RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Aerobat
Showing results 1 to 25 of 86
Search took 0.20 seconds.
Forum: IMAC
05-18-2010, 04:44 PM
Replies: 1
Views: 1,695
Posted By Aerobat

3rd ANNUAL LUMS POND IMAC CHALLENGE!!

To all IMAC pilots and those that want to try IMAC: Register for the Lums Pond IMAC challenge! We had a great time the past two years. Contact me with any questions or register here: ...
Forum: Gas Engines
06-28-2009, 02:49 PM
Replies: 7
Views: 1,194
Posted By Aerobat

RE: DA100 Idle problem - ideas?

It does it in the air and on the ground. I'll try richening it way up on the low end the next time I fly it.
Forum: Gas Engines
06-28-2009, 01:01 PM
Replies: 7
Views: 1,194
Posted By Aerobat

RE: DA100 Idle problem - ideas?

I have cleaned and overhauled the carb recently. The screen is clean. Everything is tight. The crankcase halves are tight and the outside of the motor is dry.

I tried to remove the reed...
Forum: Gas Engines
06-27-2009, 08:03 PM
Replies: 7
Views: 1,194
Posted By Aerobat

DA100 Idle problem - ideas?

Hi all,

My DA100 has started to act up at idle. When I chop the throttle, it will go to a low idle, then slowly speed up. It's gotten to be a real problem for IMAC. If I set the throttle trim...
Forum: Gas Engines
04-27-2008, 05:58 PM
Replies: 5
Views: 1,014
Posted By Aerobat

RE: Carden 40% Edge/DA150 sags in rolls

It's had that problem since I had the airplane.
Forum: Gas Engines
04-26-2008, 06:32 PM
Replies: 5
Views: 1,014
Posted By Aerobat

Carden 40% Edge/DA150 sags in rolls

The title says it all. It originally had one of those gadgets that route the diaphram vent out in front of the air inlet. I removed that and moved the vent line inside the fuse, but the motor still...
Forum: Carden Aircraft
04-26-2008, 02:40 PM
Replies: 3
Views: 1,403
Posted By Aerobat

Carden 40% Edge/DA150 sags in rolls

The title says it all. It originally had one of those gadgets that route the diaphram vent out in front of the air inlet. I removed that and moved the vent line inside the fuse, but the motor still...
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-09-2008, 12:49 PM
Replies: 10
Views: 2,389
Posted By Aerobat

RE: 3W Extra 300 - Toledo winner !

Which pilot/cockpit/panel is that?
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-08-2008, 10:04 AM
Replies: 28
Views: 2,983
Posted By Aerobat

RE: will my plane fit in any of the following?

Nothing beats a Chrysler/Dodge minivan with Stow n Go. I can get a 40% Edge (stabs removed), 1/3 Extra, full field gear, AND a passenger, in comfort.
Forum: Giant Scale Aircraft - General
04-07-2008, 01:45 PM
Replies: 6
Views: 1,423
Posted By Aerobat

RE: cleaning off your giant after flight

Goo Gone is great for the black oily exhaust residue you get on the underside.
Forum: Giant Scale Aircraft - 3D & Aerobatic
04-07-2008, 12:52 PM
Replies: 12
Views: 3,557
Posted By Aerobat

RE: DA 100 specs

Mine idles at about 1300, maxes out at about 6500 with a Mez 27x10.
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2008, 09:25 AM
Replies: 119
Views: 8,181
Posted By Aerobat

RE: 2.4 problems or A123s or?

Hey Jake, I'd plug each of those servos one at a time into a different receiver with a known good Nicad battery straight into it. Then move it under load for a good while.

I find that the...
Forum: Events, Shows and Fun Flys - Airplanes
01-25-2008, 08:12 AM
Replies: 6
Views: 1,401
Posted By Aerobat

RE: Warbirds Over Delware 2008

This is a one-post troll, Brian. No need to respond to it.
Forum: Gas Engines
12-12-2007, 04:39 PM
Replies: 8
Views: 1,020
Posted By Aerobat

RE: Glitching ZDZ80

I'd swap the plug, then the whole ignition. When the ignitions go bad they start to throw out RF noise. You could waste a lot of time (like I did) chasing the problem when it's that simple.
Forum: Giant Scale Aircraft - General
11-30-2007, 12:10 PM
Replies: 5
Views: 860
Posted By Aerobat

RE: Cowl and canope anchors

Wish I could take credit -- it was in the instructions for my Columbo Extra.
Forum: Giant Scale Aircraft - General
11-30-2007, 08:35 AM
Replies: 5
Views: 860
Posted By Aerobat

RE: Cowl and canope anchors

Here's what I'm talking about.
Forum: Giant Scale Aircraft - General
11-29-2007, 07:14 PM
Replies: 5
Views: 860
Posted By Aerobat

RE: Cowl and canope anchors

For the canopy/hatch, I like the single-screw method with a small hole in the top rear of the canopy for a screwdriver. There are 2 dowels in the front of the hatch and a single 1/4" nylon screw...
Forum: Gas Engines
11-24-2007, 07:33 AM
Replies: 48
Views: 4,565
Posted By Aerobat

RE: Proper Throttles on Gas Engines

All the gas motors I've bought had an arm on the carb. I just bolt on a ball link and it's ready to go.
Forum: Giant Scale Aircraft - General
11-21-2007, 09:24 AM
Replies: 13
Views: 1,445
Posted By Aerobat

RE: first gas plane

Get a design that you're comfortable with, similar to what you've been flying, but big enough for a small gas motor. You can get past the gas learning curve and fly a bigger plane without taking too...
Forum: Gas Engines
11-20-2007, 05:02 PM
Replies: 2
Views: 770
Posted By Aerobat

RE: Winter Maintenance DA-50R

I'd run the gas out of it to keep the carb from gunking up. You could also put a bit of oil in the spark plug holes. That's pretty much standard winterizing.
Forum: Gas Engines
11-20-2007, 01:31 PM
Replies: 25
Views: 3,303
Posted By Aerobat

RE: CH RCEXL Ignition

CH says not to run the RCXL on 6v. Mine has it written right on the ignition module.

http://www.ch-ignitions.com/CHinst.html
Forum: Gas Engines
11-15-2007, 01:45 PM
Replies: 4
Views: 734
Posted By Aerobat

RE: Proper proceedure for starting a DA 100?

I start my 100 and 150 the same way -- prop at 11 o'clock, ignition on, choke, 1/2 throttle, on the 3rd flip it starts and dies, then choke off, throttle just above idle, 5 flips or so and the beast...
Forum: IMAC
11-13-2007, 03:34 PM
Replies: 60
Views: 8,286
Posted By Aerobat

RE: 2008 Basic Narrative

Check out www.mini-iac.com -- there's a lot of good info there to get you started.
Forum: IMAC
11-12-2007, 10:14 PM
Replies: 60
Views: 8,286
Posted By Aerobat

RE: 2008 Basic Narrative

Bill, the short sequence you posted is AWESOME for practice - it really forced me to use the rudder without thinking about it - thanks! I'm going to drill on this one until it's intuitive.

Mark
Forum: Futaba Radios Direct support forum
11-10-2007, 10:16 PM
Replies: 5
Views: 809
Posted By Aerobat

RE: Need to set up a throttle/elevator mix on the 9Z

A lot of guys do it, it keeps the plane from pulling out of downlines. Someone PMd me with the proper setup.
Showing results 1 to 25 of 86
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.