RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: gi1mo2
Showing results 1 to 25 of 500
Search took 0.39 seconds.
Forum: T-Rex heli
04-30-2013, 06:15 AM
Replies: 13
Views: 1,674
Posted By gi1mo2

RE: I think i'm going to get the HK-600gt help needed!

Best is to look at the specs for the Trex, and get something similar.
Forum: T-Rex heli
04-29-2013, 03:27 PM
Replies: 13
Views: 1,674
Posted By gi1mo2

RE: I think i'm going to get the HK-600gt help needed!

Interchangeability - - up to a point. Depends on the model. For example, the head on the Trex 600 ESP is different from the original 600. I believe you will need 2 x 6S 3300mah batteries (total 12s)....
Forum: T-Rex heli
04-29-2013, 02:22 PM
Replies: 13
Views: 1,674
Posted By gi1mo2

RE: I think i'm going to get the HK-600gt help needed!

You should have a look at the specs for the Trex 600. I have the HK 450 and HK 500GT. I have the Trex 450, Trex 500 and Trex 600 ESP. The 600 is way different than the 450 or 500. Much heavier...
Forum: T-Rex heli
12-31-2012, 10:42 AM
Replies: 5
Views: 945
Posted By gi1mo2

RE: LAST WEEK choice

Be careful with the HK500GT. I have one, flies fairly well, but initially I had problems with the main gear to tail gear (there was a gap which would strip gears because Turnigy motor I got was too...
Forum: T-Rex heli
08-06-2012, 04:59 AM
Replies: 4
Views: 1,169
Posted By gi1mo2

RE: TREX 600EFL Pro - Part Question

I don't have the FBL version, and didn't have that part. Looks like the main head for the feathering shaft. I don't know if you have two options?
Forum: E-Flite Helicopters
07-30-2012, 02:28 AM
Replies: 5
Views: 1,637
Posted By gi1mo2

RE: next heli after fixed pitch?

If you don't like Nitro, then stick with the 450 class helicopter. Nitro are not allowed where I fly because of noise. Even our club had to convert from Nitro to Electric. After the 7 minutes the...
Forum: E-Flite Helicopters
07-25-2012, 12:04 PM
Replies: 2
Views: 698
Posted By gi1mo2

RE: striped screw questions

I would use CA on the boom itself and fit it in. You might dril a hole a put a short screw to prevent the boom to slip back. Scratch the boom to get a good grip.
Forum: T-Rex heli
07-15-2012, 04:40 AM
Replies: 24
Views: 3,182
Posted By gi1mo2

RE: Hk600 tail not holding

Check your belt tension for slippage. The tail gear will be harder to identify. Try to turn the main blades when you hold the tail.
Forum: T-Rex heli
07-14-2012, 07:34 PM
Replies: 24
Views: 3,182
Posted By gi1mo2

RE: Hk600 tail not holding

Sorry, 780 are good gyros. Too fast on my iPad. I have used them with many digital servos. Chech the tail gear (front) I had some slip on smaller size HK helis
Forum: T-Rex heli
07-14-2012, 07:12 PM
Replies: 24
Views: 3,182
Posted By gi1mo2

RE: Hk600 tail not holding

The 780 are good servos. I have them on 500 and 600 helis. I don't know if your 600 is belt or torque tube, but you might have some slippage somewhere. I had the tail gear slip on my HK 500. Also...
Forum: E-Flite Helicopters
05-17-2012, 07:38 PM
Replies: 8
Views: 1,504
Posted By gi1mo2

RE: Blade cp pro

I broke many landing gears on my CP Pro 2. Problem with that heli is also the tail motor. Had to replace it twice. Also, the fact that the tail is motor driven is not really the best. Belt or direct...
Forum: T-Rex heli
05-06-2012, 05:34 AM
Replies: 3
Views: 919
Posted By gi1mo2

RE: very weird question

Seems to me that your transmitter is in idle up mode. That is the throttle curve is like a V or U, or even flat line at 100%. It is for 3D and allows you to fly upside down where the blade pitch...
Forum: E-Flite Helicopters
05-01-2012, 04:31 AM
Replies: 2
Views: 623
Posted By gi1mo2

RE: Flybar, has 2 flat places, what way up?

