RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: JonPa
Showing results 1 to 19 of 19
Search took 0.37 seconds.
01-11-2013, 02:22 PM
Replies: 1,677
Views: 403,485
Posted By JonPa

RE: Extreme Flight Vanquish 2m Build Thread

Wayne,

I just used a piece of stiff music wire that I taped to the tip of the pull pull cable. Then I routed it from the back through the slot in the fuselage. You only need to push it about...
12-29-2012, 10:26 AM
Replies: 1,677
Views: 403,485
Posted By JonPa

RE: Extreme Flight Vanquish 2m Build Thread

Thanks for the information. Are you also using an offset servo arm?

Jon
12-29-2012, 09:44 AM
Replies: 1,677
Views: 403,485
Posted By JonPa

RE: Extreme Flight Vanquish 2m Build Thread

Just wondering if people are crossing the rudder pull-pull cables or not? For some reason I cant find any comments on this topic.
12-20-2012, 05:39 PM
Replies: 1,677
Views: 403,485
Posted By JonPa

RE: Extreme Flight Vanquish 2m Build Thread

I have noticed that many people using futaba servos (9650s for eles; 9551 for ailerons; 9156 for rudder) are using different arms such as the Dubro super strength or aluminum arms. Is there any...
11-18-2012, 07:47 PM
Replies: 1,677
Views: 403,485
Posted By JonPa

RE: Extreme Flight Vanquish 2m Build Thread

Can you use direct A123 batteries for those futaba servos or the bls versions?

Jon


"Here are the servos I used that are Futaba. I can give you a rough idea of what would work well for...
05-03-2011, 06:38 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

I have flown my edge now about 5 or 6 times and everything has worked well so far. Incredible power! Anyway, on my most recent flight, on the landing I was pulsing the motor to land the plane, and...
04-19-2011, 08:51 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Any more electrics on the way?
04-19-2011, 06:13 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Are you planning on selling any more of the 56 e-edges/slicks?
04-09-2011, 07:40 PM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Thank you very much for the information-I will take your advice. After flying it a few times today, I found that the low rates were quite nice for larger IMAC maneuvers and the medium rates (25...
04-02-2011, 07:26 PM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

How is everyone setting up their planes? I switched over to HS-82mgs and set the rates to exactly what is recommended for high and low rates, and medium rates right in between. My concern is that...
03-11-2011, 06:17 PM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Has anyone had any problems with the hS-81s on the ailerons? I will replace the elevator and rudder servos with HS-82mgs (since the HS-81s stripped in the shop), but I wonder if I should replace them...
03-10-2011, 07:24 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

I had the same problem. Both elevator servos, which were HS-81s, stripped while in the shop. I must have bumped the elevator at some point, but it could not have been much of a bump because I dont...
01-18-2011, 11:12 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Matt,

I agree that limiting throttle endpoint would lower RPM and the corresponding amp and wattage output, but the esc chopping effect (whatever that is-LOL) would suggest it is bad overall for...
01-18-2011, 10:30 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Matt,

Yeah, I dont really understand the esc chopping effect either, but I think it does really make more sense to go to a lower prop size. Keep in mind that that constant rpm of a motor...
01-18-2011, 09:09 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Matt,

I will admit that I limit throttle on my slick to keep it from getting warm and it does work, but apparently not a good idea. The reason limiting throttle does not limit amps (peak amps,...
01-18-2011, 07:58 AM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

From what I have heard and read, limiting the endpoints on the throttle is not a good way to keep the motor or esc from burning up. According to Lucien Miller limiting throttle does not really limit...
01-11-2011, 03:01 PM
Replies: 217
Views: 26,161
Posted By JonPa

RE: Wild Hare Electrics

Has anyone tested the DYS motor on this plane using a 5s battery? I had planned on 4s (3000) for this plane, but then I received this motor instead of the HD motor. I am sure it would be serious...
11-01-2010, 08:34 AM
Replies: 4
Views: 1,216
Posted By JonPa

RE: Columbus Swap Meet November 6th!

I am looking forward to the swap. How early can we arrive to setup our tables?
03-21-2009, 06:53 PM
Replies: 1
Views: 553
Posted By JonPa

R6004FF receiver

I have been using this receiver on my foamie for a couple weeks and have been getting glitches that fully deflect the aileron servos. I thought it was the servos, so I replaced them, but the new...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.