RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: RONW
Showing results 1 to 25 of 86
Search took 0.73 seconds.
Forum: KingTech Turbines International
12-09-2017, 05:28 PM
Replies: 1
Views: 930
Posted By RONW

PC software V2 ECU

Hello can anyone please tell me if the Xicoy software and connection cable is compatible with the new Kingtech V2 ECU.
Thanks Ron
Forum: JR Radio & Spektrum Radios
11-09-2017, 08:56 PM
Replies: 1
Views: 1,230
Posted By RONW

Adidas123 You should be able to select any mode...

Adidas123
You should be able to select any mode you wish according to my manual. The physical change will be to change the throttle from mode 2 to mode 1 (page 39) as in the manual which puts the...
Forum: Jet Central Turbines - Artes Jet
11-06-2017, 05:02 PM
Replies: 10
Views: 2,573
Posted By RONW

Redtail Probably a stupid question but are you...

Redtail
Probably a stupid question but are you using the A123 3S setting to charge?
Forum: KingTech Turbines International
11-02-2017, 04:19 PM
Replies: 1
Views: 1,028
Posted By RONW

K80 cuts at idle 'low RPM'

Hi has anyone had this issue. My K80 (V2 ECU) with about 35 starts and 3 hours running cuts out after about 10 seconds at idle showing low RPM, no problem at higher RPM.
Turbine battery is 3S...
Forum: RC Jets
10-20-2017, 07:22 PM
Replies: 1,970
Views: 378,153
Posted By RONW

I am pretty sure they changed or extended the...

I am pretty sure they changed or extended the inlet duct at some stage (maybe when they offered the full turbine ducting kit) from when the manual was produced which does not leave enough room to...
Forum: KingTech Turbines International
10-12-2017, 05:42 PM
Replies: 3
Views: 1,685
Posted By RONW

I cannot understand why I have not received a...

I cannot understand why I have not received a response for my question about the missing Battery used display in the new ECU which the manual says is in the 'Info' menu same as in the Xicoy ECU's....
Forum: KingTech Turbines International
10-07-2017, 04:09 PM
Replies: 3
Views: 1,685
Posted By RONW

V2 ECU 'Info' Battery used

Barry, Cannot find any previous posts on this so here goes.

The V2 manual on page 21 states

'Also, we recommend you reset the battery used value to zero using the GSU. Go to the menu item...
Forum: JetCat Turbine Direct Support
08-21-2017, 02:22 PM
Replies: 2
Views: 1,381
Posted By RONW

Thanks rg that seemed to have done the trick as...

Thanks rg that seemed to have done the trick as the program now brings up the find file window and I am able to load it.
I did not expect it to work until the DAO350.DLL file got registered so Win7...
Forum: JetCat Turbine Direct Support
08-20-2017, 07:29 PM
Replies: 2
Views: 1,381
Posted By RONW

Jet Tronic software

I have a problem with this software on my new Win10 system. I use the older serial cable.
When installing I get an error message 'unable to register DAO350.DLL', by ignoring the message the...
Forum: KingTech Turbines International
11-13-2016, 01:48 PM
Replies: 41
Views: 7,002
Posted By RONW

Can anyone tell me where the battery used...

Can anyone tell me where the battery used information is stored and if and how it can be reset after a battery charge, talking about the new ECU here?
I am told it is in the 'info' menu but I cannot...
Forum: Batteries & Chargers
09-16-2016, 05:38 PM
Replies: 11
Views: 2,133
Posted By RONW

I am getting the blue screen 'kernell security...

I am getting the blue screen 'kernell security error' followed by shut down when using Hyperion control and dats suit PC software running Win10
I have the EOS 720i super duo with latest firmware and...
Forum: RC Jets
09-13-2016, 08:24 PM
Replies: 678
Views: 173,608
Posted By RONW

Hi Dave Yes it is the std or mid size...

Hi Dave

Yes it is the std or mid size Xcalibur. Yes I did contact the retailer and he was as mystified as I was and had not heard of this problem.
While I did manage to overcome the issues I am...
Forum: RC Jets
09-12-2016, 04:10 PM
Replies: 678
Views: 173,608
Posted By RONW

I had a few small issues with my Xcalibur sports...

