RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 16
1
2
3
11
Last »
Search: Posts Made By: faulknej
Showing results 1 to 25 of 395
Search took 0.35 seconds.
Forum: Airtronics Support Forum
09-19-2015, 04:22 PM
Replies: 3
Views: 1,316
Posted By faulknej

It was a spare I got on e-Bay included with a...

It was a spare I got on e-Bay included with a receiver I bought.
Forum: Airtronics Support Forum
09-19-2015, 04:21 PM
Replies: 3
Views: 1,316
Posted By faulknej

RDS-8000 Switching back from mode 1 to mode 2

A few years ago I switched a spare RDS I had so a friend who flew Mode 1 could fly my planes. Tonight, I switched the springs around to make it Mode 2 again, but I can't remember which buttons to...
Forum: Airtronics Support Forum
09-19-2015, 04:07 PM
Replies: 3
Views: 953
Posted By faulknej

Where did you find a manual to download?

Where did you find a manual to download?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
11-07-2010, 08:01 PM
Replies: 42
Views: 4,383
Posted By faulknej

RE: What DON'T you like about your Tx?

I've heard lots of good things about the Aurora. As an SD-10G owner, Ihave to say you should really look at it before you buy the A9. It's programmability and features deserve a look. Good luck with...
Forum: Beginners
11-07-2010, 09:20 AM
Replies: 37
Views: 7,233
Posted By faulknej

RE: OS 65 LA similar to a 46 AX?

Why not get a Revolver for the .65? That would be a blast.
Forum: Electric RC Helis
08-27-2010, 09:35 AM
Replies: 2
Views: 1,889
Posted By faulknej

RE: copter x 450 se v2 electronics setup

Iused a Typhoon 2215 motor and a Mystery 40A ESC on mine. They work great. Surprisingly, both are in stock right now. The motor doesn't come with a pinion gear, don't forget to order one. 11T works...
Forum: RC Helicopter Beginners Forum
07-23-2010, 04:12 PM
Replies: 2
Views: 649
Posted By faulknej

RE: quastion about accucel 6

Just set the charge rate to 1.5A and it will charge. Why the 0.7 limit? Most LiPo's charge at 1C. Yours would be 2.2A.
Forum: RC Helicopter Beginners Forum
07-21-2010, 06:27 PM
Replies: 6
Views: 6,160
Posted By faulknej

RE: Idle Up/Stunt Mode

Try helifreak.com Look at Finless' setup videos. All of your questions will be answered
Forum: RC Pattern Flying
07-16-2010, 02:03 PM
Replies: 244
Views: 47,799
Posted By faulknej

RE: 2010 US Nats... share YOUR story

One has to wonder, how many Heinekens were involved in getting it on the stump?

Good luck to all!
Forum: YS Engines Support
07-09-2010, 08:52 PM
Replies: 9
Views: 1,133
Posted By faulknej

RE: YS110s Mid Range RICH

My 110S is slightly below flush. The older 110 is just about flush. I have noticed that small adjustments(1/8 turn or less)make a difference, but a few seconds for the change to take effect. Patience...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-08-2010, 08:47 PM
Replies: 885
Views: 162,806
Posted By faulknej

RE: MAN reports on Airtronics SD-10G 2.4Ghz radio system

Igot a 2S 2200mAH li-po for mine. I only use the stock battery when Ihave to field charge the Lipo.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-05-2010, 02:04 PM
Replies: 3
Views: 579
Posted By faulknej

RE: Radio Setup Troubleshooting

Oops, gas engine, Isee. Ignition system wires run near the radio system?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-05-2010, 02:02 PM
Replies: 3
Views: 579
Posted By faulknej

RE: Radio Setup Troubleshooting

Metal connector on a metal throttle arm?
Forum: E-Flite Helicopters
07-04-2010, 11:07 PM
Replies: 12
Views: 3,197
Posted By faulknej

RE: Just FRIED my Blade MSR batteries

If you leave the batteries in the charger and turn off the power to the charger, the battery will power the charger til it is ruined. If you had batteries powering the charger, the little li-po's...
Forum: Beginners
07-02-2010, 03:39 PM
Replies: 7
Views: 1,069
Posted By faulknej

RE: DX7 question

Ijust got a DX-7 yesterday. Ibound the msras an airplane, and it flies well.
Forum: E-Flite Helicopters
07-01-2010, 10:24 PM
Replies: 4
Views: 680
Posted By faulknej

RE: How to set up my heli

The Dx 5e works with the mcx also. It's about $60.
Forum: E-Flite Helicopters
06-28-2010, 01:43 AM
Replies: 5
Views: 928
Posted By faulknej

RE: Blade MSR moves forward, cannot stop it

What was it?
Forum: RC Helicopter Beginners Forum
06-27-2010, 07:21 PM
Replies: 12
Views: 3,067
Posted By faulknej

RE: Phoenix Sim Questiom

I just push the 7 key and the smoke starts.
Forum: RC Helicopter Beginners Forum
06-24-2010, 05:45 PM
Replies: 5
Views: 747
Posted By faulknej

RE: Novus CP Expo Adjustment Help

I just turned the EXT down on the main board and it tamed it down pretty well. About 1/4 turn to start. Takes out much of the "twitchy.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-18-2010, 06:08 PM
Replies: 3
Views: 761
Posted By faulknej

RE: parkzone servos

Ihave a PKZ T-28D and a Corsair, both PNP models. Both have Airtronics 5 channel 2.4GHz Rx's in them.The SD-10G is a lot of radio for them but they fly very well.
Forum: YS Engines Support
06-18-2010, 04:21 PM
Replies: 18
Views: 3,030
Posted By faulknej

RE: YS70...In the air & Haul'in

Hey Pete, Hobbybarn shows them in stock for $309.
Forum: Beginners
06-17-2010, 08:40 PM
Replies: 32
Views: 3,695
Posted By faulknej

RE: OK I'm done!!

Every time a buy a new plane, Isay that, and a week or two later I'm buying another. Igot three helicopters this month, hope I can learn to fly them.
Forum: E-Flite Helicopters
06-17-2010, 02:01 AM
Replies: 4
Views: 939
Posted By faulknej

RE: ???HOW TO STAY OUT OF TROUBLE AT WORK???

Mine was doing that until Ire-bound it. Worked fine after that.
Forum: Beginners
06-12-2010, 05:23 PM
Replies: 7
Views: 748
Posted By faulknej

RE: Motor Mount?

The GPadjustable mounts work really well. The biggest advantage to a soft mount is the increase in flight times from your batteries. The current used per flight is much less, as the servos are not...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-07-2010, 04:00 PM
Replies: 28
Views: 4,923
Posted By faulknej

RE: *Airtronics SD-10G Upgrade*

Anyone not using the stiffer springs? They were missing from mine when I got it, and would like to stiffen up my sticks.
Showing results 1 to 25 of 395
 
Page 1 of 16
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.