The slots are meant for the small screws to hold it so the flaybar doesn't rotate or slide out.
Forum: T-Rex heli
04-23-2012, 12:01 PM
Replies: 5
Views: 942
Posted By gi1mo2

RE: 1 vs 2 batteries?

Haven't had a chance to run it through it's paces because of weather. Probably 6 minutes. I ran about 5 minutes, and still had some life in the batteries. Very similar to what the 500 would run on...
Forum: T-Rex heli
04-23-2012, 11:45 AM
Replies: 5
Views: 942
Posted By gi1mo2

RE: 1 vs 2 batteries?

Two batteries. The motor requires 48.8V. I actually decided to buy it because I had an Align Trex 500 using 6S 3000 mah batteries. I only have to put two of the same batteries in this heli.
Forum: T-Rex heli
04-23-2012, 09:38 AM
Replies: 5
Views: 942
Posted By gi1mo2

RE: 1 vs 2 batteries?

Hard to compare as it is quite different. Part not interchangeable. The head is completely redisigned, and you can really adjust it the way you like. Low center of gravity, top mounted motor, new...
Forum: E-Flite Helicopters
04-08-2012, 02:45 PM
Replies: 39
Views: 3,658
Posted By gi1mo2

RE: Are most of u e-flite blade owner self taught?

GoPro camera with anything smaller than a 450 is going to be a problem. Have you given a quadcopter consideration? I have a Gaui 330X with a GoPro hero camera on it. I also have a new Gaui 500X with...
Forum: E-Flite Helicopters
04-06-2012, 08:53 AM
Replies: 39
Views: 3,658
Posted By gi1mo2

RE: Are most of u e-flite blade owner self taught?

Money may not be being an object, but size matters. The bigger they are, the more stable they are, but they are also more dangerous. A 450 will hurt you, a 500 will mame you and a 600 could kill you....
Forum: E-Flite Helicopters
04-05-2012, 05:37 AM
Replies: 5
Views: 681
Posted By gi1mo2

RE: Radio HEEEEEEELP !

Either call HorizonHobby or look for the BNF manual for the Blade 450. I assume it is a Blade?
Forum: E-Flite Helicopters
04-03-2012, 08:12 PM
Replies: 5
Views: 1,095
Posted By gi1mo2

RE: 450x goes out of control!!!!

Sounds like a low voltage problem for your battery. Should be around 12 volts fully charged. Trickle charge is around 10 hours. Have a look at this thread.

...
Forum: E-Flite Helicopters
04-03-2012, 07:01 PM
Replies: 5
Views: 1,095
Posted By gi1mo2

RE: 450x goes out of control!!!!

What kind of battery do you have in the DX8? Tha charger that comes with my DX7 can only charge NiMh batteries, not LIPO. You have to charge them outside of the tramitter, not inside. Could the...
Forum: E-Flite Helicopters
03-31-2012, 08:21 AM
Replies: 39
Views: 3,658
Posted By gi1mo2

RE: Are most of u e-flite blade owner self taught?

The bigger they are, the harder they fall. You extend this to be the more agile they are, the more often they will fall. Using a simulator will become a common word for you when you get tired of...
Forum: E-Flite Helicopters
03-27-2012, 06:10 PM
Replies: 9
Views: 729
Posted By gi1mo2

RE: HELP !!!!!

So learning to setup a heli properly is also very important. It should almost fly hands free. Some flight simulators are not as realistic as others. I have ClearView (entry level - not that...
Forum: E-Flite Helicopters
03-27-2012, 05:27 PM
Replies: 9
Views: 729
Posted By gi1mo2

RE: HELP !!!!!

Brain training. It's all about repetitive movements. Simulators are good for this. Young people learn quicker than older folks like me. But I did, and am able to fly helis. Some 3d, but that is still...
Forum: E-Flite Helicopters
03-25-2012, 07:28 PM
Replies: 3
Views: 549
Posted By gi1mo2

RE: need help finding parts

So these are better quality and should fit:

http://www.rotorquest.com/product_info.php?cPath=38_233_240_699&products_id=11574

...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.