RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: milkman-RCU
Showing results 1 to 25 of 101
Search took 0.70 seconds.
Forum: RC Scale Aircraft
11-27-2005, 06:07 PM
Replies: 4
Views: 903
Posted By milkman-RCU

RE: Looking for Unionville 6' Beaver Plans

I have the plans (and the finished plane), but don't recall any rib templates that were part of the wing plans. Since the wing is constant cord, can you not make a tracing from the ribs that are...
Forum: Glow Engines
10-26-2005, 06:57 PM
Replies: 9
Views: 1,143
Posted By milkman-RCU

RE: ST 90 Muffler

I have the Slimline Large Volume Pitts on both a ST90 and ST75. I think they are the best solution for the ST 60-90 range. The Slimline model is #6002. The package says it is for the ST90, but...
Forum: ARF or RTF
10-15-2005, 10:30 PM
Replies: 1,245
Views: 205,591
Posted By milkman-RCU

RE: H9 60 Size P-47 Thunderbolt-Build & Flying

Nemesis -

I am using the GP mount with a ST-75 and the TF in-cowl muffler. I found the supplied mount would not work with the ST without modification, so I just used the GP mounts that I have...
Forum: ARF or RTF
10-10-2005, 09:14 PM
Replies: 13
Views: 3,419
Posted By milkman-RCU

RE: Seagull "Zero Fighter"?

I have been flying the Seagull Zero for two seasons. I put a TT 46 in mine and it pulls it real nice. I did use all the stock hardware, but there have been several warnings about the brittle clevis...
Forum: ARF or RTF
10-07-2005, 07:54 AM
Replies: 1,245
Views: 205,591
Posted By milkman-RCU

RE: H9 60 Size P-47 Thunderbolt-Build & Flying

Not much activity on this new ARF from H9? I picked mine up past night and I agree the covering job is great, not one wrinkle. I have no previous experience with H9 ARF's, but have read enough to...
Forum: "1/2 A" & "1/8 A" airplanes
09-17-2005, 09:29 PM
Replies: 7
Views: 586
Posted By milkman-RCU

RE: Berg receiver

As I understand, Berg was purchased by Castle Creations and they will be re-introducing the receivers soon. I believe they are going to be even smaller. I am waiting for these as well as the new...
Forum: RC Sailboats
07-26-2005, 09:34 PM
Replies: 10
Views: 1,504
Posted By milkman-RCU

RE: CR914

Hey Andy!

Did not notice your location on your post, small world.
I am on vaction up here in the Boston area and visited Marblehead and Redd's Pond where they race CR-914's.


Joel
Forum: RC Sailboats
07-25-2005, 09:13 PM
Replies: 10
Views: 1,504
Posted By milkman-RCU

RE: CR914

I just bought a CR-914 and joined a sailing club in Columbia, MO. Attached is a picture off the M3SC website of my boat, "Nick of Time" #1265 rounding the mark in my first race! Great boat and a...
Forum: Events, Shows and Fun Flys - Airplanes
07-14-2005, 10:19 PM
Replies: 2
Views: 1,782
Posted By milkman-RCU

RE: CAF Warbird Expo July 16/17 2005 9-5 New Century, Olathe NAS, KS.

The link includes the period at the end of .org

Delete the period to get the link to open.

Looking forward to being there on Sunday.
Forum: RC Warbirds and Warplanes
04-02-2005, 09:35 AM
Replies: 2,442
Views: 444,142
Posted By milkman-RCU

RE: CMP Hellcat

Where is everyone finding the best deal on the CMP Hellcat. I have seen them several places, but it seems all of the sources have their "stories" to go along with the service. Any good reliable...
Forum: ARF or RTF
03-30-2005, 08:55 PM
Replies: 3
Views: 939
Posted By milkman-RCU

RE: Seagull Zero

http://www.rcuniverse.com/forum/m_1366941/anchors_1366941/mpage_1/key_Seagull%252CZero/anchor/tm.htm

Try this thread. There is extensive discussion about the CG.

Mine flew fine with the...
Forum: RC Warbirds and Warplanes
03-30-2005, 06:43 PM
Replies: 41
Views: 6,578
Posted By milkman-RCU

RE: robart is making spring air type retracts

Does anyone know the scoop on these new Robart retracts. Did they license the product from Spring Air or did Spring Air's patent expire? Seems odd that these showed up marketed by Robart?
Forum: Glow Engines
03-21-2005, 11:37 PM
Replies: 55
Views: 6,023
Posted By milkman-RCU

RE: Super Tiger G51 should I return it??

