engine with less than 2 gallons thru it, how and...
Forum: RCV Engines Support
05-28-2008, 02:07 AM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ****!!!

Thanks for the input.
Took the carb apart today (3rd time now), checked it over for blockages etc..., nil found. Reset the idle needle.
Mounted it on the engine stand and tried everything I...
Forum: RCV Engines Support
05-27-2008, 12:28 AM
Replies: 17
Views: 4,368
Posted By dave0955

RE: rcv60 sp ***!!!

Good idea and I did try that prior to posting the prob. Thanks for the input though, much appreciated.
Forum: RCV Engines Support
05-26-2008, 09:57 PM
Replies: 17
Views: 4,368
Posted By dave0955

rcv60 sp ***!!!

Not sure what the hell is wrong with this motor but I'm about finished with the aggravation already.
Went from running like a champ (for a short short time) to unable to start in less than a year. ...
Forum: RC Warbirds and Warplanes
02-29-2008, 09:17 PM
Replies: 229
Views: 61,153
Posted By dave0955

RE: KMP NEW A1 Skyraider - pics

Right on, thanks for the info Andrew.
I'll have a look at the Fuji24
Forum: RC Warbirds and Warplanes
02-29-2008, 12:39 AM
Replies: 229
Views: 61,153
Posted By dave0955

RE: KMP NEW A1 Skyraider - pics

Hi Andrew, I'm planning on buying the A1 very shortly.
For clarification on engine choice, will the cowling in the Skyraider house the Zenoah G26ei or would a different engine choice such as the...
Forum: RC Warbirds and Warplanes
02-26-2008, 02:19 AM
Replies: 229
Views: 61,153
Posted By dave0955

RE: KMP NEW A1 Skyraider - pics

Hmmm, according to Horizonhobby, the Zenoah G26ei has mounting dimensions of 180mm x 193mm x 181mm.
To put that into inches it would be: 7.08 x 7.59 x 7.12
However, if wanting to keep the...
Forum: RC Warbirds and Warplanes
02-03-2008, 03:35 AM
Replies: 229
Views: 61,153
Posted By dave0955

RE: KMP NEW A1 Skyraider - pics

6.5 inches if I recall correctly.
Im planning on using a Zenoah G26EI in this or a Saito 1.80 Still debating.
Was told via e-mail by KMP the cowling would fit either one, but that the Zenoah...
Forum: Beginners
11-03-2007, 06:53 PM
Replies: 5
Views: 659
Posted By dave0955

RE: Hanger 9 F-22 PTS

Take of the progressive training gear, add the Evo 52NT with an 11 x 7 2 blade prop and this plane will not bore you.

Still, as a second plane, I'd recomened something different. Something along...
Forum: RC Warbirds and Warplanes
10-24-2007, 09:38 PM
Replies: 117
Views: 33,267
Posted By dave0955

RE: cmp p47 thunderbolt

Well, from what I've read the 3'' CG should be fine. Variable is the weight of the motor you use.
I've decided to use the OS 75AX on my P-47. Pretty damn close in power and the same weight as the...
Forum: RC Warbirds and Warplanes
10-19-2007, 12:14 AM
Replies: 117
Views: 33,267
Posted By dave0955

RE: cmp p47 thunderbolt

Ok, read lots here on the 40 size P-47.
I have an Evolution engine I'm pondering using from the Hangar 9 F-22 Raptor PTS. Dropped a 52 into the raptor. Anyway, motor is the EVO100 and is pretty...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.