RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: ERV JR
Showing results 1 to 25 of 68
Search took 0.32 seconds.
Forum: Speed - RC Nitro Boats
06-02-2009, 02:52 PM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

ok I will check the dia compared to the strut. I am in the process of doing some hull repairs and am going to paint the boat. I also am going to make a SS or alum bracket to extend the rudder futher...
Forum: Speed - RC Nitro Boats
06-02-2009, 03:34 AM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

I have a question about the drive dog, i lost mine when the flex shaft broke, I ordered a octura drive dog along with a new prop but I got a straight drive dog,and the stock was tapered to the same...
Forum: Speed - RC Nitro Boats
05-30-2009, 01:23 AM
Replies: 3
Views: 454
Posted By ERV JR

RE: sw 36 carb settings?

I have had my tirge drive for more than a year, I greased it and set the lash tight and had no problems, i think the biggest problem is cranking it when hydro locked
Forum: RC Boats General Discussion
05-28-2009, 04:06 PM
Replies: 4
Views: 825
Posted By ERV JR

RE: Ebay gas boats

ok thanks for the reply, I love thrashing on my TC31 , i really put it thru alot. I run it in water that I should not. I have rolled it flipped it end over en but I love the thing. On Gps it has gone...
Forum: RC Boats General Discussion
05-28-2009, 01:58 PM
Replies: 4
Views: 825
Posted By ERV JR

RE: Ebay gas boats

Do you have any gps speeds ? What kinda of run time do you get on a tank ? Also how does it handle at speed on a long straight, in the clip it looks a bit loose ?</p>
Forum: RC Boats General Discussion
05-28-2009, 04:34 AM
Replies: 4
Views: 825
Posted By ERV JR

Ebay gas boats

Has anyone bought one ,or tested one ? They have a deep vee and a miss bud boat, both for around $400 . I am sure they arent too good but we go to the colorado river alot with our real boats and use...
Forum: RC Boats General Discussion
05-28-2009, 03:49 AM
Replies: 3
Views: 607
Posted By ERV JR

RELEASE AGENT

WHAT CAN I USE FOR A RELEASE ANGENT ? I need to make some parts but dont want to buy a gallon of release agent. Can i use Pam spray, Vasilone or wax ? Is there some sort of household product or...
Forum: Speed - RC Nitro Boats
02-01-2009, 01:15 PM
Replies: 4,067
Views: 449,669
Posted By ERV JR

RE: AquaCraft U-18 Miss Vegas Hydro Thread_Make it Fast!

Wel there is some truth to that statment about scale, but at the same time the weight is incorrect. Our Pgf Haul was 350lbs , then you have the motor and rigging, but a all alum. Bbc and all billiet...
Forum: RC Boats General Discussion
12-27-2008, 05:12 PM
Replies: 2
Views: 627
Posted By ERV JR

What weight/ OZ cloth for hull

I am planning on building a mold for a drag boat and want to know what weight cloth ? should i use 2oz 5oz or 8 oz
Forum: Speed - RC Nitro Boats
12-18-2008, 10:03 PM
Replies: 8
Views: 1,348
Posted By ERV JR

RE: blackjack26ss hull crack

My Tc31 cracked in the same area, there is a bulk head that ran right there, the floor is a thin layup and flexed at the bulkhead. I ground the crack out, layed a pice of 5oz and 8oz cloth on top and...
Forum: Speed - RC Nitro Boats
11-07-2008, 12:29 AM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

ok god idea, it crossed my mind that it could be a radio issue. I will look it over good
Forum: Speed - RC Nitro Boats
11-07-2008, 12:25 AM
Replies: 7
Views: 740
Posted By ERV JR

RE: TC31 GOES HARD RIGHT, CANT CONTROL

looking at it I notice that the water pickup tube isnt inline with the rudder, but its pressed in that way. Its not bent but offset. oh the prop is a plastic sw proboat prop
Forum: Speed - RC Nitro Boats
11-06-2008, 12:39 AM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