Thanks for the feedback. Its just nice to know what RPM's you should be expecting out of a motor / prop combination.

Thanks for the help.
Forum: Glow Engines
03-21-2005, 12:02 AM
Replies: 55
Views: 6,023
Posted By milkman-RCU

RE: Super Tiger G51 should I return it??

Thanks for the feedback. I ran three tanks through at a rich setting before I leaned it out with the pinch method described in the manual. I had a MA Black prop on for break in.

Seems to idle...
Forum: Glow Engines
03-20-2005, 06:45 PM
Replies: 55
Views: 6,023
Posted By milkman-RCU

RE: Super Tiger G51 should I return it??

Dar -

I just broke my ST 51 in on a test stand this weekend with an 11x6 prop. By the third tank of gas and going thru the setting of the high end needle, I was turing 13,750 rpm. Before I got...
Forum: Glow Engines
03-15-2005, 07:53 PM
Replies: 55
Views: 6,023
Posted By milkman-RCU

RE: Super Tiger G51 should I return it??

You are both correct. I just bought a new ST 51 (China version) within the last three weeks. The manual shows a 11x6 as the largest recommended prop. The older Italian manual like the one scanned...
Forum: Kit Building
02-06-2005, 04:53 PM
Replies: 740
Views: 170,398
Posted By milkman-RCU

RE: Sig Hog Bipe Build

As you move to the fin/rudder and the stab/elevator, I will give you a caution on the pre-shaped tapered balsa for the elevator and rudder. The three pieces all look alike, but the one for the...
Forum: RC Warbirds and Warplanes
01-29-2005, 12:07 PM
Replies: 5
Views: 687
Posted By milkman-RCU

RE: Inverted pitts mufflers

Here is a link to the J'Tec site that has mufflers for inverted applications. I plan to use one on my ST 90 in a TF P-47.
http://www.jtecrc.com/mufflers-01.htm
Forum: RC Warbirds and Warplanes
01-21-2005, 10:14 PM
Replies: 16
Views: 1,032
Posted By milkman-RCU

RE: which retracts for .60 TF P-47

I had found the Spring Air struts, but they say they are "New" and I don't recall anyone mentioning exerience with Spring Air struts. Just wondered it they were comparable to the Robart. They are...
Forum: RC Warbirds and Warplanes
01-21-2005, 06:28 PM
Replies: 16
Views: 1,032
Posted By milkman-RCU

RE: which retracts for .60 TF P-47

Excellent choice!

I have a pair of the plastic Robart's for a Skyshark SBD and the metal Spring Air for the TF P-47. There really is no comparison. The plastic Robart's look cheap! I guess...
Forum: Twin & Multi Engine RC Aircraft
01-10-2005, 07:50 PM
Replies: 373
Views: 34,720
Posted By milkman-RCU

RE: The Twinstar is coming back

I have one on order and I plan to use two TT GP42's that I have laying around. Not as hot as .46, but not as heavy either.
Forum: RC Warbirds and Warplanes
12-30-2004, 07:08 PM
Replies: 5
Views: 827
Posted By milkman-RCU

RE: So who is building a Skyshark 109G?

Good start on the G.......

How is the ST75 fitting in the cowl?
Are you going to use the TF in cowl muffler or something else?
Any concerns on running the 2-stroke inverted?
Forum: RC Warbirds and Warplanes
12-03-2004, 02:16 PM
Replies: 166
Views: 30,108
Posted By milkman-RCU

RE: Skyshark Aichi (VAL) Build

Grahamd1-

I saw you were using the RCV-58 in the Val. I also know you have the Skyshark SBD with a different engine. What do you think about using the RCV-58 in the SBD? Will it provide enough...
Forum: Tips & Techniques
11-25-2004, 11:37 AM
Replies: 17
Views: 2,197
Posted By milkman-RCU

RE: Hang that bird

Here is my parkflyer parking garage made out of all 1/2 PVC. For the larger planes, I just the adjustable metal shelving with pipe insulation covering the moveable hangers. They work great for...
Forum: RC Warbirds and Warplanes
09-28-2004, 07:54 AM
Replies: 6
Views: 959
Posted By milkman-RCU

RE: opinions on best p 47 kit for first scale build

Mercuryfire -

The gear are not that difficult. If you leave off the gear doors, there are not any problems. Getting the gear doors to be flush with the bottom wing skin is the trick, just not...
Showing results 1 to 25 of 101
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.