I had a few small issues with my Xcalibur sports jet and despite two email to Ripmax they were both totally ignored.
My issues are centered around the wing clamp bolts supplies which were M5 x 25mm...
Forum: RC Jets
09-09-2016, 03:56 PM
Replies: 271
Views: 54,632
Posted By RONW

Yes that is for the pump battery. What I need to...

Yes that is for the pump battery. What I need to know is the allowed voltage range into the ECU throttle port from the receiver. I plan to power the receiver with 7.4V which means that voltage will...
Forum: RC Jets
09-08-2016, 05:49 PM
Replies: 271
Views: 54,632
Posted By RONW

Does anybody know the voltage range of the new...

Does anybody know the voltage range of the new ECU. This is the receiver voltage I am asking about.

Ron
Forum: JR Radio & Spektrum Radios
08-29-2016, 03:08 PM
Replies: 15
Views: 6,794
Posted By RONW

Tom No it started with the flap servo which was...

Tom
No it started with the flap servo which was connected to a PC4 harness which I began to think was faulty so I replaced that harness with another CV4 harness. I have not seen the flap servo go...
Forum: JR Radio & Spektrum Radios
08-28-2016, 04:34 PM
Replies: 15
Views: 6,794
Posted By RONW

X bus occasionally losing servo

Hi Chaps
I have some experience with X bus but have a strange problem with my latest setup and wonder if anyone else has experienced similar failures.
Problem: Occasionally when powering up the...
Forum: RC Jets
03-03-2016, 04:44 PM
Replies: 26
Views: 8,105
Posted By RONW

Hi Roger. I cannot remember if I discussed this...

Hi Roger. I cannot remember if I discussed this issue with you at Tokoroa but thanks for the link as it confirmed how the hinging is finished at the factory. As the commentary says the builder must...
Forum: RC Jets
02-29-2016, 03:53 PM
Replies: 26
Views: 8,105
Posted By RONW

Any issues with so called 'live hinging'

I am curious to know if anybody has had any failures with 'live hinging' such as found on CARF and Skymaster models?
Also I would like to know how exactly how the hinge is constructed. Is the hinge...
Forum: RC Jets
02-28-2016, 05:10 PM
Replies: 12
Views: 1,831
Posted By RONW

Skymaster 5.5 Hawk weight

I would like to collect a few weights for comparison reasons on the Skymaster 5.5 Hawk, ready to fly less fuel.
Also any wing loading figures and wing area will be much appreciated.............Ron
Forum: RC Jets
09-05-2015, 03:16 PM
Replies: 9
Views: 2,547
Posted By RONW

Thanks Kim for these facts. I am only doing an...

Thanks Kim for these facts.
I am only doing an inspection of the model as it is already finished and twin 140's installed with twin pipes.
The model has been really beefed up and now has a big...
Forum: RC Jets
08-28-2015, 05:54 PM
Replies: 9
Views: 2,547
Posted By RONW

Byron F15 turbine conversion

Found some really old posts on this subject so I thought I would start a new thread!
I am interested in gaining any information on converting a Byron F15 to twin turbines, 2 x Kingtech 140's.
What...
Forum: RC Jets
08-28-2015, 05:50 PM
Replies: 8
Views: 2,100
Posted By RONW

Hi Mick I hope you are still watching this...

Hi Mick

I hope you are still watching this thread, or anyone else with first hand experience on this subject, as I am interested in gaining any information on converting a Byron F15 to twin...
Forum: JetCat Turbine Direct Support
01-24-2015, 05:53 PM
Replies: 1
Views: 1,575
Posted By RONW

P120 not reaching full RPM

Hi, I have been reading posts on similar problems. My P120 will not reach the 123K commanded, it only gets to 115K. The turbine was returned from JetCat Germany in this condition.
Have done plenty...
Forum: RC Jets
07-19-2014, 06:35 PM
Replies: 1,970
Views: 378,153
Posted By RONW

[QUOTE=blackcat;4866687]to joe and chris, yes it...

[QUOTE=blackcat;4866687]to joe and chris, yes it came with ducting and bypass, which i always use (space permitting),

Hi Dave and Blackcat
I have a query about fuel tank placement with this model...
Showing results 1 to 25 of 86
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.