RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Oldie
Showing results 1 to 25 of 63
Search took 0.67 seconds.
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
10-27-2018, 01:03 PM
Replies: 4
Views: 13,248
Posted By Oldie

Can't bind new Aurora 9 Tx with new Optima 9 Rx.

Have been trying off and on for five months to bind. Tx has supplied battery pack 100% charged for attempted binding.. RX has A123 2500 MAH batteries. Throttle is closed, model is set up according to...
Forum: ARF or RTF
09-12-2013, 07:30 PM
Replies: 4
Views: 823
Posted By Oldie

Trucker-Thanks did the trick. Oldie

Trucker-Thanks did the trick.

Oldie
Forum: Batteries & Chargers
02-02-2013, 08:26 PM
Replies: 7
Views: 1,112
Posted By Oldie

Life Rx Packs

Need to know how Life batteries can be checked. Voltmeters won't work. How do you check that it is good after charge. What is the down side if any?
Forum: ARF or RTF
12-07-2012, 06:22 AM
Replies: 2
Views: 571
Posted By Oldie

RE: Pull-pull system for a 120 size ARF

Thanks, Nitro.
Forum: ARF or RTF
12-06-2012, 06:42 PM
Replies: 2
Views: 571
Posted By Oldie

Pull-pull system for a 120 size ARF

What is the best pull-pull rudder system for a 120 size Edge? Is Sullivan any good?
Forum: Batteries & Chargers
07-06-2012, 07:56 AM
Replies: 24
Views: 2,210
Posted By Oldie

RE: Life battery packs

Thanks for the information. Are LIFE batteries widely used in RC aviation activities now, and are they any more of a fire threat than NiCads when charging, like LIPOs?
Forum: Batteries & Chargers
07-03-2012, 04:05 AM
Replies: 24
Views: 2,210
Posted By Oldie

Life battery packs

SIAP, but what is the story of Life batteries for RC. Do the on board packs need a voltage regulator as they seem to be 6.6? What is the best charger for them?

Would appreciate your comments....
Forum: ARF or RTF
04-17-2012, 05:33 PM
Replies: 4
Views: 823
Posted By Oldie

Got a large profile from Ohio Model Products

Have a large Ohio Model Products Profile ARF.

Wing tubes are fiber glass and the wings can't be slipped on.

The tubes are smooth.

Is there something I can spray on them to make them...
Forum: JR Radio & Spektrum Radios
03-03-2008, 06:29 PM
Replies: 1
Views: 526
Posted By Oldie

Using JR reciever; Hitec servo.

Hi, Danny:

I know this is a Lincoln was shot question as you have probably had it endlessly, but will Hitec servos work with Jr receivers electronically? I know that you can't recommend them,...
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
03-03-2008, 06:21 PM
Replies: 1
Views: 681
Posted By Oldie

Hitec servos work with JR receivers?

Hi:

Will Hitec servos work with JR receivers?

Thanks

Oldie
Forum: JR Radio & Spektrum Radios
07-04-2007, 01:15 PM
Replies: 6
Views: 1,317
Posted By Oldie

RE: JR 4721 servos

An amplified Y-harness did not cure the problem. Still an aileron vibration that does not go away when you grasp the airelon on both sides.

Still seeking a cure.

Further suggestions?

...
Forum: JR Radio & Spektrum Radios
07-02-2007, 12:41 PM
Replies: 6
Views: 1,317
Posted By Oldie

RE: JR 4721 servos

Thanks for the reply Danny.

I have a plain Y-Harness, an amplified, and one designed for make elevators operate in the same direction. Only one installed on this plane. Probably got the one...
Forum: JR Radio & Spektrum Radios
06-29-2007, 08:59 PM
Replies: 6
Views: 1,317
Posted By Oldie

JR 4721 servos

Have a profile powered by an OS Max 1.60. On each aileron I have a JR 4721 servo with a y connector suposed to dampen any problems because of long leads. The ailerons servos chatter a lot with no...
Forum: JR Radio & Spektrum Radios
06-21-2007, 08:13 PM
Replies: 6
Views: 733
Posted By Oldie

RE: XP 783 Elevator Leaf Mixing Problem

Another Oldie, your advice is worth far more than it costs. Switched the slave to 7 and all is in order.

