RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: Mikes145
Showing results 1 to 25 of 54
Search took 0.25 seconds.
Forum: Marketplace
08-01-2019, 03:30 AM
Replies: 0
Views: 636
Posted By Mikes145

Morane Saulnier 85"

I'm selling a Morane Saulnier that I purchased used from a club member. I believe the plane had never been flown prior to my one flight today, 7/30/19.
The plane flew fine but it's just not the...
Forum: Marketplace
04-23-2019, 09:33 AM
Replies: 5
Views: 1,004
Posted By Mikes145

Pending sale to GeeBeeMan21.

Pending sale to GeeBeeMan21.
Forum: Marketplace
04-18-2019, 02:45 AM
Replies: 5
Views: 1,004
Posted By Mikes145

I would do that for you. I'll mark it sold as I...

I would do that for you. I'll mark it sold as I have it on a couple sites. Do you want to put a few bucks down on Paypal? I'll refund it if you change your mind. Send me a pm please.
Forum: Marketplace
04-17-2019, 05:14 PM
Replies: 5
Views: 1,004
Posted By Mikes145

I'm available pretty much anytime. I'm located...

I'm available pretty much anytime. I'm located in S/E Michigan.
Forum: Marketplace
04-15-2019, 11:28 AM
Replies: 5
Views: 1,004
Posted By Mikes145

Weeks Solution Bi-plane

I got this used plane a few years ago with the intention of getting it going but I've since changed my mind to go with a smaller Bi-plane. The covering isn't perfect and it has some scuffs here and...
Forum: Questions and Answers
09-19-2017, 05:44 AM
Replies: 2
Views: 1,098
Posted By Mikes145

Weeks Solution X Biplane

I purchased a used biplane, approximately 70-72" wingspan, that I was told may be a Weeks Solution X. It was just the air frame and a few servos so I need to add an engine and fuel system.
Does...
Forum: Twin & Multi Engine RC Aircraft
03-08-2016, 04:09 AM
Replies: 2
Views: 1,758
Posted By Mikes145

Identify this plane please

I purchased this kit built plane that hasn't been flown. Can anyone tell me what model it is and what servos would be the minimum required? The wingspan is approximately 70" and the length 53". I...
Forum: Questions and Answers
10-09-2015, 07:23 PM
Replies: 6
Views: 865
Posted By Mikes145

I figured it out. For some reason, I thought I...

I figured it out. For some reason, I thought I could just plug it into my receiver without a battery pack. Well, that powered the switch but the lights only work when you plug them into a separate...
Forum: Questions and Answers
10-09-2015, 05:07 PM
Replies: 6
Views: 865
Posted By Mikes145

Y harness into channel 7 with receiver power and...

Y harness into channel 7 with receiver power and lights. I've changed it all around to different channels.
Forum: Questions and Answers
10-09-2015, 04:42 PM
Replies: 6
Views: 865
Posted By Mikes145

I have the lights plugged into 7, 7 assigned to...

I have the lights plugged into 7, 7 assigned to switch d, and I think 5 was another switch. I'll eventually figure it out, it's just harder than it needs to be.
Forum: Questions and Answers
10-09-2015, 02:47 PM
Replies: 6
Views: 865
Posted By Mikes145

Futaba 7C with landing lights

I'm putting my plane back together with a Futaba T7C transmitter and 617FS receiver. For the life of me, I can't remember how to activate the flashing lights I have on my wings. I had it working...
Forum: Futaba Radios Direct support forum
10-06-2015, 04:15 PM
Replies: 4
Views: 857
Posted By Mikes145

Everything passed inspection. I think I may have...

Everything passed inspection. I think I may have had a battery problem. I run a Life battery. Do you think it's possible for the battery to get low enough to give me the problems and crash but...
Forum: ARF or RTF
10-06-2015, 03:34 AM
Replies: 225
Views: 65,000
Posted By Mikes145

I have one of these in a box unassembled. The...

