RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: washfire
Showing results 1 to 21 of 21
Search took 0.30 seconds.
Forum: Gas Engines
10-23-2013, 07:17 PM
Replies: 1,709
Views: 336,108
Posted By washfire

I installed one in a Seagull Edge 540 -120...

I installed one in a Seagull Edge 540 -120 size.... All I can say is ... WOW!!!... Fly's GREAT.... Been looking for a good match for the DLE20 and I just found it..
05-01-2013, 02:55 PM
Replies: 157
Views: 45,948
Posted By washfire

RE: Manuals for Nitromodels

I purchased the Airfield RC P51 6 channel ARF 1450mm wingspan (Red). Could I get a copy of the manual or assembly diagram so I could put the airplane together??? I would also like the CG spec ...
Forum: Gas Engines
12-08-2012, 11:29 AM
Replies: 300
Views: 80,326
Posted By washfire

RE: Saito - Pro FG 14 Tips and tricks only!!!

MercerAUST ... So what plug are you running if not the stock Saito plug. ?????[&:]
Forum: Beginners
12-03-2012, 03:40 PM
Replies: 6
Views: 2,105
Posted By washfire

BEWARE .. GENERAL HOBY

BEWARE of GENERAL HOBBY Walnet Ca. *** Do NOT do business with them... Rip Off !!!
I purchased a Zlin 70" from them in September.. Started the assembly and found out I was missing the tail wheel...
Forum: ARF or RTF
12-03-2012, 03:39 PM
Replies: 2
Views: 1,348
Posted By washfire

GENERAL HOBBY - Beware

BEWARE of GENERAL HOBBY Walnet Ca. *** Do NOT do business with them... Rip Off !!!
I purchased a Zlin 70" from them in September.. Started the assembly and found out I was missing the tail...
Forum: Gas Engines
05-25-2012, 01:58 PM
Replies: 300
Views: 80,326
Posted By washfire

RE: Saito - Pro FG 14 Tips and tricks only!!!

I've had good luck with mine in a showtime 50..... However have needed to replace the spark plug twice.... Not sure why, they looked great. Engine would start and run at idle nut stumble and die...
Forum: Gas Engines
11-05-2011, 09:37 AM
Replies: 7
Views: 895
Posted By washfire

RE: fg-14 in showtime 50

I supose I could only fly upright and around in circles, it does that great... I'm only concerned about the dying... And why... You cna'y tell me the going straight up and then flatten out is a...
Forum: Gas Engines
11-05-2011, 09:30 AM
Replies: 7
Views: 895
Posted By washfire

RE: fg-14 in showtime 50

:)Well, finished the install a few weeks ago and it flys great!!!! Almost thru the 1st gallon and the only problem I'm having is it will die after an abrupt move... If I fly with no loops, rolls...
Forum: Gas Engines
10-01-2011, 05:24 PM
Replies: 7
Views: 895
Posted By washfire

fg-14 in showtime 50

Putting a new Saito FG-14b in my Showtime 50.... First time with this gas motor... Looking for ideas on mounting the ignition and etc... Not sure where to mount everything???
08-14-2011, 04:57 PM
Replies: 22
Views: 2,932
Posted By washfire

RE: DX7 + AR7000 Lost Binding Issue

I lost a Hnager 9 RV-8 a few weeks ago for the same resaon... 3rd flight with the plane so it was working great.. 2nd flight for that day... lost signal in the 4th lap and down she went... Total...
07-26-2011, 12:19 PM
Replies: 30
Views: 3,027
Posted By washfire

RE: Lost another one today

Ok, Sorry to be a little short on the info, I was pissed at the time of writing it... Lets see..... using a DX7 (been using it for past 3 years with out any problems on several other...
07-25-2011, 07:59 PM
Replies: 30
Views: 3,027
Posted By washfire

Lost another one today

Lost my new plane yesterday,.... Hanger 9 RV-8 with saito 82 in her.... Completely distroyed... Third flight in her. Second flight for yesterday... First flight was 8 min. This flight was...
Forum: Gas Engines
07-05-2011, 01:22 PM
Replies: 300
Views: 80,326
Posted By washfire

RE: Saito - Pro FG 14 Tips and tricks only!!!

Rght now I am running upright on a test stand. Fuel tank is level with the carb and line is about 5-6 in. Breather vent line open and above tank. I can get it started and will idle as long as I...
Forum: Gas Engines
07-02-2011, 11:25 AM
Replies: 300
Views: 80,326
Posted By washfire

RE: Saito - Pro FG 14 Tips and tricks only!!!

Already tried to adjust the high idle... Could it be with the low or too small / large fuel line??? I'm grasping at straws I know.... Using 6V 1700 battery.
Forum: Gas Engines
07-02-2011, 09:19 AM
Replies: 300
Views: 80,326
Posted By washfire

RE: Saito - Pro FG 14 Tips and tricks only!!!

I purchased the FG-14 and am now tring to break in on an engine stand... I get it to start but will only idle... i can not get it to run above an idle... The motor sputters and dies when I increase...
Forum: ARF or RTF
06-03-2011, 06:27 PM
Replies: 4
Views: 693
Posted By washfire

RV-8 with FG-14 HELP!!!

Well I screwed up... After what I thought was checking all the details I must have missed one...
I purchased a Hanger 9 RV-8 and was (and still want to) going to install the FG-14 motor in it......
Replies: 170
Views: 19,688
Posted By washfire

RE: Which New 2.4 Transmitter Would You Choose?

The biggest problem I see is that once you get into this sport you go with what you THINK will be best. Getting advise from others you purchase the first one. As you build up more and more planes...
Forum: Gas Engines
05-28-2011, 08:35 PM
Replies: 2
Views: 583
Posted By washfire

FG14 in an RV-8

Have one of the Hanger 9 RV-4 on order and was thinking about installing the FG14 for the motor.... Anyone have any tips on this setup? Not sure if it will fit or not. Should be the same size...
Forum: Gas Engines
01-25-2011, 08:31 PM
Replies: 1,824
Views: 338,686
Posted By washfire

RE: Saito FG-20 or 21

Does anyone have anything good tosay about the FG20? I was thinking about putting one in th ehanger 9 p51d but after reading all this I'm not sure???
[:o]
Replies: 12
Views: 1,212
Posted By washfire

How many chanels doyou need????

Ok, I know I'll get a lot of answers on this one but here goes.... How many channels does one need on a transmitter???? I mean, what functions would you need that you can't do with say a 6 or 7...
Forum: Beginners
04-22-2009, 11:51 PM
Replies: 16
Views: 2,958
Posted By washfire

Prop for Evolution Trainer motor

Question.... I have a new Hanger 9 Alpha 40 with the Evolution Trainer Power System on it with the 3 blade prop... I'm just learning to fly with the club instructors.... I know it's a long way off,...
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.