RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: JFEsch
Showing results 1 to 11 of 11
Search took 0.33 seconds.
Replies: 171
Views: 128,596
Posted By JFEsch

Cool Aurora 9 recevier for quad build

I am looking for a receiver compatible with my Aurora 9 TX, for a 200 size quad build, that will work with the Kombini Furious FPV Flight Controller Board. I am clueless on what will work with what...
06-05-2017, 09:50 PM
Replies: 2
Views: 1,142
Posted By JFEsch

Exclamation Needing help on Hitech Aurora 9 differential thrust

Howdy all,
I am building a FT Kraken and using a Hitech Aurora 9 radio. I need help on setting the radio up for differential thrust (twin motor).
There is little info or videos on how to set the...
02-14-2017, 09:40 PM
Replies: 9
Views: 2,776
Posted By JFEsch

I like it. This project is for my son. I am...

I like it.
This project is for my son. I am going to go with what the manuals says and hope for the best.
My next project is the TF Giant scale Corsair. Can't wait but my wallet can. Going all out...
02-12-2017, 12:46 PM
Replies: 9
Views: 2,776
Posted By JFEsch

Thanks for the help. I guess if there was an...

Thanks for the help. I guess if there was an issue with the setup or how to assemble the tank, it would have been noted in the manual since the manual is well written, IMO.
02-12-2017, 09:26 AM
Replies: 9
Views: 2,776
Posted By JFEsch

Thanks for the reply. That fuel tank install...

Thanks for the reply. That fuel tank install looks the same as a normal install though. The fuel tank install in the TF C182 is 90 degrees, long side of the tank left to right, not forward to aft. In...
Forum: Kit Building
02-12-2017, 09:07 AM
Replies: 1,051
Views: 540,512
Posted By JFEsch

Any concerns of the fuel tank being mounted...

Any concerns of the fuel tank being mounted sideways? I know the instructions say that they had no issues, while test flying the model, but it would nice if they said how the tank was assembled...
02-11-2017, 07:26 PM
Replies: 9
Views: 2,776
Posted By JFEsch

Fuel tank install in Top Flite C182 position

Anyone has had issues with the way the fuel tank (sideways) is installed in the TF C182? If not, would the fuel pickup be made to where it is centered in the tank?
I would think being in a turn in...
02-11-2017, 06:57 PM
Replies: 2
Views: 546
Posted By JFEsch

Saito

I got a Top Flite Giant Scale Corsair for my birthday and was curious if a Saito F170 R3 radial engine would be a good match?
I am going to put alot of time and money into this kit, and I don't want...
Forum: ARF or RTF
02-11-2017, 12:15 PM
Replies: 1,420
Views: 380,196
Posted By JFEsch

How are you attaching the nose gear fairing to...

How are you attaching the nose gear fairing to the strut? What is your measurement from the swing arm to the top of the strut?
Forum: Kit Building
02-04-2017, 09:10 PM
Replies: 6
Views: 1,884
Posted By JFEsch

Anyone know of a LED kit for the nose landing...

Anyone know of a LED kit for the nose landing lights for this kit? I don't like the looks of the incandescent lights or the size of the of the light plus LEDs will take less power to run. Also,...
Forum: Kit Building
01-29-2017, 03:03 PM
Replies: 3
Views: 2,836
Posted By JFEsch

I am having an issue about the Outer Dihedral...

I am having an issue about the Outer Dihedral braces. I can not picture it in my mind, but it states in the manual that the angled edge should be facing upward between the ribs. The wing is being...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.