RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: apcud7
Showing results 1 to 23 of 23
Search took 0.34 seconds.
Forum: RC Warbirds and Warplanes
02-01-2019, 11:19 AM
Replies: 105
Views: 19,091
Posted By apcud7

Hi guys, I know I'm a few years late to the party...

Hi guys, I know I'm a few years late to the party but I finally have time to build this (bought it a few years ago). I was planning on the Saito 125 but have never had one. May last Hangar 9 60 ARF...
Forum: Speed - RC Nitro Boats
06-06-2009, 03:27 PM
Replies: 4
Views: 1,047
Posted By apcud7

RE: CMB .67

I'm taking apart a new CMB .67 Greenhead. First CMB I've ever had and Itoo was told to go through it before cranking it over. What is the trick to getting the head off after the water jacket has been...
Forum: Speed - RC Nitro Boats
06-06-2009, 03:26 PM
Replies: 11
Views: 2,109
Posted By apcud7

RE: CMB .67 piston position

I'm taking apart a new CMB .67 Greenhead. First CMB I've ever had and Itoo was told to go through it before cranking it over. What is the trick to getting the head off after the water jacket has been...
Forum: RC Warbirds and Warplanes
04-23-2009, 02:08 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Even though it is nearly inverted, it has run fine for as long as I've had it. I didn't change the tank height, just put it in by the book. I can't remember how much weight I had to add. I had those...
Forum: RC Warbirds and Warplanes
04-23-2009, 01:07 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Well I think that you will be happy with the .61 or the .75. This plane flies great with anything. I think the .61 is more than enough when flying scale, though. Engine is mounted as the manual says,...
Forum: RC Warbirds and Warplanes
04-23-2009, 11:14 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

RedStar

I use an evo .61 in my hellcat. It is light, didn't take much weight to balance it out either. I fly like you do mostly scale and have no need for extra power that will never be used...
Forum: RC Warbirds and Warplanes
04-21-2009, 11:36 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

my tank c/l is about 25mm above the carb. Mine has run fine for a season like that, but I'm running an evo .61 two stroke
Forum: RC Warbirds and Warplanes
04-21-2009, 10:55 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

mr sand

I use a hangar 9 fuel dot to do the fueling. I first used a valve system but after one season the valve began to stick and the engine wouldn't run correctly. The guy at my hobby store...
Forum: RC Warbirds and Warplanes
08-13-2008, 04:12 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Had my second flight with the Hellcat the other day. Everything went fine and the stock landing gear is holding up great.
Here's the youtube link
http://www.youtube.com/watch?v=5Ra5kSWZkT4
Forum: RC Warbirds and Warplanes
07-08-2008, 02:42 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

I flew my maiden flight this weekend with the hellcat. Everything went well except I landed with too much speed and the plane nosed over in the grass at the end of the runway. I had never flown any...
Forum: RC Warbirds and Warplanes
06-25-2008, 06:02 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

I just finished my Hellcat today. I painted the heads of the cowl screws to match the colors that they are in. I also painted the screws in the switches black. It helps hide them a lot.
Forum: RC Warbirds and Warplanes
04-06-2008, 09:09 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Hey, I was just wondering if anyone has used the evolution 61 with this hellcat. That is the engine I will be using and I am wondering if anyone has used it and if they were able to get the stock...
Forum: RC Warbirds and Warplanes
04-06-2008, 10:03 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Hey guys, I just got my Hellcat yesterday and I noticed that the elevators fit nicely into the horizontal stab for the most part except at the edges. I looked through the forum again for photos of...
Forum: RC Warbirds and Warplanes
03-19-2008, 06:17 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

I called Horizon and looked around and they said the Hellcat should be back in stock either the third or fourth week of April. I'm not sure about the landing gear but most sites say the Hellcat comes...
Forum: RC Warbirds and Warplanes
03-12-2008, 01:44 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

I haven't flown any Hangar 9 Warbirds and I was wondering how hard the Hellcat is to take off. Do you need to use a lot of rudder in either direction once the tailwheel lifts up off the ground? Do...
Forum: RC Warbirds and Warplanes
03-11-2008, 04:30 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

So if i use the 700 mah that comes with my radio system and then buy the exact same one and a y harness, both the batteries will work together and give me 1400 mah which you think is enough for the...
Forum: RC Warbirds and Warplanes
03-11-2008, 02:53 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

The radio system I bought came with a 4.8V 700mAh NiCD battery for the receiver. Do you guys think that this is enough power for the receiver, retracts, and all of the other servos? I saw corsair...
Forum: RC Warbirds and Warplanes
03-05-2008, 11:11 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

ok thanks a lot steve
Forum: RC Warbirds and Warplanes
03-05-2008, 01:00 AM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Thanks for letting me know. I need to buy a radio transmitter and the one I want from JR comes with 4 of these servos

ST47 Standard (1.55 oz, 47 oz/in Torque)
JSP JSP20050
Application: 40 -...
Forum: RC Warbirds and Warplanes
03-04-2008, 09:46 PM
Replies: 1,832
Views: 276,697
Posted By apcud7

RE: H9-F6F Hellcat 60 ARF

Does the Hellcat come with the servo tray that it shows in the manual with all the precut slots? The manual doesn't say if it comes with it but it doesn't talk about making it either. I was wondering...
Forum: ARF or RTF
02-18-2008, 06:50 PM
Replies: 2,530
Views: 399,221
Posted By apcud7

RE: Hangar 9 60 size corsair arf

Hey Viper, thanks for all the posts and help. Could you post some pictures of your Corsair with the Sierra Gear in it? How well did it fit?
Forum: ARF or RTF
02-18-2008, 10:41 AM
Replies: 2,530
Views: 399,221
Posted By apcud7

RE: Hangar 9 60 size corsair arf

Alright thanks a lot for your help guys. I will do what you guys said to do but why do I need to bend the tail assembly before putting it in the plane? Also, I am thinking about getting new retracts...
Forum: ARF or RTF
02-15-2008, 12:49 AM
Replies: 2,530
Views: 399,221
Posted By apcud7

RE: Hangar 9 60 size corsair arf

Hey, I am very interested in the Hangar 9 Corsair. I have seen it in stores and online and in videos. It is a beautiful plane and I really want to buy it. There are 70 pages in this forum and I've...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.