RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: rookie1970
Showing results 1 to 7 of 7
Search took 0.33 seconds.
06-22-2008, 09:08 PM
Replies: 11
Views: 13,579
Posted By rookie1970

RE: is the sh.18 motor worth getting

Well I have a Tornado BB SH30 and the motor seems to be just fine for me, runs out nice. I havent had any problems with this motor and I have put 1 1/2 gallons thru it. Maybe this will help in your...
06-22-2008, 05:47 PM
Replies: 2
Views: 536
Posted By rookie1970

My Landslide doesnt shift is it 2 speed?

My Landslide doesnt seem to be shifting into second gear, it is a 2 speed or is suppose to be, any ideas? I just got done with the break-in steps, so I'm ready to see some more speed. Thanks for all...
06-22-2008, 05:30 PM
Replies: 3
Views: 482
Posted By rookie1970

RE: Low speed needle

ok, thanks for the info. I thought that was how it worked, just wanted to make sure before I went and started turning screws and got it all out of wack. Thanks again.
06-22-2008, 04:38 PM
Replies: 3
Views: 482
Posted By rookie1970

Low speed needle

If I turn the low end mixture screw counter-clockwise what does that do? I'm trying to cool down my motor and the needle valve is good with bue smoke out the exhaust. I just needed low end speed and...
06-22-2008, 04:25 PM
Replies: 4
Views: 1,333
Posted By rookie1970

RE: Redcat Landslide or Earthquake

Thanks alot Darin that was the problem, I kinda knew that was the thing, but I'm not one to tear into things without knowing what lies ahead.
06-22-2008, 10:45 AM
Replies: 4
Views: 1,333
Posted By rookie1970

Redcat Landslide or Earthquake

Ok I got a dumb question if they are a such thing, just got a Landslide and I dont see the on-off switch on the car. I see what appears to be a plastic looking boot that should be over one but they...
06-11-2008, 08:23 AM
Replies: 50
Views: 46,605
Posted By rookie1970

RE: idle screw setting

I just got a Tornado BB S30, during break-in it says to adjust the high-speed screw to 3 full turns out, the low-speed screw even with collar, and the idle screw 1mm opening. I'm wondering about...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.