I have one of these in a box unassembled. The box got wet but everything inside is good. I will sell if anyone is interested. Send me PM.
Forum: Futaba Radios Direct support forum
10-05-2015, 02:37 PM
Replies: 4
Views: 857
Posted By Mikes145

Ok, thanks for the reply. It seems weird that I...

Ok, thanks for the reply. It seems weird that I would have two receivers fail doesn't it? If I were to replace the receivers, I may as well start new with a transmitter and all. If I do replace...
Forum: Futaba Radios Direct support forum
10-05-2015, 10:04 AM
Replies: 4
Views: 857
Posted By Mikes145

Futaba 7C

My 7c and two R617FS receivers are currently at Hobby Services for a check out. I recently crashed a plane that I believe are radio related. While flying, the throttle went to idle without any...
Forum: Questions and Answers
10-01-2015, 07:22 AM
Replies: 29
Views: 2,131
Posted By Mikes145

I did send the transmitter and two receivers to...

I did send the transmitter and two receivers to Hobby Services. The package arrived this morning. I'll update this posting when I get an answer from them. The antenna was not pointed to the side,...
Forum: Questions and Answers
09-30-2015, 08:57 AM
Replies: 29
Views: 2,131
Posted By Mikes145

I sent the transmitter and two receivers to Hobby...

I sent the transmitter and two receivers to Hobby Services last night. I hear good things about them, I hope they find something wrong....
Forum: Questions and Answers
09-29-2015, 06:48 AM
Replies: 29
Views: 2,131
Posted By Mikes145

I need a new transmitter. Looking for opinions

I've been using a Futaba T7C for the past few years with R617FS receivers. Last night I crashed my Redwing RC 30cc airplane when I lost all input while flying. I had this happen once before in...
Forum: ARF or RTF
04-18-2014, 03:07 PM
Replies: 6
Views: 890
Posted By Mikes145

I ended up getting the XQ servos through Redwing...

I ended up getting the XQ servos through Redwing RC. I got most everything installed and then realized that I must have gotten some CA on the stabilizer carbon fiber tube. It pushed in hard but I...
Forum: ARF or RTF
04-10-2014, 02:58 AM
Replies: 6
Views: 890
Posted By Mikes145

Redwing RC 30cc MXSR servos

I just purchased the listed plane and now need some servos. I'm not interested in flying 3D. What minimum torque servos would you buy? 200 oz for 6v seems like overkill for what the way I'll fly...
Forum: ARF or RTF
12-11-2013, 05:53 PM
Replies: 19
Views: 949
Posted By Mikes145

Hey Motor12, what tires are those? I have a...

Hey Motor12, what tires are those? I have a Taylorcraft and really like the bush plane look.
Forum: Beginners
09-27-2013, 05:12 PM
Replies: 38
Views: 3,981
Posted By Mikes145

Any videos of the Mentor flying with smoke? I...

Any videos of the Mentor flying with smoke? I have a couple bigger gas planes but this one looks like a lot of fun for some reason. I have a DLE 30 that would probably be too big though.
Forum: Gas Engines
09-25-2013, 04:39 PM
Replies: 18
Views: 2,961
Posted By Mikes145

Valley View RC says they are in stock. ...

Valley View RC says they are in stock. http://www.valleyviewrc.com/estore/dle-20ra-gas-engine.html
Forum: ARF or RTF
09-22-2013, 05:26 PM
Replies: 13
Views: 4,992
Posted By Mikes145

Here's the link, nice looking plane. ...

Here's the link, nice looking plane.

http://www.horizonhobby.com/products/savage-cruiser-90-arf-SEA195#t1
Forum: Gas Engines
09-18-2013, 06:24 AM
Replies: 9
Views: 1,382
Posted By Mikes145

That's what the switch is for, thanks. I don't...

That's what the switch is for, thanks. I don't have the battery holder and cord for the switch. It looks like the cord I use to charge my transmitter. Any idea where to find the cord and is there...
Showing results 1 to 25 of 54
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.