RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Search
Today's Posts
Mark Forums Read
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: kestrel53065
Showing results 1 to 25 of 73
Search took 0.72 seconds.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-13-2009, 10:42 PM
Replies: 6
Views: 643
Posted By kestrel53065

RE: Antenna question

Thanks Guys.

Anyone care to break the tie here????
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-11-2009, 11:05 PM
Replies: 6
Views: 643
Posted By kestrel53065

Antenna question

The thin strip of ribbon from an audio cassette would make a great wind indicator at the end of the Tx antenna. Would this create a problem with the function of the antenna?

Thanks
Forum: RC Gliders, Sailplanes and Slope Soaring
09-07-2008, 11:05 PM
Replies: 9
Views: 4,222
Posted By kestrel53065

RE: Best tape for taped hinge?

Is Blenderm suitable for DLG rudder? How about flaps and ailerons on a 3meter?

Thanks,
Forum: Futaba Radios Direct support forum
07-09-2008, 10:05 PM
Replies: 2
Views: 603
Posted By kestrel53065

RE: Sailplane motor control

Thanks Krysta,

I have been messing with it and came up with pretty much what you have. Looks like it should work.

Thanks again.
Forum: Futaba Radios Direct support forum
07-08-2008, 11:31 AM
Replies: 2
Views: 603
Posted By kestrel53065

Sailplane motor control

I would like to leave my left stick to control the spoilers on a sailplane. Can I program one of the sliders on my 9CH to control the esc for an electric motor?

Thanks
Forum: Hitec/MultiPlex Radios- Ask Hitec Customer Service
02-28-2006, 11:25 PM
Replies: 17
Views: 1,647
Posted By kestrel53065

555 / Super Slim

I recently visited the Hitec site and noticed that the 555 and Super Slim Rx were not listed. I have several of these and have been pleased with the performance. Have they been discontinued?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-07-2006, 11:31 AM
Replies: 4
Views: 935
Posted By kestrel53065

RE: Wiring a four pin connector

Thanks Michael.

I don't need to do a six servo wing at this time but at least now I understand it.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-07-2006, 11:07 AM
Replies: 4
Views: 935
Posted By kestrel53065

RE: Wiring a four pin connector

Thank you Michael. I will look at the pins that you suggest. The pins that I have are some very small Deans.

Just curious, but how many servos could be powered by one wire coming from the Rx?...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
01-06-2006, 12:10 AM
Replies: 4
Views: 935
Posted By kestrel53065

Wiring a four pin connector

I would guess that this topic has been covered before, but, I have a discus launch glider that has ailerons. I want to make the servo connector at the wing a single 4 pin connection. I understand...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-28-2005, 09:33 PM
Replies: 28
Views: 4,247
Posted By kestrel53065

RE: Volt watch troubles

I understand that if an antenna wire is crossed over/ touches itself that it can negatively affect its function. Can other wires such as from servos or the voltwatch cause any performance problems if...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-28-2005, 08:01 AM
Replies: 28
Views: 4,247
Posted By kestrel53065

RE: Volt watch troubles

I sent an e-mail to Hobbico asking if there were any problems with the volt watch and glitching. Explaining this thread. Below is the answer that I received back.


"No there are no issues with...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-26-2005, 11:36 PM
Replies: 3
Views: 737
Posted By kestrel53065

RE: Setting up a new radio

Thanks for the replys. The new 9CH should be here tomorrow.

Duey
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-23-2005, 08:00 PM
Replies: 3
Views: 737
Posted By kestrel53065

Setting up a new radio

I am considering a new radio in the near future. The thought occured to me that setting up all of my existing models on the new radio would be a considerable task.

