RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: f0rmula_2001
Showing results 1 to 25 of 88
Search took 0.32 seconds.
Forum: RC Nitro Stadium Trucks
06-11-2010, 10:42 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

It is a little tricky. I actually ended up making my own horn to get it to work the best. Or use the round horn and drill your own holes. Another thing that helped was springs in between the front...
Forum: RC Nitro Stadium Trucks
05-04-2010, 07:09 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I ran the 15/40 with the close ratio and i barely ever hit wide open. I usually only run on a trck though. I just really think anything over 40 in this truck is just too fast. it isnt stable enough...
Forum: RC Nitro Stadium Trucks
05-04-2010, 10:07 AM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I dont know what that is in reply to...but its is about the Slash 4x4 Ultimate.
Forum: RC Nitro Stadium Trucks
05-04-2010, 07:13 AM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I think they are putting the 2.4ghz radio with it too.

On the 40tooth spur, I ran mine with a 15 tooth clutch bell. And I had room to go to a 16 at least. Steve Slayens uses a 40/15 combo too.
Forum: RC Nitro Stadium Trucks
05-02-2010, 06:52 AM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

A receiver pack is a rechargeable battery pack that goes in place of the 4 AA batteries. It is a 6v pack rather than 4.8v that the 4 AAs puts out, so your servos are faster. You will need a new on...
Forum: RC Nitro Stadium Trucks
05-02-2010, 06:42 AM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I had a lot of problems with that happening. take it out and and clean it in some rubbing alcohol then put a little wd-40 on it. If that doesnt work you will have to get a new one.
Forum: RC Nitro Stadium Trucks
05-01-2010, 09:46 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I think 2 servos is overkill. Most guys running revos dont even use 2. I would get a Hitec MG-5645 or or a MG-645 is cheaper and a little less precise and not digital. it will probably the last servo...
Forum: RC Nitro Stadium Trucks
05-01-2010, 09:09 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

It sounds like you have my luck. I had 3 different motors get wrecked(2 by other people,1 bearing failure) 2 servos,and the center diff cup exploded and took out my tranny. All that happened in less...
Forum: RC Nitro Stadium Trucks
04-25-2010, 09:57 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

As long as you empty the fuel out of it then turn it over a few more times till it get all the fuel out of the lines you should be good. If you are going to let it sit for more than a week or 2 you...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-31-2010, 03:20 PM
Replies: 7
Views: 917
Posted By f0rmula_2001

RE: Tekin Q&A Support

Would you know how the 13.5 would perform in the SCRT? with the 13mm rotor?
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-29-2010, 09:40 PM
Replies: 7
Views: 917
Posted By f0rmula_2001

RE: Tekin Q&A Support

That is what I wanted to here. Were do I get the Rotors? I have been looking for a bit and havent been able to find anything.
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-29-2010, 02:38 PM
Replies: 7
Views: 917
Posted By f0rmula_2001

RE: Tekin Q&A Support

I have a SCRT10 and our track is limiting the motors to a 10 turn motor, 2S lipo. Will the the Redline 10.5 turn motor push the truck without overheating? Will the optional Rotors help?
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-26-2010, 10:00 PM
Replies: 0
Views: 379
Posted By f0rmula_2001

SCRT10 Motor Help

I just ordered an SCRT10 and a MMP ESC and need to get a motor. The place I race at is goin to have a 10 turn brushless motor limit and a 2s Battery limit. Has anyone here ran a motor that fits those...
Forum: RC Electric Off-Road Trucks, Buggies, Truggies and more
03-17-2010, 06:41 PM
Replies: 1
Views: 517
Posted By f0rmula_2001

Hyper 10SC w/ MMP 4600 Gearing???

I have been searching on the forums for a bit and havent been able to find any real good info. I have a Hyper 10SC that should be here tomorrow and I am planning on putting my New Mamba Max Pro and...
Forum: Traxxas Monster Truck forum
03-16-2010, 07:17 PM
Replies: 14
Views: 1,945
Posted By f0rmula_2001

RE: os 18 tz questions

I see there hasnt been much on this for a while, but there is an easier way to do this. No matter what shaft you have in your TZ you can cut it at 1-2 threads off the end. Then you can get part...
Forum: RC Nitro Stadium Trucks
03-15-2010, 06:26 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

Lately I have been working on a forward mounted throttle servo, I've seen a couple on revos and I think it looks like it works better for the rear brake and throttle to the TZ. I made the mounts out...
Forum: Traxxas Monster Truck forum
03-13-2010, 10:57 AM
Replies: 10
Views: 1,061
Posted By f0rmula_2001

RE: o.s. .18 question

No the insides are the same too. The way the block is made the Tm is almost like a 5 port too. If you look inside with the sleeve out they both have the exact same fin right down the middle of the...
Forum: RC Nitro Stadium Trucks
03-10-2010, 11:10 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

Yes They do fit but i would get one that isnt from a parted out truck as they will already have the holes for the slash mounts. The part number for the unpainted, untrimmed body 6811. There are 2...
Forum: RC Nitro Stadium Trucks
03-07-2010, 03:10 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

There are a lot of issues that could cause a conrod to break. IF you can tell us how it broke, like were it would help.
You could run to lean and melt the bushing, that would look make the conrod...
Forum: Traxxas Monster Truck forum
03-06-2010, 01:50 AM
Replies: 10
Views: 1,061
Posted By f0rmula_2001

RE: o.s. .18 question

Yeah I wouldnt use anything else at this point.. I love em!!! Mine have all been in Slayers. I am kind of partial to the SC trucks. I grew up in SODA, CORR, TORC. Short course has bee my life.
Forum: Traxxas Monster Truck forum
03-05-2010, 06:27 PM
Replies: 10
Views: 1,061
Posted By f0rmula_2001

RE: o.s. .18 question

I know this is an old thread but I would like to set it straight. The TZ and TM are different in number of ports as stated before, but they can be interchanged. The blocks on the two are identical...
Forum: RC Nitro Stadium Trucks
02-26-2010, 07:57 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

Carguy... there is a guy on the traxxas forum that asked about revo gearing. I use revo gearing in mine and i run 20/34 gearing for CB/spur gear. That gets me to about 40mph with the close ratio...
Forum: RC Nitro Stadium Trucks
02-23-2010, 12:54 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I did a couple 3.3s myself and had a couple done by professionals. It does really wake up that motor. You got to be pretty careful with the sleeve, make sure you dont cut to deep or heat it up to...
Forum: RC Nitro Stadium Trucks
02-21-2010, 11:20 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

I am pretty happy with were they are at now. They shouldnt come out. I was talking with the one of the engineers and the guy who does the driving for all the videos from traxxas this summer and he...
Forum: RC Nitro Stadium Trucks
02-21-2010, 07:14 PM
Replies: 460
Views: 110,354
Posted By f0rmula_2001

RE: OFFICIAL TRAXXAS SLAYER OWNERS THREAD

here are a few pics of the CVDs and the whole truck. On the second one of the CVD you can see how close it is to coming out at full droop. I think I understand why those other guys might have had...
Showing results 1 to 25 of 88
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.