RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 18
1
2
3
11
Last »
Search: Posts Made By: black talon
Showing results 1 to 25 of 437
Search took 0.49 seconds.
Forum: Speed - RC Nitro Boats
07-04-2011, 08:34 AM
Replies: 7
Views: 1,550
Posted By black talon

RE: my boat wont start

try a new plug.
Forum: RC Boats General Discussion
05-14-2011, 06:29 AM
Replies: 13
Views: 1,391
Posted By black talon

RE: battery coolers

just use tiny computer fans and a 9 volt battery.works for me!
Forum: Speed - RC Gas Boats
05-14-2011, 06:15 AM
Replies: 8
Views: 1,002
Posted By black talon

RE: New motor for BJ55

i would start with a 2716/10*. the 10*rake should keep your nose down with all that power.
Forum: Speed - Electric
04-07-2011, 05:57 AM
Replies: 41
Views: 4,538
Posted By black talon

RE: Cat 36” from R2hobbies (Hong Kong)

do you get cable whip with that much unsupported cable between motor and stuffing box?
Forum: RC Boats General Discussion
04-07-2011, 05:50 AM
Replies: 5
Views: 752
Posted By black talon

RE: Left = Forward Right = backwards (beginner needs help!)

i'm going to guess that you hooked up your servo's in the wrong ports.try swapping them.
Forum: Speed - RC Gas Boats
02-23-2011, 11:31 AM
Replies: 9
Views: 1,292
Posted By black talon

RE: PROPS ON EBAY

the prop blades will bend on you sooner or later.
Forum: Speed - RC Nitro Boats
02-09-2011, 07:40 AM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

the thunder tiger carb i tried on mine didn't work as well. all it did is provide more fuel flow but then i had to lean it back to get it to run. i just sold it. the original carb is much crisper...
Forum: Speed - RC Nitro Boats
02-05-2011, 09:32 AM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

i ran a 45 tt carb on mine and got worse performance out of it. it wasn't as sharp as the oem carb.
Forum: RC Boats General Discussion
01-04-2011, 05:51 AM
Replies: 15
Views: 1,411
Posted By black talon

RE: RECHARGABLE AA BATTERIES FOR TRANSMITTERS

i like the duracell 2650 mah batt's.i use those in my tx. and i use a CHEAP BATTERYS 3300 mah 6v hump pack for my rx. i charge my batt's about every 2 wks.
Forum: Speed - RC Nitro Boats
12-31-2010, 05:32 PM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

the first thing you might try is to raise your strut. what % nitro are you using?
Forum: Speed - RC Nitro Boats
12-11-2010, 03:44 PM
Replies: 15
Views: 1,194
Posted By black talon

RE: Where can i find scratch pads for props?

I'M INPATIENT BUT TAKE ONLY A LITTLE AT A TIME. DREMEL.60/240/CERAMIC POLLISHING WHEELS,IN THAT ORDER.
Forum: Speed - RC Nitro Boats
12-11-2010, 03:39 PM
Replies: 7
Views: 1,110
Posted By black talon

RE: Digital speedometer Q?

I USE A GARMIN E-TREX. WORKS PERFECT.
Forum: Speed - RC Nitro Boats
12-11-2010, 03:25 PM
Replies: 49
Views: 3,196
Posted By black talon

RE: old

WHAT WAS THE QUESTION?
Forum: Speed - RC Nitro Boats
11-04-2010, 05:41 PM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

ran the bigger carb on mine and got a little more torque but couldn't get as much top end so back to the original carb.
Forum: Speed - RC Nitro Boats
11-04-2010, 05:26 PM
Replies: 9
Views: 1,049
Posted By black talon

RE: problems with shaft

and then theres the good old"are you leaving a gap between the strut and drive dog"?
Forum: Speed - RC Nitro Boats
11-01-2010, 06:12 PM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

i've been running an m445/2 on my boat for awhile so i put a thundertiger 45 carb on it and ran a 445/3.i don't know if i can get more torque out of it or not but i'm going to explore it.
Forum: RC Boats General Discussion
10-14-2010, 08:57 AM
Replies: 2
Views: 609
Posted By black talon

RE: Aluminum bending

i am not sure so don't take me at my word but i know heating and quenching softens some metals but i am unexperienced with aluminum. so it might soften it or it might make it brittle. if you have a...
Forum: Speed - RC Nitro Boats
09-27-2010, 11:49 AM
Replies: 2,876
Views: 315,597
Posted By black talon

RE: Thunder Cat 31

i don't know if it makes a diff in head clearence,but your supposed to keep the aluminum shim in at all times and just remove the brass shims.
Forum: Speed - RC Gas Boats
09-22-2010, 02:31 PM
Replies: 570
Views: 137,716
Posted By black talon

RE: Proboat Blackjack 55 Catamaran

first thing your going to need is a 90 degree drill head for your drill,at least that's what i did and then cutoff the top inch to inch and a half of a 1/4 inch drill bit to chuck in the 90 degree...
Forum: RC Boats General Discussion
09-21-2010, 10:18 PM
Replies: 11
Views: 1,255
Posted By black talon

RE: Proboat Radio Repair

the jr xr3i has been sold quite a while as a standalone 3 channel unit as well as being supplied with proboat units. i also swapped out the std antenae with the upgraded larger and more powerfull all...
Forum: RC Boats General Discussion
09-21-2010, 10:08 PM
Replies: 11
Views: 1,255
Posted By black talon

RE: Proboat Radio Repair

.................................mistake........................................
Forum: Speed - RC Gas Boats
09-21-2010, 02:13 PM
Replies: 570
Views: 137,716
Posted By black talon

RE: Proboat Blackjack 55 Catamaran

you should have those rudders by tomorrow. and like i said if there are any other bits and pieces you need let me know. glad to help.
Forum: RC Boats General Discussion
09-21-2010, 05:35 AM
Replies: 11
Views: 1,255
Posted By black talon

RE: Proboat Radio Repair

you can have mine for $20.00 + $8.00 shipping. thats the xr3i FM transmitter with the r135 FM receiver.3 channel,perfect working order.it has about 5 to 6 hours on it. like i said the crystal over...
Forum: RC Boats General Discussion
09-17-2010, 11:02 PM
Replies: 1
Views: 615
Posted By black talon

RE: jersey skiff

go to venomcc he makes a top o the line jersey skiff.you won't be disapointed.
Forum: Speed - RC Gas Boats
09-17-2010, 10:53 PM
Replies: 3
Views: 1,421
Posted By black talon

RE: Jersey Skiff

venomcc or wayne farrow by name makes an excelent jersey skiff.the bottoms take a minimum amount to blueprint.and their solid performers.
Showing results 1 to 25 of 437
 
Page 1 of 18
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.