RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: dcl1701
Showing results 1 to 9 of 9
Search took 0.37 seconds.
Forum: Exceed RC Support - Helicopter
12-28-2009, 01:48 AM
Replies: 19
Views: 2,535
Posted By dcl1701

RE: eagle 50 no lift

When I got another batt, I went to the hobby shop and got a decent quality, don't remember what brand but it does perform. Glad I spent a couple of extra bucks.
Forum: RC Helicopter Beginners Forum
12-28-2009, 12:28 AM
Replies: 4
Views: 820
Posted By dcl1701

RE: trex 450 combo kit servo trouble

If they are the blue ones, I would take a.w.a.g and say they just don't have the umph. The rx/speed control should take care of the voltage but usually 4 to 6 volts. I you have more burnt servos when...
Forum: RC Helicopter Beginners Forum
12-26-2009, 02:34 AM
Replies: 4
Views: 820
Posted By dcl1701

RE: trex 450 combo kit servo trouble

Hey hadi,

I had 2 of 'em just burn up so I ended up putting the HS 85 MG (I think that was the one) and haven't had a problem yet. GOOD servos. I also upgraded gyro and Tail servo (digital) as...
Forum: Exceed RC Support - Helicopter
12-26-2009, 02:21 AM
Replies: 4
Views: 1,094
Posted By dcl1701

RE: Eagle 50 T-shaped Hub

Hi fly,

I've had a bit of problems with that hub. The set screw is Loc-Tie and had to use reverse drill bit to get it out. Then, I had to snug it just so you can slide it up to the top of the...
Forum: Exceed RC Support - Helicopter
12-26-2009, 01:12 AM
Replies: 60
Views: 10,752
Posted By dcl1701

RE: eagle 50 helicopter

Hey,
I have an Eagle 50 and I really got tired of getting the "upgraded" part that has that little ball on it. So, I got a ball from my T-rex 450 spares kit, drilled a hole where the ball broke...
Forum: Exceed RC Support - Helicopter
12-26-2009, 12:21 AM
Replies: 19
Views: 2,535
Posted By dcl1701

RE: eagle 50 no lift

Hey,
Got The Eagle 50 a few months back and I really haven't got to practice with it because something was always going wrong with it. But I would certainly try another batt and never run a lipo...
Forum: Off Topic Forum - Planes/Helis
12-25-2009, 10:50 PM
Replies: 0
Views: 534
Posted By dcl1701

shipping lipo batts

OK... Does any one know the rules on shipping lipos from one place to another? I know the Battery Companies do it and no prob. However, after reading CFR 49 and HazMat rules, I'm sceard ta death!...
Forum: RC Helicopter General Discussions
01-08-2009, 05:25 PM
Replies: 1,595
Views: 111,562
Posted By dcl1701

RE: WIN A FREE Scale Fuselage from V-East & Graupner Helis

OK. I hope I'm not late as I tend to be on the low end of the power curve. When I win this baby, I know I will be back at the top of that curve. If not, I can still fly my 450 and get satisfaction...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.