Anyone have any tricks or...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-11-2005, 01:13 AM
Replies: 7
Views: 708
Posted By kestrel53065

RE: Slippery Antenna

I have used the needle and thread trick several times. If the antenna isn't long enough to exit the fuse, simply leave a length of thread attached to the antenna and then anchor the end of the thread...
Forum: Futaba Radios Direct support forum
04-01-2005, 04:03 AM
Replies: 2
Views: 577
Posted By kestrel53065

RE: Switching switches

Thanks Bax.
Forum: Futaba Radios Direct support forum
03-30-2005, 10:06 AM
Replies: 2
Views: 577
Posted By kestrel53065

Switching switches

If you have a 9CAP, is it possible to move the switches from side to side so that it is set up like the heli version? In other words are the mounting holes the same and the wires long enough?
Forum: RC Gliders, Sailplanes and Slope Soaring
03-26-2005, 11:27 PM
Replies: 4
Views: 1,111
Posted By kestrel53065

RE: Recommendations Please - 2M Full House ARF

A 2M fullhouse for under $200 is going to be hard to find. Art Hobby has a few 2M for under $200 but do require some building. NSP has the Omega listed as "almost ready to fly" but it is priced...
Forum: Futaba Radios Direct support forum
03-25-2005, 10:14 PM
Replies: 3
Views: 720
Posted By kestrel53065

RE: What's the different between 9CAP & 9CHP ???

If you have a 9CAP, is it possible to move the switches from side to side so that it is set up like the heli version? In other words are the mounting holes the same and the wires long enough?
Forum: RC Gliders, Sailplanes and Slope Soaring
03-20-2005, 12:44 AM
Replies: 22
Views: 2,922
Posted By kestrel53065

RE: Good Glider Transmitters

Thanks for the info. Will see what is avail. when I am ready to buy. At this time it looks like the Futaba will fit my needs. Will have to decide if the heli model is worth the extra $30 or so.
Forum: RC Gliders, Sailplanes and Slope Soaring
03-19-2005, 01:25 PM
Replies: 22
Views: 2,922
Posted By kestrel53065

RE: Good Glider Transmitters

aeajr,

I have been looking over info on the 9C and thought it meant that the air v heli was that a couple of the switches are swapped from one side to the other and smooth stick on the heli. Did...
Forum: RC Gliders, Sailplanes and Slope Soaring
03-17-2005, 10:44 PM
Replies: 22
Views: 2,922
Posted By kestrel53065

RE: Good Glider Transmitters

aeajr/John C,

It appears to me that your assumptions are correct. I have an Eclipse 7 set up as you have listed. Chanel 3 is open on my 8 chanel Rx. So, I plugged a servo into it and yes the...
Forum: RC Gliders, Sailplanes and Slope Soaring
03-03-2005, 12:18 AM
Replies: 9
Views: 3,505
Posted By kestrel53065

RE: Jester 2M RES build thread - good 2nd plane... perhaps

Just a note here. You may or may not have done this but just a suggestion. In regard to fitting the square leading edge. First be sure that if you have to trim the notch in the ribs to fit the spar,...
Forum: RC Gliders, Sailplanes and Slope Soaring
03-03-2005, 12:09 AM
Replies: 9
Views: 1,569
Posted By kestrel53065

RE: Thermalling and Hi-Start

Yes, a hi-start can be used to launch the hand launch planes. I am currently building a Gambler+. It is not that difficult of a build if you like to build. It was suggested to me that if I wanted to...
Forum: RC Gliders, Sailplanes and Slope Soaring
03-02-2005, 11:21 AM
Replies: 35
Views: 5,341
Posted By kestrel53065

RE: Choosing a big, cheap, relaxing glider

jkirby,

If you have narrowed it down to the Big Bird and the Kestrel. The Big Bird would be by far the favorite.
Forum: Batteries & Chargers
02-01-2005, 12:06 PM
Replies: 6
Views: 681
Posted By kestrel53065

RE: Charging Tx Battery with Accu Cycle

The word form Hitec is that charge/discharge thru the Tx jack can't be done as there is a diode in the circuit. Anyway, I plan to set up a cable to do the battery outside of the Tx. Which leaves me...
Showing results 1 to 25 of 73
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.