RCU Forums - Search Results

Search: Posts Made By: easymoney

Showing results 1 to 25 of 82
Search took 0.77 seconds.

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-15-2003, 10:40 AM

Replies: 23

jr 700 glitches

Views: 1,514

Posted By easymoney

jr 700 glitches

First thing to mention that this is not a 4 or 5 cell issue (4.8V or 6V) as all JR RXs have built in regulator. Nor this is a problem with the Amplifier in Y harness. The servo pot needs to be...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-13-2003, 10:29 AM

Replies: 8

Don't like digital trim feel

Views: 926

Posted By easymoney

Don't like digital trim feel

jskrebs

I like your idea very much and want this feature...

Phil Cole
I think we all have five fingures on each hand... how about you.

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-11-2003, 10:08 AM

Replies: 15

Typical transmitter RF output power?

Views: 2,314

Posted By easymoney

Typical transmitter RF output power?

The maximium RF output power limit set forth by FCC for radio control is 750mW and new JR Txs normally transmitts between 500 to 600mW.

Its better if you send the radio to JR service centre for...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-11-2003, 10:08 AM

Replies: 15

Typical transmitter RF output power?

Views: 2,314

Posted By easymoney

Typical transmitter RF output power?

The maximium RF output power limit set forth by FCC for radio control is 750mW and new JR Txs normally transmitts between 500 to 600mW.

Its better if you send the radio to JR service centre for...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-11-2003, 09:49 AM

Replies: 8

Don't like digital trim feel

Views: 926

Posted By easymoney

Don't like digital trim feel

I don't like the feel of the 2 push button digital trim in all computer radios...
But as far as the digital trim features are concerned they are excellent.

I want the feel of the trim to be like...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

01-10-2003, 07:26 AM

Replies: 41

Hi tec reliablility

Views: 4,145

Posted By easymoney

Hi tec reliablility

joey

What do you think... if somebody had a loss of more than $500 due to Hitec servo failure then will he try that again... :rolleyes:

For my case I WILL NEVER TRY Hitec AGAIN even if they...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-31-2002, 07:56 AM

Replies: 7

Cheapest place for hitec digitals?

Views: 791

Posted By easymoney

Cheapest place for hitec digitals?

Junk.................................. :D :D :D

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-30-2002, 08:16 AM

Replies: 16

Digital Throttle Trims

Views: 1,488

Posted By easymoney

Digital Throttle Trims

Digital trim is a very good feature but I don't like the feel. It should be like the mechanical trims but with spring action to reset it to centre.

The problem with these, just 2 push button trim...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-25-2002, 09:12 AM

Replies: 5

Help !! Jr X-378

Views: 699

Posted By easymoney

Help !! Jr X-378

Yes it can be changed and I have done this on 10 new sets for a JR distributor. Its easy but cannot be explained... it requires a set to be infront and doing yourself, I think you can understand.
...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-22-2002, 06:44 PM

Replies: 8

Needs help for Hitec digital servo

Views: 719

Posted By easymoney

Needs help for Hitec digital servo

[QUOTE]Originally posted by lnorris
[B]Oh, someone asks a question and here comes the Hitec bashing :rolleyes:. I seriously doubt ANY of the digital servos have shielding. That would be...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-21-2002, 11:40 AM

Replies: 8

Needs help for Hitec digital servo

Views: 719

Posted By easymoney

Needs help for Hitec digital servo

You need a electro-magnetic shielding. In fact the microcontroller of this HS-5945MG is not properly shielded... one more Negative Point goes to hitec :o

Either place a big metal sheet betwwn...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-20-2002, 06:55 PM

Replies: 14

Hitec 5645 Jan 02 v1.03....?

Views: 812

Posted By easymoney

Hitec 5645 Jan 02 v1.03....?

Yep in the marketplace... not in customers hand... :D :D :D infact not sold.

Vince
Now you should start worrying because they have spend some good time... :rolleyes:

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-19-2002, 08:57 AM

Replies: 10

Views: 1,106

Posted By easymoney

Its perfectly controllable design parameters. If the design uses comparators after the recovered PPM signal from RX and just befor 4015 decoder, then it can be completely removed.

But still unable...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-19-2002, 08:44 AM

Replies: 10

Views: 1,106

Posted By easymoney

Its normal but I think the radio manufacturers should consider this issue as this can strip the gears if the servo is already at its extreme end, mostly in throttle. :rolleyes:

I have seen all...

Forum: The Clubhouse

12-19-2002, 08:17 AM

Replies: 17

The Wonder of Real Flight

Views: 1,350

Posted By easymoney

The Wonder of Real Flight

Yep... one of the Wonders of RealFlight is its PRICE !!! :rolleyes:

Its is only good for first time training but there are other free sims that can serve the same purpose, like FMS.

Forum: Glow Engines

12-17-2002, 06:32 AM

Replies: 7

Silicon exhaust extensions

Views: 1,160

Posted By easymoney

Silicon exhaust extensions

I don't agree that the increased lenght will effect the back pressure much. If you use the correct size extension... I mean for 40 size engine use the recommended 40 size extension and with 60 use...

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

12-16-2002, 09:24 AM

Replies: 13

Check this out!

Views: 1,981

Posted By easymoney

Check this out!

I am unable to access http://mstar2k.com/... is there any reason :confused:

Forum: Glow Engines

12-16-2002, 09:08 AM

Replies: 7

Silicon exhaust extensions

Views: 1,160

Posted By easymoney

Silicon exhaust extensions

Silicon exhaust extensions/deflector really drops the sound level. I have tried this on a fox engine with good results and I think this is because of the flexibility in the tube.

Forum: Tips & Techniques

12-10-2002, 09:32 AM

Replies: 1

Any tips

Views: 457

Posted By easymoney

Any tips

Are there any good tips to repair a damaged foam core wing...?

Forum: The Clubhouse

12-03-2002, 12:18 PM

Replies: 6

Anyother way...?

Views: 663

Posted By easymoney

Anyother way...?

The field is 8 Km and I have a bike... but don't know how to hook up a 40 size plane... :)

Forum: The Clubhouse

12-03-2002, 12:00 PM

Replies: 6

Anyother way...?

Views: 663

Posted By easymoney

Anyother way...?

Is there ant other way to transport the plane to the flying field without a car. I had a car in the past but now I feel its importance to R/C hobby.
Now I don't understamd how to take the plane to...

Forum: Glow Engines

11-27-2002, 08:35 AM

Replies: 0

Fox 40

Views: 316

Posted By easymoney

Fox 40

Is Fox 40 good enough for the CG Tiger 40...?

Forum: RC Radios, Transmitters, Receivers, Servos, gyros

11-27-2002, 08:22 AM

Replies: 17

Black Wire Desease

Views: 1,635