I will look into it, if thats the case wont I be able to turn the rudder by hand ?
Forum: Speed - RC Nitro Boats
11-06-2008, 12:37 AM
Replies: 7
Views: 740
Posted By ERV JR

RE: TC31 GOES HARD RIGHT, CANT CONTROL

Yes the rudder is straight, it turns the same both ways, reciver battries are new. All hardware on transom is tight and loctited.
I dont know how to load pics ,sorry
Forum: Speed - RC Nitro Boats
11-05-2008, 07:54 PM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

looking at the running gear it appears to be square, I checked it by eye while at the water.There isnt a way to use an actual square on the transom to the running gear. I am running a sw plastic...
Forum: Speed - RC Nitro Boats
11-05-2008, 07:47 PM
Replies: 7
Views: 740
Posted By ERV JR

RE: TC31 GOES HARD RIGHT, CANT CONTROL

Its stock, with a cut rudder and a sw prop. I tried putting a stock rudder back on and it still does the same thing.
Forum: Speed - RC Nitro Boats
11-05-2008, 12:09 AM
Replies: 4
Views: 656
Posted By ERV JR

RE: Thundercat losing power at high speed

yeah it sounds like it is too lean, it will run good when its dead cold , or at low speed, richen it up more, try 1/4 to 1/2 to start then tune from there. how much did you richen it the last time ?
Forum: Speed - RC Nitro Boats
11-05-2008, 12:05 AM
Replies: 7
Views: 740
Posted By ERV JR

TC31 GOES HARD RIGHT, CANT CONTROL

hey i have a problem with my boat going hard right, once on plane the boat wants to make a hard right turn an I struggle to keep it straight. I fliped it 3-4 times tonight trying to correct it. I...
Forum: Speed - RC Nitro Boats
11-05-2008, 12:03 AM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

hey i have a problem with my boat going hard right, once on plane the boat wants to make a hard right turn an I struggle to keep it straight. I fliped it 3-4 times tonight trying to correct it. I...
Forum: Speed - RC Nitro Boats
10-27-2008, 03:54 PM
Replies: 16
Views: 908
Posted By ERV JR

RE: A Problem with my BJssNitro.

an autobailer is like a one way check ball, you install it in the bottom edge of the transom. it will allow the water in the boat to exit but wont allow the outside water to enter since the ball and...
Forum: Speed - RC Nitro Boats
10-26-2008, 01:41 AM
Replies: 32
Views: 1,943
Posted By ERV JR

RE: blackjack26ss prop breaks

anyone have any idea what all the hardware retails for ? would it becheaper to buy an aftermarket drive system for the old bj ?
Forum: Speed - RC Nitro Boats
10-22-2008, 06:35 PM
Replies: 32
Views: 1,943
Posted By ERV JR

RE: blackjack26ss prop breaks

can you post a ic of the new BJ, is the hul any different ?
Forum: Speed - RC Nitro Boats
10-02-2008, 08:20 PM
Replies: 2,876
Views: 315,622
Posted By ERV JR

RE: Thunder Cat 31

I am out pretty far from what most people run, and im using 30 %. I would go out another turn and tune from there. I had the same problem with my Bj26 and my Tc31 used to fall on its face bad....
Forum: Speed - RC Nitro Boats
09-16-2008, 06:38 PM
Replies: 14
Views: 1,327
Posted By ERV JR

RE: Crashed Tunnel

I tend to stay away from the people ishing, At Laguna I go to the the end were its all dirt, there arent many prople fishing, i dont go to the end with cement. La Marida I drive on the end away from...
Forum: Speed - RC Nitro Boats
09-15-2008, 06:22 PM
Replies: 14
Views: 1,327
Posted By ERV JR

RE: Crashed Tunnel

Yeah I go to the far end, I also go to La Marida, Go to the santa river bed in corona also, Tri city off Asscocated is pretty good
Showing results 1 to 25 of 68
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.