Page 63 of the XP 783 manual which explains setting up electronic two elevator operation...
Forum: JR Radio & Spektrum Radios
06-21-2007, 06:19 PM
Replies: 6
Views: 733
Posted By Oldie

XP 783 Elevator Leaf Mixing Problem

Hi, Danny:

Trying to use Mix E to move elevators in concert without a Y harness with two separate servos. Following manual instructions, no result.

One servo plugged in to elevator...
Forum: JR Radio & Spektrum Radios
05-22-2007, 01:07 PM
Replies: 2
Views: 599
Posted By Oldie

RE: Purchase of JR XP7202 Tx Only

Thanks, Danny.
Forum: JR Radio & Spektrum Radios
05-21-2007, 12:02 PM
Replies: 2
Views: 599
Posted By Oldie

Purchase of JR XP7202 Tx Only

Hi, Danny:

Is XP 7202 available for purchase without receiver and servos, as a stand alone purchase?

Is only a synthensized version available?

Will synthisized version work with...
Forum: Control Lines
01-19-2007, 07:04 PM
Replies: 78
Views: 9,430
Posted By Oldie

RE: What age were you at first C/L flight.

Gremlin: I had several of those Firebabys also. The Wasp .049 was a great little engine. First few Firebaby's I flew had a balsa rudder but the last few had a stamped aluminum rudder.

Also had...
Forum: Glow Engines
12-10-2006, 10:27 PM
Replies: 49
Views: 9,456
Posted By Oldie

RE: Moki Engines

Thanks for the information, both of you. I am appreciative.

The Hobby Club page is confusing. They have Moki listed under gas engines, and where is this company located? In the US?
Forum: Glow Engines
12-10-2006, 09:05 PM
Replies: 49
Views: 9,456
Posted By Oldie

Moki Engines

Are Moki Engines still available anywhere? They are great engines.
Forum: JR Radio & Spektrum Radios
08-02-2006, 04:31 PM
Replies: 2
Views: 508
Posted By Oldie

RE: Getting JR servos fixed

I have sent in a dozen or so JR servos to Horizon over time to be repaired and have been dealt with more than fairly by them. They fixed or replaced at very reasonable cost so I must say that I am a...
Forum: Glow Engines
07-11-2006, 08:59 PM
Replies: 12
Views: 3,544
Posted By Oldie

RE: Webra .61 needs fuelpump?

I flew Webra .61 Race (rear exhaust) and Webra .61 Speed (side exhaust) engines for years. They don't make the Race any more (or don't import it here) and I sure wish I had one. The Dynamix is a...
Forum: Glow Engines
11-09-2005, 08:16 PM
Replies: 7
Views: 1,067
Posted By Oldie

RE: pitts muffler fix

I have had a couple of broken pipes (broken loose at the body of the mufflers) on Bisson Pitts mufflers and have taken them to a local welding shop.

The turn around was a few days, the fix is...
Forum: ARF or RTF
10-31-2005, 03:10 PM
Replies: 5
Views: 863
Posted By Oldie

RE: Construction booklet for Cap 232

RCPilet:

Thanks for the information. It was exactly the kind of information regarding this plane that I have looking for.

Its great to know the thing flies well, and good to be forewarned...
Forum: ARF or RTF
10-23-2005, 06:01 PM
Replies: 5
Views: 863
Posted By Oldie

Construction booklet for Cap 232

Hi:

Recently acquired a Cap 232 ARF 120 size by Hanger 9 . It was new in box except for the
construction booklet.

Since the man I purchased it from is now deceased, I can't ask him...
Showing results 1 to 25 of 63
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.