RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Art Cloutier
Showing results 1 to 10 of 10
Search took 0.35 seconds.
Forum: Gas Engines
02-02-2008, 11:54 PM
Replies: 2,356
Views: 282,579
Posted By Art Cloutier

RE: BCMAEngines

I, too, clogged up the carb with a black stopper. Cleaned everything out but now the engine does not seem to get fuel sucked in as it should. I did not pull the aluminum plugs in the Walbro Carb;...
Forum: Gas Engines
02-02-2008, 11:48 PM
Replies: 2,356
Views: 282,579
Posted By Art Cloutier

RE: BCMAEngines

Having a hard time starting my new (just broke in) SPE 26. Have checked out everything except crankcase vacuum. How does one do that ?? Compression seems about average for a new engine. It fires...
Forum: IMAC
01-08-2008, 08:50 PM
Replies: 30
Views: 3,550
Posted By Art Cloutier

RE: Minnesota IMAC Contest, Interested???

Can't make it because I am in Arizona; however am interested in seeing you succced with this because I was raised in Faribault and have flown IMAC with several people in Owatonna. Best of luck with...
Forum: IMAC
01-08-2008, 08:42 PM
Replies: 7
Views: 2,107
Posted By Art Cloutier

RE: Which Gas Engine for AeroWorks .90-1.20 Yak 54 ARF ?

Consider going to 50cc in a plane that can be finished out under 16 lb to get adequate thrust to weight ratio for good aerobatic performance. Art Cloutier
Forum: Beginners
01-08-2008, 08:36 PM
Replies: 23
Views: 2,179
Posted By Art Cloutier

RE: Nexstar does not want to turn on slight climb

The high dihedral planes I have flown often have too much adverse yaw to be very resposive to aileron inputs. On some of these planes it is an improvement to remove most of the dihedral. It may...
Forum: Beginners
01-04-2008, 02:23 PM
Replies: 23
Views: 2,179
Posted By Art Cloutier

RE: Nexstar does not want to turn on slight climb

The Nextar my last student had behaved as you have described; we tried to blend a little rudder but found it pitched so hard to the landing gear that was not a help in getting a level turn. We...
Forum: Beginners
01-04-2008, 10:51 AM
Replies: 6
Views: 1,310
Posted By Art Cloutier

RE: Gas powered trainer

When flying with the gang at Brazoria Field in Texas I flew a 25cc powered Sig Four Star in the 120 size; it had about 14 lbs thrust and weighed about 14 lbs. That gave enough vertical for basic...
Forum: 3D Flying!
12-23-2007, 04:08 PM
Replies: 17
Views: 2,020
Posted By Art Cloutier

RE: Which smaller/cheeper gasser for IMAC and 3d

My 50 cc DA pulls a 17 lb plane vertical with enough authority to do unlimited sequence in IMAC. It probably is pulling in excess of 25 lbs. of thrust.
In order to do as well a 26 cc engine...
Forum: ARF or RTF
12-23-2007, 03:04 PM
Replies: 328
Views: 79,285
Posted By Art Cloutier

RE: AVOID THESE ARF's AT ALL COST!!!!!!!!!!!!

Trainers need to be good handling planes to keep the student's workload down as much as possible. Training aircraft which have a lot of adverse yaw, roll couple, and pitch couple are difficult for...
12-22-2007, 05:27 PM
Replies: 2,864
Views: 253,053
Posted By Art Cloutier

RE: Why the AMA is not growing...........

Hi Tony! .... haven't seen you since I saw you hovering a You-Can Do at Brazoria field several years ago. At the present time in Page AZ I have three students; all are retired and looking for an...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.