RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Old Claw
Showing results 1 to 14 of 14
Search took 0.23 seconds.
Forum: ARF or RTF
01-22-2016, 08:55 PM
Replies: 590
Views: 147,243
Posted By Old Claw

It would look really goofy if they fitted 6 inch...

It would look really goofy if they fitted 6 inch wheels on it. The aircraft is scale, so the wheels are the scale size I guess. I've nearly finished building mine with a Saito FG60R engine. Balances...
Forum: The Clubhouse
06-24-2015, 03:12 AM
Replies: 2
Views: 528
Posted By Old Claw

Asp 61 FS, Camshaft removal

I am trying to replace the bearings in an Asp 61 FS. I have everything out bar the camshaft. It will NOT come out. The crankshaft turns freely, the camshaft rotates freely I cannot see any reason why...
Forum: RC Jets
04-07-2010, 07:31 AM
Replies: 88
Views: 20,301
Posted By Old Claw

RE: Did anyone see the Jet Cat P-20?

Intairco has an announcement, saying about Aus$ 3100? US$2800????   What would you use it for? Don't tell me. It's going to go into rubber powered free flight, right? Ancient, very near death, Cliff
Forum: RC Jets
04-03-2010, 10:16 PM
Replies: 5
Views: 3,177
Posted By Old Claw

RE: CARF Rookie control throws and CG

G'day Lior my mate. I have a Rookie Mk 1 with a P80 in it. I have the CofG at 120mm ahead of the wing tube. I agree with lower ailerons for beginners. Maybe use hi and lo rates, with low set to about...
Forum: RC Jets
03-19-2010, 01:50 AM
Replies: 228
Views: 33,942
Posted By Old Claw

RE: Composite-Arf rookie questions

<span style="font-family: Verdana, Arial; font-size: 13px; -webkit-border-horizontal-spacing: 1px; -webkit-border-vertical-spacing: 1px; ">Anyone here had experience with both the Mk l Rookie and the...
Forum: RC Jets
03-19-2010, 01:24 AM
Replies: 228
Views: 33,942
Posted By Old Claw

RE: Composite-Arf rookie questions

Anyone here had experience with both the Mk l Rookie and the new model with canards? I have a Mk l with a P80 and it does everything. My mate has a P80 SE, which sends it very well. Another guy in...
Forum: JetCat Turbine Direct Support
03-06-2010, 01:08 AM
Replies: 4
Views: 2,400
Posted By Old Claw

RE: Jetcat P120SE

Thanks men. Actually I think I read in the JetJoe manual, something about the pump being a rootes type and it was recommended to run under water after sitting for a while. The ECU still says 120SE, I...
Forum: JetCat Turbine Direct Support
03-05-2010, 10:44 PM
Replies: 4
Views: 2,400
Posted By Old Claw

Jetcat P120SE

G'day. I have a P120SE which has done about 9 hours total. Last weekend I discovered that it was very slow to accelerate on a go around which resulted in an off field landing. I tested the turbine....
Forum: RC Jets
03-05-2010, 06:45 PM
Replies: 7
Views: 5,134
Posted By Old Claw

RE: Jetcat fuel pump repair?

Morning all. I have a P120SE which has a total of 9 hours. Last couple of flights I noticed the acceleration to be slow, 7 or 8 seconds. I checked it again on the ground. It starts to accelerate,...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-01-2010, 05:23 AM
Replies: 112
Views: 19,612
Posted By Old Claw

RE: Your thoughts after reading JR 12X manual

<span style="font-family: 'Times New Roman'; font-size: medium; "><div style="margin-top: 0px; margin-right: 0px; margin-bottom: 0px; margin-left: 0px; padding-top: 0px; padding-right: 0px;...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
02-01-2010, 05:19 AM
Replies: 112
Views: 19,612
Posted By Old Claw

RE: Your thoughts after reading JR 12X manual

<span style="font-family: 'Times New Roman'; font-size: medium; "><div style="margin-top: 0px; margin-right: 0px; margin-bottom: 0px; margin-left: 0px; padding-top: 0px; padding-right: 0px;...
Forum: RC Jets
01-10-2010, 05:26 AM
Replies: 89
Views: 22,836
Posted By Old Claw

RE: Cermark Viper Jet Redeux

G'day guys. I've almost completed my Viper. I was going to use a P80???  I also have a Simjet 3000, might be better? Also, where is the Cof G supposed to be? I built mine up with NO manual, so...
Forum: RC Jets
01-08-2010, 01:00 PM
Replies: 64
Views: 16,610
Posted By Old Claw

RE: Fei Bao F86 Sabre

<span size="7"><font face="Courier"><font color="#333399">Good morning all. It's 4.40 am here on the sunny East Coast of Australia. I've just bought an FeiBao F86 kit. There is NO manual with it....
Forum: RC Jets
12-31-2009, 05:53 AM
Replies: 39
Views: 22,729
Posted By Old Claw

RE: Jetcat P-80 or P-80SE?

I for one think the only consideration is the price of the engine. Even if they were both P80 SE's, if one is second hand then it's only worth buying if there's a considerable saving. Example....
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.